film thickness
STANDARD STOCK GAGES
All aluminum - Dual Purpose - Dual Side - Double Scale Gage
in Mils and Microns
WF-CCD Standard stock gage with imprint of "Directions for Use"
WF-CCD
WF-CCA Standard stock gage with GARDCO Logo and
"Directions for Use" Quantity 1-999.....................$ 1.10
Quantity 1000 or more.......$ 0.80
WF-CCA
WF-SD Standard stock S gage with GARDCO Logo and
"Directions for Use" Quantity 1-999.....................$ 0.98
Quantity 1000 or more.......$ 0.72
WF-SD
INSTRUCTIONS
1- Place gage on wet film at 90° angle.
2- Press into film
3- Withdraw and note deepest tooth
having paint on it and next higher
tooth that is not coated.
4- The wet film thickness lies
between these two readings.
5- Clean gage in any suitable
solvent immediately after use.
The drawing indicates that tooth
marked 3 mils is covered with the wet
paint and tooth marked 4 mils is not
covered. This indicates that the true
wet film thickness of the material is
between 3 and 4 mils thick.
www.GlobalTestSupply.com
3
Loading...