Isotra ISOLITE PLUS, ISOLITE Measurement And Assembly Manual
MEASUREMENT AND ASSEMBLY MANUAL
Validity of the manual: 1. 9. 2014
1
ISOLITE, ISOLITE PLUS
Rectangular window Untypical window
1. MEASUREMENTS
Isolite and Isolite Plus blinds are designed to be assembled into the window wing of plastic and wooden EURO windows.
THE WIDTH AND HEIGHT ARE MEASURED IN THE FOLLOWING MANNER:
w.... (width)
The measurement is taken at the glass from the left inside edge of the glazing bar to the right inside edge of the glazing
bar, including the rubber or silicon sealing in three places – up, middle and down. For manufacturing and ordering the
blind, the minimum measured dimension is stated.
The width of the blind is produced with the precision of millimetres from the width 300 mm to 2000 mm with a tolerance of
± 1 mm.
h .... (height)
The measurement is taken at the same depth of the glazing bars as the width of the blind, from the upper bar to the lower
bar.
The height of the blind is produced with the precision of millimetres from the height of 300 mm up to 2200 mm with a
tolerance of -3 / +27mm.
d .... (depth)
The depth of the glazing bar is measured in relation to the use of the distance bases under the side board for the blinds.
There are the left and the right base.
MEASUREMENT AND ASSEMBLY MANUAL
Validity of the manual: 1. 9. 2014
2
Depth of the glazing bar:
19 and more mm – no base
15 - 19 mm one base
on each side
11 - 15 mm two bases
on each side
Maximum guaranteed area: 2.5 m2
For dimensions outside the stated limits, it is recommended to consult with the manufacturer.
The ideal measurements of the blind are in the diagram. Such measurements can be taken by using the cut of the upper
profile; by the aid of the side board place on the glazing bar, it is possible to record the point, the maximum possible width
of the blind. From this point the dimension of the same point on the opposite side is measured. This marking is always
influenced by the form and size of the glazing bar of the window profile.
2. ASSEMBLY
Assemble exclusively according to this manual to prevent redundant assembly errors and other related problems.
AIDS FOR ASSEMBLY:
•
electric drill, drills
•
cross-head screwdriver
•
knife, scissors, pliers
for fixing blinds
for fixing the holder of the
chain
hole for tightening pin
screw
3,9 x 16; 3,9 x 22
3,9 x 16
3,2 mm für Plastikfenster
und Alu-Fenster, 3 mm für
Holzfenster
drill with the diameter Ø
2,5 mm
2,5 mm
Loading...