ISGUS MR527E01 User Manual

1/6
ISGUS Mifare Reader
Integration Instructions
ISGUS Mifare Reader Integration Instructions
2/6
Purpose
This document describes the measures required to integrate the ISGUS Mifare Reader into an ISGUS terminal and which regulations must be observed and fulfilled in order to introduce the terminal in the USA and Canada.
Product description
The ISGUS Mifare Reader is a RFID identification system in form of a pluggable module. The module consists of the OEM radio module PRIMO340 (manufactured by phg) and a PRIMO340 adapter with integrated loop antenna and antenna tuning network.
ISGUS Mifare Reader Integration Instructions
OEM radio module PRIMO340
PRIMO340 adapter
Loop antenna
10-pole and 4-pole pin contact strips, 12 mm
ISGUS Mifare Reader 3/6
Intended use
The reader is intended exclusively as a reading module for ISGUS time recording and access control terminals (host devices). Other areas of application deviating from this are considered contrary to the designated use.
Regulations
The ISGUS Mifare Reader has been tested according to FCC and Industry Canada (IC) regulations for module approvals.
FCC ID: 2AVK6-MR527E01 IC: 25797-MR527E01
PMN: ISGUS Mifare Reader HVIN: MR527E01 FVIN: 68075J
Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate this equipment.
User manual warnings and statements
Provisions, instructions and warnings that must be included in the User Manual of the host device.
FCC: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.
Canadian Radio Certification: This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
4/6
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
ISGUS Mifare Reader 5/6
Testing of host device with approved reader The manufacturer is responsible for ensuring that the host device has been tested and complies with the following rules and regulations.
FCC47 CFR Part 15: Radio Frequency Devices (Subpart B and Subpart C)
RSS-210 Issue 9 (10)
ICES-003 Issue 6: Spectrum Management and Telecommunications. Interference-
Causing Equipment Standard. Information Technology Equipment (Including Digital Apparatus) – Limits and Methods of Measurement
Labeling of the host device
Label on the case:
Contains FCC ID: 2AVK6-MR527E01 Contains IC: 25797-MR527E01
Installation
The ISGUS Mifare Reader is pluggable connected to the reader adapter board.
ISGUS
M
ifare Reader
Reader adapter board
ISGUS Mifare Reader 6/6
Installation and integration of reader adapter board into IT 82xx (Fig. IT 8210):
Copyright © ISGUS GmbH 2020
Edition: 002US.0220 00 MA 1ZH
ISGUS GmbH Oberdorfstr. 18 – 22 D – 78054 Villingen-Schwenningen www.isgus.de info@isgus.de
Reader adapter board
with
ISGUS
Mifare Reader
ISGUS
Mifare Reader
Loading...