I-rocks RF-6572 User Manual

USB Keyboard and Optical Mouse Kit

1US

ID Setting

This ID-recognition function helps to protect against interference
from other RF keyboards in the same environment. Remember to set
the ID when you replace the batteries or your keyboard do not work
properly. Please follow below steps to complete the necessary ID­Setting process for your cordless mouse and USB dongle receiver.

1. Make sure the mouse hardware installation is completed.

2. Turn your cordless mouse on. The red sensor display light representative
power on can work. (When not in use, turn mouse off to save batteries.)

3. Turn your cordless mouse on.

4. Plug the USB dongle receiver into your computer’s USB port.

5. Waiting for the USB plug and play initialization completed, and the dongle
receiver LED will light flush.

6. Move your cordless mouse and close to the USB dongle receiver within
30cm, then click the mouse left button to start ID setting process, and
press keyboard “ESC” key (or press keyboard connect button) of the keyboard
to make sure the ID connection. (It will take about 4~8 seconds waiting time)

7. Once the ID setting process is completed, the receiver LED will light
off. The receiver LED will light on again when cordless mouse is working.

8. If the mouse or keyboard doesn’t work properly, please remove the
USB dongle receiver from computer’s USB port, then repeat do step
3 to step 6 again.

Enjoy using your keyboard and mouse.