Iron-A-Way NE46WDU, NE46MDU, NE46RMU, NE46NDU, NE46FWU Installation Manual

Installation

Manual

MODEL NE-46

GET TO KNOW YOUR UNIT

1

2

1. CROSS BRACES 2. HOT IRON REST

Tools Needed: Supplied Parts:

- Stud Finder

- 12-14” Level

- Tape Measure

- Small Flathead
Screwdriver

- Electric Drill
(with 1/4” & 1/8” drill bit)

- 1/4” Nut Driver
(optional)

- Safety Glasses

- Utility Knife

Recessed Mounting:

- Four #10 x 1

portion of cabinet

- Two #14 x 2

side brackets

Surface Mounting:

- Two #14 x 4” wood screws

1/2

” wood screws for top

1/2

” Phillips screws for top

9

PRE-INSTALLATION

1. DETERMINE MOUNTING HEIGHT

Using the charts provided, determine
the mounting height above oor (the
distance between the oor and the
bottom of the cabinet). First choose
your desired ironing board height
from the left column, then locate the
corresponding mounting height in the
right column.

Desired Ironing

Board Height

36”

35”

34”

33”

Mounting

Height Above

Floor

25”

24”

23”

22”

2. LOCATE STUDS & UTILITIES

Using a stud nder, locate the wall

studs to be used for mounting.

Locate the existing wiring or other
utilities in the wall to prevent drilling
into/severing a wire and/or other utility
during installation.

Mounting

Height

Above Floor

Desired Ironing

Board Height