Page 1
Product Model: E-46
Ironing Board Heigh t
19” 30”
Dimensions (Actual Size)
Overall height: 60 5/8”
Overall width: 15”
Overall depth including door: 7 3/4”
Dimension from wall to outer
Edge of door (when recessed): 3 7/8”
Penetration into opening: 3 7/8”
Rough opening height: 59 7/8”
Rough opening width: 14 3/8”
Wall opening depth: 3 7/8”
Opening dimensions listed above
Overlap distances when using wall
Top overlap: 3/8” Right side overlap: 3/8”
Bottom overlap: 3/8” Left side overlap: 3/8”
Additional Information
• Unit may be surface mounted (unit extends
approximately 7 3/4” into room) or recessed
(unit extends appro x imately 3 7/8” into room)
into any wall with standard 16” center studs.
• See table bottom right to determine desired
ironing board height above the floor.
• Unit can be provided with a left hinged door
upon request. Right hinge is standard.
• Comes standard with w o o d veneer door.
• Electrical requirements for E-46: 115/120v, 15
amp. Pigtails are provided in bottom of wire
raceway for hookup to supply li ne. Make
entrance into knockout provided in top of
wire way through left-hand vent hole. (Refer
to Top View Diagram.)
• Recommended to attac h 2” x 4” cleats to
studs, level with the bottom of opening (for
support when r ecessing unit.)
• Door opens approximately 180°. Allow at
least 16” to the side of the unit for door to
swing open (door hinges on full length piano
hinge.)
• Options include: Surface mount trim
(necessary for surface mounting), oak, maple,
pine, or white raised panel door, fl a t white
door, glass mirrored door, or no door, sleeve
board, swivel, rough-in kit, and iron.
See Page 2 for additional information
Specification s | February 2015
Cut Opening Board
Above floor Height
27” 38”
26” 37”
25” 36”
24” 35”
23” 34”
22” 33”
21” 32”
20” 31”
Page 2
Recommended Adequate Space/Clearance for Ironing
the user will typica l ly stand to ensure adequate space for ironing.
Product Model: E-46
Additional Information
Measurements when board is lowered
(Not to Scale)
Unit can be provided with a left hinged door upon request. Right hinge is standard.
Door opens approximately 180°. Allow at least 16” from side of cabinet.
Specifications | February 2 015
Page 2
Distance from Wall to tip of Ironing Board 46 1/4”
Swivel Clearance from cutout opening of cabinet N/A
Distance from Wall in Full Swivel Position N/A
Standing Area Clearance ** 24”
** The recommended dis tance from the side of the ironing board where
Loading...