Iron Aces Rushmore Street Glide Mount Quick Start Manual
Tools Required:
• Blue Loctite
• Allen wrench – 2mm & 3mm
• Phillips head screwdriver
• 7mm Wrench
IMPORTANT!!
Iron Aces Speed Shop is not responsible for the
operation of the Rushmore Street Glide Mount or
its compliance with highway regulatory and safety
standards. Please use common sense and do not
operate either device while riding your motorcycle.
Doing so is at your own risk.
Zumo 5xx
Hardware
Zumo 390LM
Hardware
See Appendix for Explanation of Parts
Zumo 6xx
Hardware
Base-to-Cam
Screws
Cam-to-Mount
Screws
704-255-1780
www.ironacesspeedshop.com
Street Glide Mount - Rushmore
Version 1.0Install Guide4101-E Stuart Andrew Blvd. Charlotte, NC 28217
Step 1
Using the supplied alcohol prep pad, thoroughly clean
the inner fairing surface where the Rushmore Street Glide
Mount will be installed.
****IMPORTANT****
Allow this surface to thoroughly dry before mounting the
Rushmore Street Glide Mount.
IMPORTANT!!
To obtain optimum adhesion, the
bonding surfaces must be clean, dry and
applied at room temperature.
After application, the bond strength
will increase as the adhesive flows
onto the surface. At room temperature,
approximately 50% of the ultimate
strength will be achieved after 20
minutes, 90% after 24 hours and 100%
after 72 hours.
Step 2
Remove the VHB protective film on base and loosely align
the Rushmore Street Glide mounting base to the inner
fairing. Take extra time for proper center alignment.
****HELPFUL TIP****
The base of the mount is profiled to match the profile of
the inner fairing. Loosely attached the mounting plate
and use the center hole in the Iron Aces logo for proper
centering. The base has a small amount of flex, therefore
the fitment will be affected if base it tightened snuggly.
704-255-1780
www.ironacesspeedshop.com
Step 3
Once proper alignment is achieved, press firmly on the
base of the Rushmore Street Glide Mount for 30 seconds.
****IMPORTANT****
Bond strength is dependent upon the amount of adhesive-
to-surface contact developed. Firm application pressure
develops better adhesive contact and helps improve bond
strength.
Street Glide Mount - Rushmore
Version 1.0Install Guide4101-E Stuart Andrew Blvd. Charlotte, NC 28217
Loading...