The manual contains symbols to attract the reader's attention and highlight particularly
important aspects. The table below illustrates the meaning of the various symbols used.
Read the manualUse of protective clothing
DANGER
Live electrical parts
ATTENTION / DANGERImportant information
Information
Eye checkNotes/Important Notes
On-board Condensing unitRemote Condensing unit
DANGER
Slipping
DANGER
Tripping
Maintenance requirement or operations that
must be completed by qualifi ed personnel or
technical assistance centre
Operations that must be performed by two
persons
Waste disposal
Recyclable Material
Earthing
428000364237 MULTIVIEW
EN
USE AND MAINTENANCE MANUAL
3
1. NOTES / WARNINGS
NOTE
The content of this manual is of technical nature and is owned by ISA.
It is forbidden to reproduce, circulate or modify all or part of its content
without written consent. Any infringement will be legally pursued.
The manual and the conformity certifi cate are an integral part of the equipment
and should always accompany the product in the event of a transfer to a new
location or to a new owner. The user is responsible for the integrity of these
documents, for their consultation and during the whole life cycle of the equipment
itself. Keep this manual in a safe place.It should be available for consultation
near the equipment at all times. If lost or destroyed, you can request a copy of
the manual from ISA by specifying the exact model, serial number and year of
manufacture. The manual refl ects the manufacturing technology at the time of
supply.The manufacturer reserves the right to modify its products in any way it
deems necessary, with no obligation to update manuals and machines relating to
previous manufacturing batches.
The equipment can be used by children no younger than 8 and by persons
with reduced physical, sensorial or mental capabilities, or lacking experience or
necessary knowledge, as long as supervised or after having received training
regarding safe use of the equipment and have an understanding of the inherent
risks involved. Do not allow children to play with the device. The cleaning and
maintenance that the user will carry out must not be undertaken by children
without supervision.
Always refer to this manual before going ahead with any operation. Before doing
any type of work, disconnect the equipment from the power supply. Any work on
electric and electronic parts or cooling system components should only be carried
out by trained personnel in compliance with current laws.
The Manufacturer cannot be held liable for any damage to persons, animals or to
the product in the following cases:
• improper use of the equipment or use of the appliance by unqualifi ed or
unauthorised personnel;
• failure to comply with current legislation
• incorrect installation and/or power supply faults
• failure to observe the instructions contained in this Manual
• failure to follow the maintenance programme
• unauthorised modifi cations
• installation of non-original spare parts in the equipment
• installation and use of the equipment for purposes other than those for which
the appliance was designed and sold;
• Tampering with or damage to the power supply cable.
428000364237 MULTIVIEW
EN
USE AND MAINTENANCE MANUAL
4
1. NOTES / WARNINGS
Liability for applying the safety instructions contained in this manual is held by
the technical personnel responsible for the intended use of the equipment, who
should ensure that authorised personnel:
• Are qualifi ed to carry out the requested activity;
• is aware of and carefully complies with the instructions contained in this
document
• are aware of, and apply, the general safety standards applicable to the
equipment.
The buyer is responsible for training personnel using the appliance on the risks,
safety devices and general health and safety rules required by the laws of the
country where the appliance is installed.Users/operators should be aware of the
position of all the controls and how they work, as well as of the features of the
appliance.
They should also read this manual in its entirely. Maintenance work should be
conducted by qualifi ed personnel after the appliance has been prepared adequately.
DANGER
Unauthorised tampering with or replacement of one or more parts
of the appliance, use of accessories that modify the use of the same
and use of spare parts different to those recommended, can become
the cause of injury.
DANGER
Any work conducted on the on the appliance must involve
disconnection from the power socket and in any case, none of the
protective elements (grid, casing) should be removed by non-qualifi ed
staff.The appliance should not be operated when these protective
elements have been removed.
NOTE
In order not to compromise functionality and safety of the appliance,
the particularly complex installation and maintenance activities are not
documented in this manual and are performed by specialised ISA S.r.l.
division TASSELLI.
Never use electric devices inside this appliance. Do not use mechanical
devices or other means to accelerate the defrosting process, other than those
recommended by the manufacturer. Keep the air vents in the casing of the
appliance or in the structure built into the wall free of obstructions. Do not
damage the refrigeration circuit.
RISK OF EXPLOSION
Do not store products containing fl ammable propellants or explosives.
