Iron-A-Way UD42ROU, UD42NDU, UD42WDU, UD42MDU, UD42RMU Specifications

Product Model Numbers

Ironing Centers: UD-42

Board automatically engages to low position each time

the board is put away.

Height Adjustments

Specifications | February 2015

Dimensions (Actual Size)

Overall height: 60 5/8”
Overall width: 15”
Overall depth including door: 7 3/4”
Dimension from wall to outer
edge of door (when recessed): 3 7/8”
Penetration into opening: 3 7/8”
Wall opening height: 59 7/8”
Wall opening width: 14 3/8”
Wall opening depth: 3 7/8”

Opening dimensions listed above

Overlap distances when using wall

Top overlap: 3/8”
Bottom overlap: 3/8”
Right side overlap: 3/8”
Left side overlap: 3/8”

15/16

Specifications
February 2015

Additional Information

• Unit may be surface mounted (unit extends
approximately 7 3/4” into room) or recessed
(unit extends approximately 3 7/8” into room)
into any wall with standard 16” center studs.

• See table bottom right to determine desired
ironing board height above the floor. The
user can adjust height of board after
installation with a 4” differential between a
maximum and minimum height.

• Unit can be provided with a left hinged door
upon request.

• Comes standard with wood veneer door.

• Electrical requirements: 115/120v, 15 amp.

Pigtails are provided in bottom of wire
raceway for hookup to supply line. Make
entrance into knockout provided in top of
wire way through right-hand vent hole.

• Recommended to attach 2” x 4” cleats to
studs, level with the bottom of opening (for
support when recessing unit.)

• Door opens approximately 180°. Allow at
least 16”
swing open (door hinges on full length piano
hinge.)

• Options include: Surface mount trim
(necessary for surface mounting), oak, maple,
pine, or white raised panel door, flat white
door, glass mirrored door, or no door,
sleeveboard, rough-in kit, and iron.

See Page 2 for additional information

Right hinge is standard.

to the side of the unit for door to

the board is lowered for use. High position requires
adjustment and engages back to low position each time

Cut Opening Minimum Maximum

(Default) (Adjusted)

Above floor Position Position

16” 32” 36”
15” 31” 35”
14” 30” 34”
13” 29” 33”
12” 28” 32”
11” 27” 31”

Specifications

Recommended Adequate Space/Clearance for Ironing

Specifications | February 2015

February 2015

Page 2

Product Model UD-42

Additional Information

Measurements when board is lowered

(Not to Scale)

Unit can be provided with a left hinged door upon request. Right hinge is standard.
Door opens approximately 180°. Allow at least 16” from side of cabinet.
Board can be turned left or right 90° in either direction until parallel with the wall.
Additionally, there are conveniently placed stopping points as the board is being turned.

46 7/8”

20 7/8”

17 3/4”

32 7/8”

43 3/4”

13 1/8 14 5/8”

Distance from Wall to tip of Ironing Board 46 5/8”
Swivel Clearance from cutout opening of cabinet 14 7/8”
Distance from Wall in Full Swivel Position 33”
Standing Area Clearance ** 24”

** The recommended distance from the side of the ironing board
where the user will typically stand to ensure adequate space for
ironing.

46 7/8”
14 5/8”
32 7/8”