Invacare IH 5126, IH5125 User Manual

User Manual

DEALER: This manual MUST be given to the user of the product.

USER:

BEFORE using this product, read this manual and save for future

reference.

Overbed Table

IH5125 Overbed Table

IH 5126 Overbed Table with Vanity

1 General

1.1 Symbols

Signal words are used in this manual and apply to hazards or unsafe practices which could result in
personal injury or property damage. See the information below for definitions of the signal words.

WARNING



Warning indicates a potentially hazardous situation which, if not avoided, could result in death or
serious injury.

IMPORTANT

!

Indicates a hazardous situation that could result in damage to property if it is not avoided.



Gives useful tips, recommendations and information for efficient, trouble-free use.

2 Safety



2.1 Weight Limitation

The weight limitation of the IH5125 and IH5126 is 40 pounds.

2.2 General Warnings



Part No 008187 1 Overbed Table

Check ALL parts for shipping damage. If shipping damage is noted, DO NOT use. Contact
carrier/dealer for further instruction.

WARNING

DO NOT USE THIS PRODUCT OR ANY AVAILABLE OPTIONAL EQUIPMENT WITHOUT
FIRST COMPLETELY READING AND UNDERSTANDING THESE INSTRUCTIONS AND
ANY ADDITIONAL INSTRUCTIONAL MATERIAL SUCH AS OWNER’S MANUALS,
SERVICE MANUALS OR INSTRUCTION SHEETS SUPPLIED WITH THIS PRODUCT OR
OPTIONAL EQUIPMENT. IF YOU ARE UNABLE TO UNDERSTAND THE WARNINGS,
CAUTIONS OR INSTRUCTIONS, CONTACT A HEALTHCARE PROFESSIONAL, DEALER
OR TECHNICAL PERSONNEL BEFORE ATTEMPTING TO USE THIS EQUIPMENT ­OTHERWISE, INJURY OR DAMAGE MAY OCCUR.

ACCESSORIES WARNING

Phillips Screws

Locknuts

Column

Assembly

Push Down with

this Hand

Packing Pin

Table Top

Top View of

Column Assembly

Base

DETAIL “A”





Invacare products are specifically designed and manufactured for use in conjunction with Invacare
accessories. Accessories designed by other manufacturers have not been tested by Invacare and
are not recommended for use with Invacare products.

WARNING

ALWAYS wear safety glasses and use extreme caution when removing the packing pin from the
column assembly of the overbed table. The column assembly is spring loaded and will extend
suddenly when the packing pin is removed. Serious injury or damage can occur.

After any adjustments, repair or service and before use, make sure that all attaching component
parts are secure.

3 Assembling the Overbed Table



1. Position the column assembly on the base.

2. Assemble the column assembly to the base with the two locknuts provided and tighten securely.

3. Using extreme caution, push down on the outer column and remove the packing pin from the

4. Allow the column assembly to expand slowly.

5. Position the table top on the column assembly and tighten securely with the six Phillips

4 Using the Overbed Table



1. Lift up on the handle on the side of the overbed table and adjust the overbed table to the desired

2. When the table is at the desired height, release the handle.

For this procedure, refer to FIGURE 1.

column assembly as shown in Detail “A”.

provided.

FIGURE 1 Assembling the Overbed Table

For this procedure, refer to FIGURE 2.

height.

®

screws

Overbed Table 2 Part No 008187