IRIS035 Fixed Wide Angle Micro Dome Camera.
Wide Angle Dome Camera with IR LED Illumination.
Thank you for buying the IRIS035 from Iris Innovations.
This product has been designed especially for use as an on board docking camera / backup camera for the marine industry.
Before installing and operating the product, please read this instruction leaflet to familiarize
your self with the products features, limitations and installation requirements.
Key Features:
Height at 45˚ = 47mm
✴
Ultra Wide Angle View. 2.3mm provides 120˚ Horizontal field of view.
✴
Available in PAL or NTSC Video Formats.
✴
Available in Standard View or Mirror Image for aft facing installations.
✴
Incredibly Compact Housing. Measures only 48mm Diameter x 43mm*
✴
High Resolution Camera Module (540 TVL).
✴
12 x Infra Red LEDʼs provides up to 8 meters visibility in the dark.
✴
Compatible with all Chart Plotters that support composite video inputs.
✴
Water Resistance (IP66).
✴
Day / Night Operation (Switches to monochrome in the dark).
Installation Considerations:
1. Camera requires 12VDC
Height Straight = 43mm
2. Video Output connector from the camera Female RCA socket
Diameter = 48mm
3. Prior to fixing camera into place, power up the camera to ensure desired field of view is
achieved.
4. Ensure camera does not obstruct any moving fixtures on the boat such as hatches or
doors.
5. Ensure there is sufficient access in head linings and bilk heads to allow cable run, and
ensure any screws used to fix the camera into place do not foul any existing cables.
Cautions:
1. Camera operates on 12VDC ± 3V. Do not connect camera to a 24VDC supply.
2. Ensure correct polarity when connecting power. Incorrect connection will damage the
Adjustment Angle 45˚
Installation:
1. Sight camera in desired position. It is advised that the camera is powered up and the field of view checked before fixing into place.
Also ensure the power and video cable can be run to the camera and that camera fixings screws will not foul and damage any other
cable or equipment mounted behind the fixing surface.
2. Ensure power supply to camera is sufficiently protected, by either a fuse rated at 1A or a circuit breaker from the boats distribution
panel. It is recommended that a power supply with an isolated ground be used.
3. Run suitable video cable from the camera back to the monitor, chart plotter or video processing device. RG59 / URM70 or RG159
mini coax is advised, although other cable can be used. Consult your local dealer or Iris Innovations before using alternative cable.
CAT5 cable can also be used in conjunction with video baluns is desired.
4. Use the base of the camera as a template to mark of screw holes and cable entry hole. Carefully loosen the grub screws that hold
the cup into the base and slide off, along with the camera ball and metal seating ring.
camera beyond repair.
3. Avoid pointing the camera directly at sunlight as prolonged operation could damage the
imaging sensor.
Warning!
Loosen grub screw fully using 2mm Hex Key
(supplied) prior to adjusting camera position
within cup-bracket.
Failure to do so could result in damage to
the paintwork which will invalidate the
warranty.
Power Connection:
The camera cable is fitted with a 2.5mm DC Barrel Jack connector.
The centre pin is positive.
If you need to cut off the connector the positive wire is coloured red
and the ground is the braid.
Specifications
IRIS035 Wide Angle IR Micro Dome Camera
Imaging Sensor
1/3” Colour Sony Super HAD II CCD
TV System
PAL / NTSC. Please specify when ordering as cannot be switched.
Picture Elements
PAL: 778(H) x 500(V) / NTSC: 756(H) x 542(V)
Horizontal Resolution
540 TVL
Sensitivity
0 Lux at F1.2 (Infrared ON)
Scanning System
2:1 Interlaced
Synchronization
Internal
Infra Red Spectrum
850nm
S/N Ratio
More than 48db (AGC off)
Auto Gain Correction
Auto
White Balance
Auto
Electronic Shutter
Auto
Back Light Compensation
Auto
Day / Night
Automatic switch to monochrome.
Infra Red LEDʼs
12 LEDʼs
Infra Red Range
Up to 8 meters.
Video Output
1V P~P Composite Video, 75Ohm. RCA Jack Female.
Gamma Ratio
0.45
Lens
2.3mm Fixed / 120˚ HFOV
Lens Mount
M12 x P0.5mm Thread
Power Supply
12VDC ± 3V. 2.1mm DC Jack type connector.
Power Consumption
140mA
Dimensions
48mm Diameter x 43mm straight ball or 47mm Ball at 45˚ orientation
Net Weight
100g
Ingress Protection
IP66
Operating Temperature
-20˚C to +50˚C
Loading...