ISON IS-DH310P-2F-8, IS-DH310P-8 Quick Installation Manual

Quick Installation Guide

IS-DH310P-2F-8

Industrial 10 port POE switch, with 8 x 10/100M TX PSE (802.3af/at) + 2 Giga SFP

IS-DH310P-8

Industrial 10 port POE switch, with 8 x 10/100M TX PSE (802.3af/at) + 2 Giga TX

FCC MARKING
This Equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at the own expense.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference.
(2) this device must accept any interference received; including interference that may cause undesired
operation.

CE MARKING
This equipment complies with the requirements relating to electromagnetic compatibility, EN 55022 class A
for ITE, the essential protection requirement of Council Directive 2004/108/EC on the approximation of the
laws of the Member States relating to electromagnetic compatibility.

Company has an on-going policy of upgrading its products and it may be possible that information in this
document is not up-to-date. Please check with your local distributors for the latest information. No part of
this document can be copied or reproduced in any form without written consent from the company.

Trademarks:
All trade names and trademarks are the properties of their respective companies.

1

Copyright © 2016, PRIMMCON Industries Inc. All Rights Reserved.

2

Introduction

This rugged design Industrial 10 port POE switch, complied with IEEE802.3af and IEEE802.3at, and pass
many rigorous environmental test. It delivers 30 watts (Max 36 watts) power per POE port, also generate up
to 200 watts power to PD devices. The uplink 2 SFP port can extend to a wilder area connection. With its
multi-purpose design, that can also be used for Din-Rail or wall-mounted. This is an ideal unit for IP
surveillance, traffic monitoring and security application in critical environment which -40°C to 75°C range is
required.

Housing Dimension (IS-DH310P-2F-8) (mm)

3

4