
GHZ BGA Socket (direct mount - hardware)
Page 1 of 2
Assembly Instructions
Tooling holes have to be designed into the target PCB for this version of the GHz BGA socket
1. Install the socket base assembly on the target PCB with the hardware (round head 0-80 screws and nuts) provided (see Detail A for
orientation).
2. Place BGA package (solder ball side down) into the socket. NOTE: BGA orientation on target PCB is cr itical.
3. Place the compession plate on top of the BGA package.
4. Install the socket top assembly on to the socket base assembly and swivel to lock into the position.
5. Turn the set screw (x4) clockwise, until it makes contact with the compression plate.
6. Turn an additional 3 to 5 turns.
Set Screw (x4)
Socket
Top Assembly
Socket Lid
BGA Package
Socket Base Assembly
Target PCB with SMT pads
Nylon Washer
Hex Nut
Compression plate
Round head Screw
Socket Base
Dowel pin
Angle wire elastomer
Backing Plate
(not necessary for
some sockets)
© 2002 IRONWOOD ELECTRONICS, INC.
Tele: (800) 404-0204
www.ironwoodelectronics.com
Filename: GCI.mcd, Rev A, 6/25/02, IP

GHZ BGA Socket (direct mount - hardware)
Assembly Instructions
Page 2 of 2
Top View
Orientation Mark
DETAIL A
Socket Base
PATTERN OFFSET
(CLOSER TO RIGHTSIDE
TOOLING HOLES)
Side View
NOTE: WHEN PLACING SOCKET BASE ASSEMBLY,
ORIENTATION MARK SHOULD BE ON THE UPPER
LEFT CORNER AS SHOWN IN THE TOP VIEW.
Offset
© 2002 IRONWOOD ELECTRONICS, INC.
Tele: (800) 404-0204
www.ironwoodelectronics.com
Filename: GCI.mcd, Rev A, 6/25/02, IP