iSolutions iColor 3, iColor 4 User Manual

User Guide

Professional Entertainment Technology

2G

7. Fixture Cleaning

The cleaning of internal and external optical lenses and/or mirrors must be carried out

periodically to optimize light output. Cleaning frequency depends on the environment in which

the fixture operates: damp, smoky or particularly dirty surrounding can cause greater

accumulation of dirt on the unit’s optics.

＊ Clean with soft cloth using normal glass cleaning products.

＊ Always dry the parts carefully.

＊ Clean the external optics at least once every 20 days. Clean the internal optics at least

every 30/60 days.

3G

INDEX

1. General Instructions

2. Main Features

3. Lamp

4. DMX Linking & Controls

5. How To Control The Unit

A. By master/slave preprogrammed function

B. By easy controller

C. By Colormix controller

D. By universal DMX controller

6. Troubleshooting

7. Fixture Cleaning

4G

1. Getting Instructions

The following points are important for safety as well as for the smooth installation and

performance of the unit.

Ÿ Unpack carefully and be sure that no damage has occurred during shipping.
Ÿ It is very important to ground the yellow/green conductor in order to meet regulations for

safety.

Ÿ Do not connect the device to any dimmer pack or power pack.
Ÿ The electrical work that is necessary for installation must do by qualified personnel.
Ÿ Be sure to locate the unit in a place with adequate ventilation at least 15 cm from the walls

and at least 100 cm from adjacent surfaces. Be sure than no ventilation slots are blocked.

Ÿ Be careful that no liquids or other objects can enter the unit. If this ever happens,

disconnect the main power immediately.

Ÿ In the event of serious operating problems, turn off the unit immediately. Never try to repair

the unit yourself. Repairs carried out by non-qualified personnel can lead to serious

damage or malfunction. Please contact your dealer about authorized technical assistance.

Always use genuine spare parts.

Ÿ Occasional breaks are necessary to prevent breakdowns. This unit is not designed to be

used non-stop.

Ÿ Always remember to unplug the unit from the power mains before any service is done.

Ÿ Please recycle the packaging.

D. By universal DMX controller

from 1 to 9 of the channel so that all the units will receive its DMX signal. Please refer to the

following diagram to know how to address your DMX512 system in the binary code.

Value

• Examples:

Channel 1 : dip / on : #1 ( 1 )

Channel 5 : dip / on : #1, #3 ( 1 + 4 = 5)

Channel 9 : dip / on : #1, #4 ( 1 + 8 = 9 )

Channel 13 : dip / on : #1, #3, #4 ( 1 + 4 + 8 = 13 )

• DMX512 Configuration

If you use CA-32 Colormix controller, the DMX value range of CH4 is from 100% to 0% .