iSport P090A, P084C User Manual

ENGLISH l 1

3D motion sensor USB
Pedometer

with 30days memory
P090A

User’s Manual

2 l ENGLISH

This digital pedometer features with step counter,

distance, calories consumpon, speed, exercise
mer and stopwatch. As well as download your
exercise workout into your PC. To get the most out
of your purchase, be sure to carefully read this
manual and keep it on hand for future reference.

NUMBER OF STEP WE NEED TO DO PER DAY

To keep you health and reduced chronic disease
risk, we recommended you to do 10,000 steps a day.
For an eecve weight loss, this should be between
12,000 and 15,000 steps. If you want to have high
level of tness, you should make at least 3000 or
more steady steps per day.

NOTE: In order to acvate your pedometer aer
purchase, you must remove the baery insulator
tab inside the baery compartment. See page 11
Baery Replacement for details

Introduction

ENGLISH l 3

Contents

INTRODUCTION 2
CONTENTS 3
BASIC OPERATION OF BUTTONS 4
OPERATING MODES 5
SETTING YOUR PEDOMETER 6-7
OPERATING THE PEDOMETER
STEP MODE 8
DISTANCE MODE 8
CALORIES MODE 8
EXERCISE TIME MODE 8
DAILY MEMORY MODE 9
TOTAL MEMORY MODE 9
RESETTING THE PEDOMETER 10
USB CONNECTION 11
UPLOADING YOUR DATA 12-13
BATTERY REPLACEMENT 14
CARE AND MAINTENANCE 15

4 l ENGLISH

KEY CONFIGRUATION:

MODE KEY

-Scroll through operang modes

-Advance to next seng in programming sequence

SET KEY

-Press and hold to accesses programming sequence
in Time and Step modes

-Toggle system unit display in Distance,Speed mode.

-Scroll data in Memory mode

RESET KEY

-Press and hold to clears data in Step, Distance,
Calories, Speed, Timer mode and Memory mode

-Increase values being set during a programming
sequence

-Scroll through pass 30 days memory

MASTER RESET BUTTON

-Hard reset for device(will clear all data & memeory)

Basic operaion of buttons

USB Port

MODE

SET

RESET

Removable Belt Clip

ENGLISH l 5

The pedometer have 6 operaonal modes and are
in this sequence:

-Press Mode buon to scroll.

Step mode

-Display number of steps taken.

Distance mode

-Display distance traveled.

Calories mode

-Display calories consumed.

Exercise Time mode

-Display total exercise me you did.

Daily Memory mode

-Can browse your past 30 days walking workout.

Total Memory mode

-Can browse your total walking workout since last
data reset.

Operating modes

6 l ENGLISH

SETUP MODE

-Press and hold the SET buon 2 second to enter
SETUP mode,

-You can see the icon “Setup” on the display,

-Enter the values in the following order: 12-24 Hour
Format / Seconds / Hours / Minutes / Month / Day /
Year / Measurement Units / Stride / Weight / Target
Steps.

-Press RESET to increase the value, while Press
MODE to decrease; pressing and
holding the buon will change the number rapidly.

-When the value is correct, press SET to move to the
next value. Connue to press SET and change
values as required unl the pedometer returns to
STEP MODE.

-If you have established a STEP TARGET, a
ten-segment bar display on the le side of the
pedometer shows your progress towards your goal.
When you reach your goal, all ten segments will
ash and an alarm will sound for 30 seconds. The
default goal is 5000 steps.

NOTE : The display will automacally back to Time
mode if don’t have any input for 10 seconds.

Setting your pedometer

ENGLISH l 7

HOW TO MEASURE STRIDE LENGTH

Correct stride distance is dened from a p of your
foot to another one. To measure the correct average
stride distance, divide the total distance of ten
steps you walked / run by the number of step (10).
Calculate the stride distance in the following way:

You walk 6.2 meters, 6.2m (total distance) / 10
(number of steps) = 0.62m (62cm).

NOTE : Unlike the convenonal pedometer,
this pedometer using a 3D moon sensor that
can detect ne body step movement without
mechanical sensor, so no rale sound will create.

NOTE : To avoid wrong counng, the display of the
pedometer will start showing the number of steps
taken aer read 5 seconds connuous steps. This
means that the display don’t have reading for rst 5
seconds aer you start walking. All the steps taken
will be counted and displayed aerward.

Setting your pedometer

8 l ENGLISH

STEP MODE

The default mode for the device is STEP MODE
“Step” is displayed at the top of the device.

-In STEP MODE mode, the top number represents
the total number of steps accumulated since
midnight.

-Step data is saved to memory. The daily count will
be cleared automacally to zero at midnight, but
accumulated daily history is saved for 30 days.

