Page 1
Installation mnual
A
ssembling method for DMWL-01(Display unit)
1. Connect “DMS001 Type-1” and “control board”.
[NOTE]
Following messages should be mentioned in the users manual.
This transmitter must not be co-located or operated in conjunction
with any other antenna or transmitter.
This equipment complies with FCC radiation exposure limits set forth
for uncontrolled equipment and meets the FCC radio frequency (RF)
Exposure Guidelines in Supplement C to OET65. This equipment has
very low levels of RF energy that it deemed to comply without
maximum permissive exposure evaluation (MPE). But it is desirable
that it should be installed and operated with at least 2 0cm and more
between the radiator and person’s body (excluding extremities: hands,
wrists, feet and ankles).
And also following a message should be printed in the outside
label.
Contains FCC ID: XXJDMS001, Contains IC: 7216B-DMS001
Control Board
DMS001 Type-1
Page 2
A
ssembling method for DMWAP-01(Access point)
1. Connect “DMS001 Type-2” and “control board”.
2. Connect “DMS001 Type-2” and “antenna cable”.
3. Connect “Antenna cable” and “diple antenna”.
[NOTE]
Following messages should be mentioned in the users manual.
This transmitter must not be co-located or operated in conjunction
with any other antenna or transmitter.
This equipment complies with FCC radiation exposure limits set forth
for uncontrolled equipment and meets the FCC radio frequency (RF)
Exposure Guidelines in Supplement C to OET65. This equipment has
very low levels of RF energy that it deemed to comply without
maximum permissive exposure evaluation (MPE). But it is desirable
that it should be installed and operated with at least 20cm and more
between the radiator and person’s body (excluding extremities: hands,
wrists, feet and ankles).
And also following a message should be printed in the outside
label.
Contains FCC ID: XXJDMS001, Contains IC: 7216B-DMS001
Dipole Antenna
Antenna cable
Control Board
DMS001 Type-2
Loading...