428000364237 MULTIVIEW
EN
USE AND MAINTENANCE MANUAL
5
1. NOTES / WARNINGS
STAFF TRAINING
The buyer is responsible for ensuring personnel who will use the appliance
and maintenance technical staff are instructed and trained adequately. The
manufacturer is available for advice, clarifi cations, etc. so that the operator
and technical staff can use the appliance correctly. To ensure operator safety,
appliance devices should be kept in constant working order. This manual is
intended to illustrate the use and maintenance of the appliance.The operator has
a responsibility and duty to carefully observe the instructions contained within it.
Failure to comply with safety standards may result in injury to personnel and
damage to the equipment components and control unit.
The user can contact the dealer to request additional information not contained
in this document, or suggest improvements, at any time.
Before the product is delivered to the customer, it is essential that
a trained technical member of staff checks that the appliance is
operating correctly in order to achieve maximum performance.
INTRODUCTION
ISA employs materials of the best quality and as they enter the company,
we constantly monitor their storage and the use as part of the manufacturing
process to prevent damage, deterioration and failure. All manufacturing elements
has been designed and manufactured in order to guarantee reliability and high
safety standards. All appliances are subjected to a strict testing procedure before
delivery .However , please bear in mind that product performance over time depends
on correct use and adequate maintenance. This manual contains the necessary
instructions to maintain the appliance’s initial appearance and functions over
time.
The use and maintenance manual contains the information required to understand
the operating modes of the appliance and for its correct use, in particular: the
technical description of the various functional groups, accessories and safety
systems, operation, use of instrumentation and interpretation of any diagnostic
warnings, main procedures and information relating to the ordinary maintenance
operations. For correct use of the appliance, the working environment should
comply with current health and safety standards.
The safety requirements, indications, standards and notes illustrated in the
various chapters of the manual are aimed at establishing a code of conduct and
a series of obligations to be observed when performing the various activities, in
order to create safe conditions for personnel, the equipment and the surrounding
environment.
428000364237 MULTIVIEW
EN
USE AND MAINTENANCE MANUAL
6
1. NOTES / WARNINGS
The safety standards reported in this document are intended for trained, authorised
personnel responsible for:
• Transport
• Installation
• Operation
• Management
• Maintenance
• Cleaning
• Putting out of order
• Disposal
ATTENTION
Reading this manual, albeit in full, is no substitute for adequate user
experience. therefore it should only be considered a useful reminder
of the technical features and the main operations to perform.
WARNING
Installers and users must read
and understand all instructions herein before
carrying out any operation on the equipment.
428000364237 MULTIVIEW
EN
USE AND MAINTENANCE MANUAL
7
1. NOTES / WARNINGS
R744 - REFRIGERANT (WHERE APPLICABLE)
R744 The refrigerant R744 is a gas that is compatible with the environment.
Pay close attention during transport, installation and that the
destruction not to damage the refrigerant pipelines.
IN THE EVENT OF DAMAGE:
Keep fl ames or sources of ignition away from the appliance. Properly ventilate
the premises for a few minutes. Turn the unit off, pull the plug. Notify the
customer service department.
ATTENTION
The refrigerant system is High Pressure.
Do not tamper with the system, but call a specialised and qualifi ed technician
before disassembly.
ATTENTION
Maintenance must be performed by qualifi ed personnel that has been
to work with fl ammable refrigerants.
R290 - REFRIGERANT (WHERE APPLICABLE)
The refrigerant R290 is a gas that is compatible with the environment,
but is highly infl ammable. Pay close attention during transport,
installation and dismantling not to damage the refrigerant pipelines.
IN THE EVENT OF DAMAGE:
Keep fl ames or sources of ignition away from the appliance. Properly ventilate the
premises for a few minutes. Turn the unit off, pull the plug. Notify the customer
service department. The more refrigerant containing an appliance, the greater
must be the environment in which there is the unit. In areas too small, in the
event of leakage can form a fl ammable mixture of air and gas. The volume of
the room where the appliance is installed must be at least 19 m³ for each
cooling system present in the room.
428000364237 MULTIVIEW
EN
ATTENTION
Maintenance must be performed by qualifi ed technical personnel with ap-
propriate training and authorisation to work with infl ammable refrigerants.
USE AND MAINTENANCE MANUAL
8
1. NOTES / WARNINGS
R600a - REFRIGERANT (WHERE APPLICABLE)
The refrigerant R600a is a gas that is compatible with the environment,
but highly fl ammable. Pay close attention during transport, installation
and dismantling not to damage the refrigerant pipelines.
