Table
of
Contents
Pages
1.
Introduction
2.
ISFM21
3.
Installation
4.
Frequency Selection and
App
5.
Bluetooth
6.
Troubleshooting
7.
Warranty
Components
Options
Operation
pairing and
Information
connecting
2
2
2
3
3
3
4
1.
Introduction
Thank you for choosing the iSimple ISFM
BLU) is designed to provide the connecting link between your Android powered device with
Bluetooth, and your vehicle. This interface provides a Bluetooth connection point for your
android phone,
or
tablet, and delivers streaming audio directly into your radio.
21
as your audio input solution. The ISFM21 (Tranzlt
2. ISFM21 Components
• Radio input module
· Application (Free download from android market)
3.
Installation Options (Choose A or B)
The ISFM21 interrupts the incoming antenna signal when
audio possible from your device.
simply pause the android device, and approximately 8 seconds later the full
accessible. There is also a power on/off/auto option
on/off control
toggle switch" into the power harness,
on or off at any time.
of
the ISFM21 is desired, disconnect the "loop plug
To
regain standard FM operation without interruption,
in
the Tranzlt BLU app.
in
its place. This will allow the user to turn the ISFM21
A. Connecting to any FM equipped radio
1) Red Wire. Connect to switched accessory power (not constant)
2)
Black Wire. Connect to ground.
3)
Antenna input. Connect antenna lead from the vehicle.
4)
Antenna output. Connect antenna lead into back
Note: Antenna adaptors may be needed for select vehicles!
The ISFM21 is compatible with amplified antenna systems, and adaptors.
in
use, to deliver the cleanest
FM
band will be
If
manual power
",
and plug the "optional
of
radio.
Android phone
<<(
DD
~=
Option
al
toggle
=ll
lr
swi
tch
B. Connecting to a radio equipped with an
1) Red Wire. Connect to switched accessory power (not constant)
Black Wire. Connect to ground.
2)
RCA connections. Use these connectors when the radio is equipped with an
3)
RCA audio input. Connect a short pair
into the radio 's aux input.
The antenna connectors are not used
~===-
r. Antenna Out' round
------..r
Antenna
In•
r((
iri
loopp
lug I c
O
-:::=
t
oauxolia~aud
Input on back ol
t
dac
~
Optional toggle swi
of
stereo RCA cables to this outpu
in
this configuration.
Android phone
({~
o~
({(
1r
tch
i
o
radoo
or
tablet
(not included)
RCA
auxiliary audio input
or
tablet
(not included)
D D
t,
and
2
4. Frequency Selection and
App Operation
Selecting the ISFM21 Frequency
The factory-set operating frequency
be
frequency may
illustration
).
For full frequency tuning control, visit the Android Market to download the free
easily adjusted using the selector switch on the side
app for Tranzlt BLU.
5.
Bluetooth Pairing and Connecting
To
pair your Android device with the ISFM21 (this is only required the first time you use
the Tranzlt BLU, after being paired, it will automatically reconnect with the android device
when returning to the vehicle)
A.
Turn the vehicle on.
B.
Open your device's Bluetooth settings menu, and search for new
Bluetooth adaptors.
C.
Select the device called "TranzltBLU
Note: If pairing is not successful within the first 2 minutes after turning the vehicle on, cycle
ignition off, then begin again
at
is
step A
88.3
FM.
Side
of
ISFM21
controlled 1106
If
an
alternate frequency is desired, the
of
the module (see
app
".
.318
8.3 187.9
Choose "Connect"
6. Troubleshooting
Symptom
No Audio from the Android
source correct station
Noise
I static on
stations
Audio
is
distorted
Can not find Tranzlt BLU
when searching bluetooth pairing mode (lasts 2 minutes
devices after key on)
Message
adnroid
message
device sating "Pairing
unsuccessful"
"Tra
on, in
to pair.
appears
device
appears
nzlt
BLU" is
range, and
regular
on
If
a
on
Make
turned
is
your
sure
ready
Cause Remedy
is
1) The radio
2) Device is not paired Please reference section 5
ISFM21 is active.
FM
The input from the android
source is too loud.
The Tranzlt BLU is no longer in Turn the vehicle off, then back on again,
The device did not properly
establish a bluetooth connection continues to fail. cycignition off, back on
The ISFM21 gain is set too low Adjust the gain setting on the back side
not set to the Tune to the default frequency: 88.3FM
for device pairing.
