ISOMAG MS2410 Installation Manuals

ELECTROMAGNETIC FLOW METER

“FULL BORE” SENSORS MODEL MS2410

INSTALLATION MANUAL

Authorization
n. 1035

Pag. 2 ESENS_FULLBORE_R01_MS2410_IS

INDEX

INTRODUCTION ___________________________________________ 3
START UP AND MAINTENANCE OF THE INSTRUMENTS _____________ 3
SAFETY _________________________________________________ 4
GENERAL INFORMATION ON THE SENSORS INSTALLATION _________ 5
ELECTRICAL CONNECTIONS OF SENSOR TO CONVERTER ___________ 6
GROUNDING INSTRUCTIONS ________________________________ 6
OVERALL DIMENSIONS _____________________________________ 7
THREADED CONNECTIONS __________________________________ 7
CLAMP CONNECTIONS ______________________________________ 8
INSPECTION SCREWS ______________________________________ 9
CONFORMITY DECLARATION ____ ERRORE. IL SEGNALIBRO NON È DEFINITO.
ADDRESSES _____________________________________________ 12

Pag. 3 ESENS_FULLBORE_R01_MS2410_IS

INTRODUCTION

- This manual is integral part of the product. Read carefully the instructions
contained since it contains important indications for the safety of use and
of maintenance.

- The technical information and the relative products of this manual could be
modified without any previous notice.

- The flow meter must be used for the use it has been built for. The improper
use, possible tampering of the instrument or parts of it and substitutions of
any components not original, makes the warranty to decay automatically.

- The manufacturer is considered responsible only if the instrument is used in
its original configuration and setting.

- The flowmeter makes measures of liquids with conductivity greater than
5µS/cm; it consists of a sensor (described in this manual) and a converter,
for it see the manual provided.

- If the sensor is supplied in compact version to the converter, consider the
operating temperatures more restrictive, otherwise refer to the respective
manuals (page 5).

- When transporting, unpacking and handling the flowmeter, be careful and
care.

- In the case of prolonged storage and of transport, use and store in the
original container in a dry place, do not place more than 3 packs one above
the other. It is possible pallets storage and transport (in case of wooden
crates do not place one above the other).

- For the cleaning of the device use only a damp cloth, and for the
maintenance/repairs, contact the customer service.

- For the disposal of the device and of the packaging make strict reference to
the regulations.

- It is forbidden the reproduction of the present manual and of possible

software supplied with the instrument.

START UP AND MAINTENANCE OF THE INSTRUMENTS

- Before starting up the instrument, always make a sure connection to
ground as suitable to page 6.

- Verify periodically: the cables integrity, the tightening of the sealing
elements (cable glands, covers, etc.), the mechanical fixing of the
instrument on the pipe or on the wall stand.

Pag. 4 ESENS_FULLBORE_R01_MS2410_IS

SAFETY

Before using the instrument, always make a sure connection to
the ground

Avoid any attempt to repair the instrument. If the instrument is
not functioning properly, please call the nearest assistance
service

Pay maximum attention during the operations

ATTENTION !!!

DANGER !!!