IN THE EVENT OF DAMAGE:
Keep fl ames or sources of ignition away from the appliance. Properly ventilate the
premises for a few minutes. Turn the unit off, pull the plug. Notify the customer
service department. The more refrigerant containing an appliance, the greater
must be the environment in which there is the unit. In areas too small, in the
event of leakage can form a fl ammable mixture of air and gas. The volume of
the room where the appliance is installed must be at least 17 m³ for each
cooling system present in the room.
ATTENTION
Maintenance must be performed by qualifi ed technical personnel with ap-
propriate training and authorisation to work with infl ammable refrigerants.
428000364237 MULTIVIEW
EN
USE AND MAINTENANCE MANUAL
9
2. MANUFACTURER
ISA
Bastia Umbra - Perugia - Italy
www.isaitaly.com
Tel. +39 075 80171
Fax ++39 075 8000900
3. WARRANTY TERMS AND CONDITIONS
The seller's warranty on the equipment is valid for 12 (TWELVE) months from the date of delivery. The warranty includes repairs or replacements of any faulty parts due to manufacturing processes or installation after
written communication has been received, stating the appliance serial number and date of installation.
Not included in the warranty:
• Incorrect use of the appliance
• Incorrect connection to the power grid
• Normal component wear (e.g. compressor failure, neon/LED lights, etc.) where not caused by manufacturing defects.
• Installation, technical instruction, regulation and condenser cleaning call-outs.
If the seller's technical staff detect any tampering, unauthorised repairs or inappropriate use of appliance the warranty
will be invalidated.
Shipment of components covered by the warranty is freight collect only.
Any damage to the appliance detected at the time of delivery due to transport must be reported on the same shipping
note to claim compensation from the carrier.
The seller cannot be held liable in the event of damage to accepted products due to appliance faults.
4. EQUIPMENT IDENTIFICATION
• Find the label affi xed to the machine in order to read technical data.
• Check the machine model and the power supply voltage before you perform any operation.
• If you fi nd discrepancies, contact the manufacturer or the company that supplied the machine immediately.
1
IDENTIFICATION OF THE COMPANY RESPONSIBLE FOR THE PRODUCT
2SYMBOLS OF COMPLIANCE
3TYPE
4MODEL NAME
5ARTICLE
6PRODUCTION DATE
7PRODUCTION ORDER
8CUSTOMER ORDER
9PRODUCT CLASS
10SERIAL NO.
11OWNER REGISTRATION NUMBER
12SUPPLY VOLTAGE
13SUPPLY VOLTAGE
14FUSE VALUE
15LAMP POWER
16ELECTRICAL RESISTANCE ABSORPTION
17NOMINAL POWER (NORMAL OPERATION)
18POWER (DEFROSTING)
19MINIMUM PRESSURE
20MAXIMUM PRESSURE
21SAFETY CLASS
22NOMINAL CURRENT
23CURRENT DURING DEFROSTING
24SHELF LOAD
25TANK LOAD
26TYPE OF COOLANT
27WEIGHT OF COOLANT
28GROSS VOLUME
29EXPANDING ISOLATION AGENT
30WEEE MARK
428000364237 MULTIVIEW
EN
USE AND MAINTENANCE MANUAL
10
5. USE
This appliance is exclusively intended to:
DISPLAY OF FRESH PRE-PACKAGED, DAIRY AND DRINK PRODUCTS
The manufacturer is not liable for injury to persons or damage to property or the appliance itself caused by
the displaying of products other than those described above.
It is fundamental not to exceedthe load limits indicated in order not to alter the correct air circulation
and thus prevent a higher product temperature. The limits indicated refer to a static and evenly distributed
load. Therefore dynamic overloads due to violent loading operations are excluded, which must be
prevented for safety reasons.
5.1 COMPOSITION
The appliance is made up from a unique cabinet, onto which all devices necessary to make it a professional and effi cient product for its declared use, are installed.
The appliance is composed of:
Ventilated refrigeration unit (VR)
Condensing unit on board (UCB) or remote (UCR)
Electrical system
Electronic controller
Insulated monolithic structure in ecological polyurethane
Height-adjustable feet
Internal LED illumination
Height-adjustable display shelves
Front closing with manual self-rolling coverMULTIVIEW
Front closing with single glass doorsMULTIVIEW SGD
Automatic condensed water evaporationOnly UCA models
428000364237 MULTIVIEW
EN
USE AND MAINTENANCE MANUAL
11
Loading...
+ 23 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.