IPW China K KEY 051 User Manual

10
English
Hello, and thank you for having purchased the Smart&Green KEY remote control. It will allow you to control very easily your Smart & Green lights equipped with the KAMELEON TECHNOLOGY.
CONTROL YOUR LAMPS WITH KEY
TECHNICAL DATA
COMPARTMENT
ON / OFF
COLOURS
MODES
LUMINOUS INDICATOR
switches on or off the
lamp or the group
GROUP BUTTON
FRONT PANEL
SHOCK PROOF
SPLASH PROOF
100 meters maximum
without any obstacles.
REMOTE CONTROL
RANGE
IP44, the remote control
can be used or
forgotten under the rain.
Hereby, IPW Europe, declares that this KEY is in compliance with the essential require­ments and other relevant provisions of Directive 1999/5/EC.
S&G-Manuel-kameleon-KEY.indd 10 28/08/12 16:49:00
11
BATTERY
COMPARTMENT
COVER
REAR PANEL
BATTERY CHANGE
PROCEDURE
- battery service life : 3 years for standard usage.
- battery type : CR 2450
BATTERIES
Insert a tip in the notch and turn to unscrew.
CAREFULLY READ THIS GUIDE BEFORE USING THE DEVICE AND KEEP IT HANDY FOR FUTURE USE.
Use the remote control in conformity with the utilization precautions ; failure to do so will cancel any warranty.
• If not used for an extended period, remove the battery from the remote control
• Do not immerse it
• Do not expose it to fi re
• Keep it outside the reach of young children
• Use the supplied battery reference
• Do not expose it to sunlight for a long time
• Do not try to dismount the remote control > For any questions about the proper operation of this product, please contact the point of sale where you purchased the product.
The components of this remote control cannot be replaced ; if any part is damaged, the remote control must be discarded.
S&G-Manuel-kameleon-KEY.indd 11 28/08/12 16:49:00
12
THE LIGHT PART
OPERATION
Thanks to this remote control, you will be able to apply many new functions. Two specifi c functions : THE LIGHT PART and THE LAMP GROUP CONTROL PART
COLOUR CONTROL : 9 PRE-RECORDED COLOURS
COLOUR
CIRCLE
FRESH
Rotation of cold colours
PASTEL
Rotation of light colours
FASHION
Rotation of
warm colours
RAINBOW
Scrolling of
all the colours
Candle effect
fl ickering of the LEDS
LOUNGE
Rotation colour by colour
(30 sec per colour)
LUMINOUS COLOUR
INDICATOR OF
SELECTED MODE
This colour fl ashes once
before the cycle beginsne
commence
MODE
CYCLE
CANDLE EFFECT
MODE CONTROL : 6 PRE-RECORDED MODES
S&G-Manuel-kameleon-KEY.indd 12 28/08/12 16:49:01
13
- SYNCHRONIZATION : perfect coordination between the modules
- PAIRING : creation of links between the lamps.
- CONTROL BY AREA : creation of a lamp group to control the various areas.
(example : a group for the basic room, a group of the VIP corner, etc…)
- COMMUNICATION BETWEEN THE MODULES : each lamp gives the order
to the next one, without any limit in distance.
LAMP GROUP CONTROL PART
THE ADVANTAGES
SEE EACH LAMP’S STATUS
5
seconds
GROUP PART
If the lamp lights RED
it means that it is in another group.
If the lamp lights GREEN
it means that it is already grouped.
If the lamp lights BLUE
it means that it is available.
LONG PRESS (about 5 sec)
the button to return to the group mode.
=
S&G-Manuel-kameleon-KEY.indd 13 28/08/12 16:49:01
14
Once in the group mode, pressing the button briefl y links the nearest 10 blue bulbs (as long as the operation is in progress the indicator lamp fl ashes green) Redo the same operation with the lamps that you want to integrate in this group.
CREATE A LINK
If you have two remote controls, use the remote control which allowed connecting them. Same procedure as for the green link, but using the appropriate remote control.
BREAK A RED LINK
When you press one of these 2 buttons, the light that you will control goes on in RED and then goes off.
10
seconds
This operation can be performed directly on the K BULB or K BULBLITE module..
DEGROUP A COMPLETE GROUP
Your lamps go on then in BLUE
(not associated with a group)
LONG PRESS
10
seconds
and then 5 seconds
The remote
control lumi­nous indicator fl ashes green.
S&G-Manuel-kameleon-KEY.indd 14 28/08/12 16:49:02
15
EXIT THE GROUP MODE
LONG PRESS
5
seconds
You can control all your lamps using your remote control, even those locked by the Hold mode.
This function is to be enabled directly on the module
3
seconds
OR
CONTROL THE HOLD MODULES
S&G-Manuel-kameleon-KEY.indd 15 28/08/12 16:49:02
FCC WARNING
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE 1: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to oper ate th e equipment.
Loading...