Iron-A-Way E42WDULH Specs

Product Model Numbers

Ironing Centers: AE-42 and ANE-42

Board automatically engages to low position each time

the board is put away.

Height Adjustments

Dimensions (Actual Size)

Overall height: 52”
Overall width: 15 ”
Overall depth i ncluding door: 7 3/4 ”
Dimension from wall to outer
Edge of door (when recessed): 3 7/8”
Penetration in to o p ening: 3 7/8”
Rough opening heigh t : 51 1/4”
Rough opening width: 14 3/8”
Wall opening depth: 3 7/8”

Opening dimensions listed above

Overlap distances when using wall

Top overlap: 3/8” Right side overlap: 3/8”
Bottom overlap: 3/8” Left side overlap: 3/8”

Additional Information

• Unit may be surface mounted (uni t extends
approximately 7 3/4” into room) or recessed
(unit extends approx imately 3 7/8” into room)
into any wall with standard 16” cente r studs.

• See table bottom righ t to determine desired
ironing board height above the floor. The
user can adjust height of board after
installation wi th a 4” differential be tween a
maxi mum and min imum h eight.

• Unit can be provided w ith a left hinged door
upon request. Right hinge is standard.

• Comes standard with wo o d veneer door.

• Electrical requirements for AE-42: 115/120v,

15 amp. Pigtails are p rovided in bottom of
wire raceway for hookup to supply line. Make
entrance into kn o ckout provided in top of
wire way through lef t-hand vent hole.

• Electrical requirements for ANE-42: Does not
require electricity, non-electric.

• Recommended to attach 2” x 4” cleats to
studs, level with the b o ttom of opening (for
support when reces sing unit.)

• Door opens approximately 180°. Allow at
least 16” to the side of the unit for door to
swing open (door hinges on full length piano
hinge.)

• Options include: Su rface mount trim
(necessary for surface mounti ng), oak, maple,
pine, or white raised p a nel door, flat white
door, glass mirrored door, or no door, rough-in
kit, and iron.

See Page 2 for additional information

Specifications
February 2015

the board is lowered for use. High position requires
adjustment and engages back to low position each time

Minimum Maxi mum
Cut Opening (Default) (Adjusted)
Above floor Position Position

31” 38” 42”
30” 37” 41”
29” 36” 40”
28” 35” 39”
27” 34” 38”
26” 33” 37”
25” 32” 36”

Recommended Adequate Space/Clearance for Ironing

Page 2

Product Model AE-42 and ANE-42

Additional Information

Measurements when board is lowered

(Not to Scale)

Unit can be provided with a left hinged door upon request. Right hinge is standard.
Door opens approximately 180°. Allow at least 16” from side of cabinet.
Board can be turned left or right 90° in either direction until parallel with the wall.
Additionally, there are conveniently placed stopping points as the board is being turned.

Specifications

December 2014

Distance from Wall to ti p of I roning Board 46 7/8”
Swivel Clearance from cutout opening of cabinet 14 5/8”
Distance from Wall in Full Swivel Position 32 7/8”
Standing Area Clearance ** 24”

** The recommended distance from the side of the ironing board
where the user will typically stand to ensure adequate space for
ironing.