CONNECTIONS
The Decimator II G String Noise Reduction pedal is the latest generation in noise reduction technology. The Decimator features improved Linear Time Vector Processing that offers the smoothest, ripple free approach in tracking the envelope of the input signal. The LTVP will instantly respond to short staccato notes and at the same time provide ripple free control of long sustained notes while downward expanding. The Decimator pedal is easy to use and simple to operate.
The threshold control on the Decimator II G String should be adjusted by listening to the noise floor while no instrument signal is present. The threshold control should be turned clockwise until the noise floor becomes inaudible. It may be necessary to readjust the threshold with the guitar volume all the way on in order to accommodate the additional noise the guitar may induce. Adjusting the threshold too far clockwise may cause the downward expander to attenuate the output level too quickly and not allow the signal to decay naturally.
BATTERY / ADAPTER
The Decimator II G String has 4 ¼ inch jacks. Connect the guitar directly to the Guitar IN. Connect the Guitar OUT to the input of the amplifier. Connect the DEC IN to the loop send and DEC OUT to the loop return. For best performance place all gain pedals in front of the amplifier and DEC IN. You can put Delay and Reverb effects pedals after the Decimator II G String and before the loop return to avoid cutting off reverb and delay tails.
WARRANTY & SERVICE
This unit parts and workmanship are fully guaranteed to be free of defects under normal use and service for a period of three years from date of purchase. Any damage resulting from misuse of the failure to follow the precautions and instructions will void the warranty. In the event that the unit needs to be repaired, please return the unit to ISP Technologies directly. Simply re-pack the unit, send a copy of your original receipt, a note stating the problem and send it to:
ISP Technologies 5479 Perry Dr. Suite B Waterford, Mich.48329 ATTEN: Repair Dept.
To install the battery, loosen the thumbscrew shown above and raise the switch cover to allow access to the battery compartment. Insert a 9v battery to the connector and place the battery into its compartment and close by holding the switch cover down and tightening the thumbscrew.
To use the Decimator II with an external power adapter, select an adapter with at least 100 milliamps capability at 9 volts DC. Make sure the adapter is polarized “TIP NEGATIVE”.
All shipping charges must be prepaid. ISP will not be responsible for any damages incurred in shipping the unit. Any claim will need to be settled with the shipping company. The warranty will be voided if the serial number has been tampered with. Should you have any questions for the repair dept prior to returning the product please call 248-673- 7790
www.isptechnologies.com
Loading...