Pause the andorid device, and wa it 8
seconds.
Access the ISFM21 App, and select the
OFF option.
turn down the volume on the android
source until distortion is
heard.
try to pair within the first 2 minutes of
key on.
Press "Connect" aagin.
and try pairing again.
of
the ISFM21
no
If
pairing
longer
3
7.
Warranty
lnfonnation
One Year Limited Warranty
The quality controls used
This warranty applies only to the original purchaser
iSimple® dealer. This warranty covers any supplied or manufactured parts
upon inspection by iSimple® authorized personnel, is found to have failed
in
to defects
Attempting to service or modify this unit, operating this unit under conditions other than the
recommended voltage will render this
WARRANTY VOID.
Unless otherwise prescribed by law, iSimple® shall not be liable for any personal injury, property damage and or any incidental or consequential damages
damage) resulting from malfunctions, defects, misuse, improper installation or alteration
this product. All parts
Within the first 12 months from date
will repair or replace the product at our discretion, if it is defective
· providing it is returned to an Authorized iSimple®' dealer, with PROOF OF PURCHASE from
an authorized iSimple® dealer.
material or workmanship. This warranty does not apply to installation expenses.
in
the manufacture
of
this iSimple® product are guaranteed for a period
of
purchase, subject to the conditions above, iSimple®
of
this product will ensure your satisfaction.
of
this product from an authorized
of
in
of
this product that,
in
normal use due
any kind (including water
of
of
1 year as follows:
material or workmanship
Warning:
This equipment may be reset by unintentional electrostatic discharge during operation.
or
Exposure to direct sunlight
FCC Class B Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15
protection against harmful interference
ates, uses, and can radiate radio frequency energy and, if not installed and used
dance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more
1.
Re-orientate or relocate the receiving antenna.
2.
Increase the separation between the equipment and receiver.
3.
Connect the equipment into an outlet on a circuit different from that
is connected.
4.
Consult the dealer or an experienced radio I television technical for help.
extreme heat may cause damage or malfunction.
of
FCC rules. These limits are designed to provide reasonable
in
a residential installation. This equipment gener-
in
not
of
the following measures:
occur
in
a particular installation. If
of
which the receiver
accor-
Notice: The changes or modifications not expressly approved by the party responsible compliance could void the user authority to operate the equipment.
4
For best performance, have
professionally installed.
it~~
Inc.
,
com
.
rM
33760
AAMP
division
A
13190
56th
support@iSimpleSolutions
2011
©
of
Court
Clearwater,
Ph. 866-788-4237
AAMP
Florida
of
America
of
Florida
www.iSimpleSolutions.com
TranzltBLU Android APP User
r---~--------------~
ON: Turns
and keeps
running
FM
radio interface
or
Manual
ON
it
ON
OFF
while
is
APP
selected
is
- - - - - - - -
1
- - -
- - I : Slide left
-
-, 1- r
OFF:
AUTO:
r-------------------
1
FM
-I
This
: broadcasting
1
to
tune
Turns
Automatically turns
interface ON/OFF according
Bluetooth
(Note: Select
selecting
broadcast frequency:
is
the
your radio
FM
radio interface
(A2DP)
ON
AUTO)
FM
frequency TranzltBLU
to
your
FM
to
this same frequency.
L-------------------
r-------------------
-1
FM
broadcast frequency slide
I adjustment:
or
right
to
select best performing
1
FM
I
I
L-------------------
1
I adjustment:
frequency
FM
broadcast frequency
OFF
FM
radio
to
activity
before
is
radio on.
b~tt;n
Be
-
- -
sure
IMPORTANT NOTE: While listening
have extended pauses between songs
TranzltBLU will disengage. When this occurs your
momentarily. Once the next song begins, the TranzltBLU will reengage and play through.
The
TranzltBLU behaves this way due
functionality
select
listening experience.
ON
is
not
desired, you
in the TranzltBLU App
: :
1
I
L - MENU Button (on phone):
Use
1
L-
these
FM
frequency
to
select best performing
r---·
Allows selection
North America, Japan
of
L-------------------
to
certain sources
it
is
possible
to
the
Bluetooth
can
choose
as
outlined above. This will provide a
not
to
of
music such
that
the radio interface
FM
radio will play through again
A2DP
use the
AUTO
_....,_..,.
FM
radio region;
or
Europe
as
Pandora
signaling.
setting and instead
less
disruptive
__
that
of
If
the
this
Loading...