DISTANCE MODE

-Press MODE to enter into DISTANCE MODE . “Km”
or “Mile” is displayed at the top of the device

-In DISTANCE MODE, the top number represents
the total distance traveled since midnight

CALORIES MODE

-Press MODE to enter into CALORIES MODE.
“Kcal” is displayed at the top of the device.

-In CALORIES MODE, the top number represents
the total number of calories burned since midnight

EXERCISE TIME MODE

-Press MODE to enter into EXERCISE TIME MODE.
“Min” is displayed at the top of the device

-In this MODE, the top number represents the total

Operating the pedometer

ENGLISH l 9

number of minutes spent walking/running since
midnight.

DAILY MEMORY MODE

-Press MODE to enter into DAILY MEMORY MODE.
“Step” is again displayed at the top of the device

-In DAILY MEMORY MODE, the top number
represents data for the selected day. The boom
number represents the number of days previous to
the current day.

-Press SET to recall daily data as follows: Step /
Distance / Calories / Step Time

-Press RESET to change the DAY RECORD

TOTAL MEMORY MODE

-Press MODE to enter into TOTAL MEMORY
MODE. “Total Step” is displayed at the top of the
device.

-In this MODE, the top number represents the

total accumulated data since the most recent full

reset.

-Press SET to recall total accumulated data as
follows: Step / Distance / Calories / Step Time

Operating the pedometer

10 l ENGLISH

RESETTING THE PEDOMETER

There are two dierent ways to RESET your
pedometer: DAILY RESET and FULL RESET

-To perform a DAILY RESET, Press & Hold RES for
two seconds WHILE IN STEP, DISTANCE, CALORIES
OR EXERCISE TIME MODE. The data for the current
day is erased.

-To perform a FULL RESET, Press & Hold RES for
two seconds WHILE IN TOTAL MEMORY MODE to

erase all accumulated data and reset the pedometer

to factory fresh condion.

NOTE: Reset either step, distance, calories burned,
exercise mer data will result to clearing all above
menioned data for current day.

NOTE: Even you did not do any exercise in any one
of those day(s), the display will keep the record as
“ZERO”. However, you cannot select and erase the
record of one individual day.

Operating the pedometer

ENGLISH l 11

USB CONNECTION

-If you want to upload the data to your PC, you
rst need to download and install the pedometer
driver on your computer by clicking the appropriate
link on the website.

- Aer installed the pedometer driver, plug the
supplied USB cable into the side of your pedometer
and a USB connector on your computer.

-Run the soware.

For the rst me to use, you are required to assign
your pedometer in system by “Create New Prole”.

-Fill in the informaon requried.

-Login to the system with your user name and
password.

USB Connection

12 l ENGLISH

Here is main screen in system and it’s funcon,

Home : Web broswer
Chart : To view your workout data in various mode.

Users : To manage dierent user account who

registered in system.
USB : To export pedometer data to PC or

synchronize prole between PC and pedometer

Password : To change password or permission
Quit : Quit the system

Uploading your data

ENGLISH l 13

NOTE : Only data from previous complete days
is uploaded. Once data from your pedometer

has been uploaded on any given day, data for
the current day will connue to accumulate but
will not be available to upload unl the next day

beginning at 12:00 A.M.

Uploading your data

14 l ENGLISH

BATTERY REPLACEMENT

WE STRONGLY RECOMMEND TAKING YOUR
PEDOMETER TO A LOCAL JEWELER TO HAVE
BATTERY REPLACED TO AVOID POSSIBILITY OF
PERMANENTLY DAMAGING OF THE PEDOMETER.

Baery Type : CR2032 x 1pcs

-Unscrew the baery compartment cover on
the backside of the unit using a small Phillips
screwdriver and remove the cover.

-Remove the exhausted baery from the unit, and
insert a new baery (be sure to place the posive
(+) side of the baery is visible, facing toward the
baery compartment cover).

-Replace the baery compartment cover on the
baery compartment and fasten the screw.

CAUTION: do not over ghten.

Battery Replacement

ENGLISH l 15

CARE AND MAINTENANCE

-Never aempt to disassemble or service your unit
it will void the warranty.

-Protect the unit from extreme heat, shocks and
exposure to direct sunlight long me.

-Unit can be wiped clean with a lightly moistened
cloth. Apply mild soap to the area if there are
stubborn stains or marks.

-Do not expose the unit to strong chemicals such
as gasoline, clean solvents, acetone, alcohol, insect
repellents, as they may damage the unit’s seal, case
and nish.

-Store the unit in a dry place when you are not
using it.

-Keep the pedometer out of reach of young children

-The operaon environment of the pedometer must
be free from shocks, magnec elds, electrical noise
and strong vibraon.

-Do not swing the pedometer.

-Do not hang the pedometer from your neck during
jogging.

-Do not drop or step on the pedometer.

-Do not put the pedometer in the back pocket of
your short or pants.

-Do not wash the pedometer or touch it with wet.

Care and Maintenance

16 l ENGLISH