iTheater BlueWave User Manual
User Guide
What you can find in the package:
1. Two iTheater Bluetooth Speakers
2.
Remote Controll
. Drawstring Accessories Bag
AC Power Cable
3. 1/8” Audio Cable
4. 16AWG Speaker Wire (9.75 ft)
5.
6
7. Two Drawstring Speaker Bags
8. iTheater™ User Guide
www.itheater.net
PAGE 1
BT CD AUX
OUT TO
RIGHT
OUTPUT
DC +5V
INPUT
AUX L R L R
POWER
ON OFF
FUSE
115V~
T1.6AL250V
T2.0AL
125V
230V~
Tweeter
Mute/Standby
Bluetooth
Power
Bluetooth
Input
CD Input
AUX Input
Remote
Sensor
Woofer
Volume
Bass Tube
Output
DC Charger
Power On/Off
Fuse
Power Plug
Power Switch
AUX Input
RCA Input
RCA Output
Primary
Secondary
User Guide
PAGE 2
www.itheater.net
OUT TO
RIGHT
OUTPUT
DC +5V
INPUT
AUX L R L R
POWER
ON OFF
FUSE
115V~
T1.6AL250V
T2.0AL
125V
230V~
1
1
2
Speaker-Wire Connection
Connect the RED (+) and BLACK (-) terminals of the left speaker to the
corresponding terminals of the speaker on right using the speaker wire supplied.
Be sure the gold color speaker wire line should go between the RED (+)
terminals of both speakers while the silver color speaker wire line connects the
BLACK (-) terminals.
> Remove the pre-cut insulation on the end of the speaker wire and twist the exposed wire strands 2-3
times.
> Loosen the binding post connector with your thumb and fingers.
> Insert each speaker wire into the holes on the side of the binding post connector.
> Tighten the binding posts. The stripped portion should be secured firmly in the connector.
> Repeat the above steps to connect the other speaker. Be sure to match the wire line color to the same
terminal color on each speaker. Also make sure that none of the speaker wire strands come in contact
with adjacent terminal.
Step by Step:
NOTE: As the iTheater™ speaker system is self powered, do not connect
the speaker terminals to the speaker outputs of a stereo receiver.
PAGE 3
Loading...