User Manual
DEALER: These instructions MUST be given to the user of the
product.
USER:
future reference.
BEFORE using this product, read this manual and save for
APP Alternating Pressure Pump
CG9701
1 General
1.1 Symbols
Signal words are used in this manual and apply to hazards or unsafe practices which could result in
personal injury or property damage. See the information below for definitions of the signal words.
WARNING
1.2 Package Contents
This model number includes one alternating pressure pump and one pad.
Warning indicates a potentially hazardous situation which, if not avoided, could result in
death or serious injury.
Gives useful tips, recommendations and information for efficient, trouble-free use.
2 Safety
WARNING
Part No 1164942 1 APP Alternating Pressure Pump
DO NOT USE THIS PRODUCT OR ANY AVAILABLE OPTIONAL EQUIPMENT
WITHOUT FIRST COMPLETELY READING AND UNDERSTANDING THESE
INSTRUCTIONS AND ANY ADDITIONAL INSTRUCTIONAL MATERIAL SUCH
AS OWNER’S MANUALS, SERVICE MANUALS OR INSTRUCTION SHEETS
SUPPLIED WITH THIS PRODUCT OR OPTIONAL EQUIPMENT. IF YOU ARE
UNABLE TO UNDERSTAND THE WARNINGS, CAUTIONS OR INSTRUCTIONS,
CONTACT A HEALTHCARE PROFESSIONAL, DEALER OR TECHNICAL
PERSONNEL BEFORE ATTEMPTING TO USE THIS EQUIPMENT - OTHERWISE,
INJURY OR DAMAGE MAY OCCUR.
ACCESSORIES WARNING
Invacare products are specifically designed and manufactured for use in conjunction with
Invacare accessories. Accessories designed by other manufacturers have not been
tested by Invacare and are not recommended for use with Invacare products.
WARNING
DO NOT use the pad near open flame or while smoking, otherwise, injury may result.
WARNING
Inspect power cord, plug, or air hoses of the Invacare APP Alternating Pressure Pump
for breaks, tears, or kinks. If damage is found, DO NOT use.
DO NOT, under any circumstances, cut or remove the round grounding prong from
any plug used with or for Invacare products. Some devices are equipped with threeprong (grounding) plugs for protection against possible shock hazards. Where a twoprong wall receptacle is encountered, it is the personal responsibility and obligation of
the customer to contact a qualified electrician and have the two-prong receptacle
replaced with a properly grounded three-prong wall receptacle in accordance with the
National Electrical Code. If you must use an extension cord, use only a three-wire
extension cord having the same or higher electrical rating as the device being connected.
Ensure that the pad is brought up to room temperature before unfolding.
DO NOT place hot objects such as heating pads on top of the pad. This may weaken
the pad material and may cause injury.
Use extreme care when handling sharp objects such as needles near the pad.
WARNING
The pad has a weight limitation of 250 lbs (114 kg).
NOTE: Check ALL parts for shipping damage. If shipping damage is noted, DO NOT use.
Contact carrier/dealer for further instruction.
3 Usage
NOTE: For this section, refer to FIGURE 1 on page 3.
3.1 Installing the APP
1. Perform one of the following:
A. Place the Invacare APP Alternating Pressure Pump on a flat surface near the bed.
B. Open the hooks on the back of the Invacare APP Alternating Pressure Pump and install on the
outside of the bed frame as shown in Detail A.
2. Place pad on top of bed mattress.
NOTE: Air chamber openings should be at bed end.
3. Install end flaps over mattress corners to secure pad.
4. Connect the other end of air hoses to the pump (Detail B).
5. Connect air hoses with fittings to the air chamber openings on the pad.
6. Install sheet over pad and bed mattress.
7. Use the pump. Refer to Using the Pump
3.2 Using/Adjusting the Pump
Using the Pump
1. Plug power cord into outlet.
2. Turn power switch to the ON position (Detail C).
APP Alternating Pressure Pump 2 Part No 1164942
on page 2.