Inverto IDLV-5000P User Manual

FTA Communication Technologies

IDLV-5000P

18 Duchscherstroos, L-6868 Wecker, Luxembourg
Tel: [phone] Fax: [phone]
e-mail: [e-mail] Web: www.inverto.tv

Professional MPEG-2/MPEG-4 AVC SD/HD
Integrated Receiver Decoder

V080509

IDLV-5000P

En

Professional MPEG-2/
MPEG-4 AVC SD/HD
Integrated Receiver
Decoder

User Manual

Model IDLV-5000P

2

Table of Contents

BEFORE USE THE DEVICE
INTRODUCTION
INSTALLATION

Inspection
Operating voltage
The fuses
Connecting up the device
Power on the device

NAVIGATING THE FRONT PANEL
MENU STRUCTURE AND OPERATING THE DEVICE

Inputs menu
Outputs menu
System menu

FAQ
TECHNICAL SPECIFICATIONS

Input
Output
I/O interface
General
Accessory list

3
4
5

5
5
5
5
6

6
6

7
8
12

13
14

14
14
15
15
15

En

3

1. Before Use the Device

Thank you for purchasing the IDLV-5000P series.
This User Manual is written for operators/users of the IDLV-5000P Multi-Format Professional HDTV Processor
to assist in installation and operation. Please read this user manual carefully before installation and use of the
device

FOR YOUR SAF ET Y

This equipment is provided with a protective earthing ground incorporated in the power cord. The main plug shall
only be inserted in a socket outlet provided with a protective earth contact. Any interruption of the protective
conductor, inside or outside the device, is likely to make the device dangerous.
Do not remove the covers of this equipment. Hazardous voltages are present within this equipment and may be
exposed if the covers are removed. Only Inverto trained and approved service engineers are permitted to service
this equipment.
No operator serviceable parts inside. Refer servicing to Inverto trained and approved service engineers.
For the correct and safe use of the device, it is essential that both operating and servicing personnel follow

generally accepted safety procedures in addition to the safety precautions specied in this manual.

Whenever it is likely that safety protection is impaired, the device must be made in-operative and secured
against unintended operation. The appropriate servicing authority must be informed. For example, safety is likely
to be impaired if the device fails to perform the intended measurements or shows visible damage.

WARNINGS

The mounting environment should be relatively dust free, free of excessive vibration and the ambient

•

temperature between 0C° to 40C°. Relative humidity of 20% to 80% (non-condensed) is recommended.
Avoid direct contact with water.•
Never place the equipment in direct sunlight.•
The outside of the equipment may be cleaned using a lightly dampened cloth. Do not use any cleaning •
liquids containing alcohol, methylated spirit or ammonia etc.

For continued protection against re hazard, replace line fused only with same type.•
Air intake for cooling is achieved via holes at the side of the device and the fans inside. The air ow should •
not be obstructed. Therefore, the device has to be placed on a at surface, leaving some space at the

sides of the device.

• °.

When in operation, the internal temperature should not exceed the limit of 70C

4

2. Introduction

The IDLV-5000P is full compliant with MPEG-2 (MP@ ML& MP@HL), H.264 and DVB-S2/S/-C/-T
standards. With a wide choice of input options for all transmission mediums, the IDLV-5000P provides

signicant benets and the maximum exibility for professionals who wish to migrate their operations from

MPEG-2 SD to H.264 HD.
Equipped with 2 PCMCIA slots, it also supports various CA systems such as Irdeto, Conax, Viaccess,
Cryptoworks, Mediaguard, and SECA, etc.
With TS over IP output (Optional), user could convert DVB-S2/S/-C/-T programs into IP format. It can be
monitored and set parameters easily with Ethernet management software. Moreover, it supports CVBS,
YPbPr, BNC, SDI, HDMI, AES_EBU output interface. High transmission speed and low error rate give more
valuable features to this model. With 19” rack, makes the receiver the best choice for your digital Headend
System.

MODEL LIST

Model No.

Function

10/100M Base-T TSoIP Board ● ● ● ● ● ●

DVB-C Input ● ● ● ●

DVB-T Input ● ● ● ●

DVB-S2 Input ● ● ● ●

PCMCIA slots*2 ● ● ● ●

ASI TS Input/Output ● ● ● ●

HD-SDI Output Audio Embedded ● ●

Ethernet Remote Control ● ●

CVBS Video 1*RCA & 1*BNC ● ● ● ●

Analogue Audio 2 * L+R ● ● ● ●

AES_EBU Output ● ●

YPbPr Output ● ● ● ●

HDMI Output ● ●

Where the ‘●’ sign stands is a standard option.

IDLV-5000P-10x IDLV-5000P-20x IDLV-5000P-30x IDLV-5000P-40x

-C -T 0 -C -T 0 -C -T 0 -C -T 0