iROCKER CRUISER Use And Maintenance Manual

INFLATABLE

www.irockersup.com

The Manual for Use and Maintenance

CARE & MAINTENANCE

TRANSPORT GUIDELINES

DO NOT LEAVE IN DIRECT SUNLIGHT

Damage resulting from heat is not covered by manufactures warranty!!

Never leave paddle board exposed to direct sunlight when out of the water.
Always keep in the shade when not in the water. If you must expose your
board to direct

sunlight during transport or temporary storage, it is safest to keep

the (bottom) facing up.

RECOMMENDED PRESSURE 15 PSI

iRocker Boards can hold up to 25 PSI, however the recommended PSI is 15 PSI
as the board will remain rigid at 15 PSI and no further benefit is gained when
inflating over 15 PSI

Do not transport an

inflated paddle board on top of
a vehicle.

TIPS FOR TRANSPORTING

This inflatable board is designed to be compact
for convenient storage & travel. Due to a lack of
weight when inflated, they will travel poorly if

strapped to a vehicle rooftop.

Damages or warping incurred by improper
transport are not covered by the manufa cture r’s
warranty!

When transporting the board, be sure to clear any
sharp objects. Punctures are not covered by the

manufacturer's warranty!

If inflated cold to 25 psi, and then the board is placed in direct sunlight pressure will
increase from the heat causing potential over inflation and damage to the seams – this
is not covered by warranty.

PUMP MAINTENANCE

Over time, the pump may naturally lose
lubrication and you may need to reapply. We
recommend white lithium grease. To lubricate,

open the top and pull out plunger and spread a
thin layer of lubricant on the black gasket on

the bottom of the plunger and then reassemble.
Also, regularly clean the air filter located under

the pressure gauge. The gauge unscrews from
the top by hand.

BOARD MAINTENANCE

S

un, sand and saltwater will degrade any man-made
material over time. Rinse off sand and saltwater
deposits from your paddle board with fresh water
and store in a cool, dry environment after each use.

Keep the board clear of any heat producing items
such as camp stoves, propane lamps, etc.

Damages resulting from heat are not covered by
the manufacturer's warranty!

Allow the board to completely dry before tightly
rolling for packing. Excess moisture may cause
mildew or mold damage.

IMPORTANT