IQAir CleanZone 3030 Reference

Unloading and Loading

the CleanZone 3030

0906

TABLE OF CONTENTS

UNLOADING THE IQAIR
CLEANZONE 3030

Opening the crate ………………………………………………………………………………………. . . page 3
Preparing the loading ramp ……………………………………………………………………………. .. page 3
Guide the CleanZone down the ramp …………………………………………………………………. . . page 4
Fold back the ramp ………………………………………………………………………………………. page 4

LOADING THE IQAIR
CLEANZONE 3030

Opening the crate ………………………………………………………………………………………... page 6
Preparing the loading ramp ……………………………………………………………………………... page 6
Guide the CleanZone into the ramp ……………………………………………………………………. . page 7
Foling back the ramp……………………………………………………………………………………... page 8
Closing the crate………………………………………………………………………………………….. page 8

nloading and L

U

oading the C

leanZ

one

1

UNLOADING THE IQAIR CLEANZONE 3030

Begin by removing the door of the crate.The front of the door is
marked with a red arrow that indicates the top and the outer panel
of the door. Remove the 4 screws that run horizontally down the
left and right sides of the door. Together there are a total of 8
screws – each is marked by a red circle.

1

Once the screws have been taken out, carefully remove the front
door and lean it against the side of the crate.

Note: keep door, screws,etc., for future return shipping.)

(

2

Next, the loading ramp must be put down. Remove the center
screw that secures the loading ramp to the base of the crate.
Unfold the ramp and extend it to the floor, as is shown in the next
2 photos. Open and extend the loading ramp to the floor.

3

nloading the C

U

leanZ

one

3