ismoka iKit User Manual
Notice for Use
Welcome to use iSmoka Electronic Cigarette, all the pictures in this manual are
the scene shooting pictures of iSmoka products. Kindly please read the manual
carefully before use to ensure that your usage of e-cigarette is correct. Besides,
it is not recommended to assemble other brands’ parts with iSmoka products.
Otherwise, it will affect using effect and service life of products. In this case,
iSmoke wouldnot provide after-sales service for those products.
Any technical improvements on this product would not be informed in the future.
And if other inquires or consults, contact with your local iSmoka agents please.
Product Introduction
iKit is a new concept succedaneum of cigarette with collecting multiple
protection functions: short-circuit protection, low-voltage protection,
overcharge protection, atomizer protection. It adopts the latest technology of
automatical rear inductor. It is more reliable and safer due to its 650mAh
high-capacity and high-stability lithium battery. Both its cartomizer(about 1.6
ml) and cartomizer head could be repeatedly used. It gives you a brand-new
experience of vapor compared with the traditional cigarette. Just enjoy your
life without the worry about second-hand smoke.
Standard configuration
1* Mini BCC-S Clear Cartomizer
1* Cartomizer head
1* Mini Mouthpiece
1* iKit power supply
1* USB cable charger
iKit
User Manual
How to use
Just inhale the mouthpiece lightly and the vapors will come out. The LED
indicator will light up when inhaling.
Introduction of Mini BCC-S
Mini BCC-S is favored by e-cigarette lovers. It consists of a cartomizer and
a cartomizer base. Its magic lies in the cartomizer base which can be
dismantaled and changed. A pocket size can perfectly match with nearly all
kinds of batteries on the market. The whole e-cigarette looks so concordant
when the cartomizer is assembled with other parts together. Users can
replace or clean Mini BCC cartomizer head freely by themselves.
Features of Mini BCC-S
1.The cartomizer coil is assembled at the bottom of the BCC, and the liquid
can be vapored as soon as the cartomizer head heats.
2.There are large areas of silicone sealed on the bottom of BCC, providing
effective insulation.
3.The cartomizer head is consumable, you’d better replace it periodically to
guarantee it in good state.
iKit Battery Mini BCC-S Mouthpiece
How to add liquid
1. Unscrew the BCC base and refill the liquid from
the side of BCC body. Please do not fill the BCC
cartridge full, and it is better to leave a little space.
2. When refill the BCC, do make sure that the liquid
does not flow into the metal channel, otherwise it
will be sucked into your mouth.
Attention:
When the liquid is less than 10%, a slightly burn taste
may come out, hinting that you shall refill it.
After using the mouthpiece for a period of time, there may be some
accumulation on the internal components caused by carbonization and
impurities. So it is necessary to replace it periodically.
iKit Power supply
To better prolong the service life of battery, do not put the battery in the
environment surrounded by overheat or damp. Do not break or extrude the
battery, put the battery far away from sharp objects. And you can check the
details of its multiple protections as below:
Short-circuit Protection: When the output resistance is lower than 1 ohm
while smoking, the LED will long light (lasts two seconds) to stop outputting.
Low-voltage Protection: When the voltage of battery is below 3.1V, the
LED light will successionally blink ten times to stop outputting.
Overcharge Protection: When fully charged to 4.2V, it will cut off the
charging circuit automatically.
Catomizer Protection: When you vapor over 5 seconds, the LED light will
successionally blink two times to stop outputting.
How to charge
Firstly, please select iKit dedicated USB charger. Next, perfectly screw the
thread mouth of battery on the USB cable charger. Then connect the USB
charger to a wall adapter or computer. Be sure to be charged fully before
first use.
Specification of USB charger: DC 5V,500mA
It takes 300mAh, about 3-4 hours to fully charge.
The LED indicator lights up when the battery is charged and will go out
when fully charged.
Precautions
1. Only have your iKit repaired by iSmoka. Do not attempt to repair the unit
by yourself as damage or personal injury may occur.
2. Please obey local laws or regulations while vaporing with electronic
cigarettes. If there are any bans or potential dangers, please keep the
battery locked.
3. keep it away from children
Shenzhen iSmoka Electronics Co., Ltd.
Email:info@ismoka.com
Web:www.ismoka.com
Warranty
Please consult with iSmoka distributors for their warranty and return policy.
We are not responsible for any defects caused by human error. Our
warranty is not available for products purchased from third party vendors.
iKit Battery USB Cable Charge
Computer
Wall Adapter
Loading...