EN-V233 – 5017 – AB Installation and Use of the Intratone Mini HF GPRS Module
Page 1 / 6
INSTALLATION AND USE OF THE
17-0104-EN MINI HF GPRS MODULE
GENERAL POINTS
This mini HF GPRS module (17-0104-EN) can be used to manage car park access via two
dry contacts operated by remote control devices or “Mobile Keys”. A free-access time
range can be set from the website www.intratone.com under the "management site" tab.
Car park access:
Two car park doors can be operated by remote controls from the Intratone range. You will
be able to manage up to 10,000 remote controls per Mini HF GPRS module.
Ex-factory, this equipment requires no configuration in order to open car park doors. Its “exfactory test” mode enables opening with any Intratone remote control, making it easier to
carry out checks during the installation phase.
After the first update, authorisation for opening will be restricted solely to remote controls
configured on the website.
Operating warranty:
- The GPRS Module is guaranteed to work at temperatures of between -20°C and
+70°C and in relative humidity that does not exceed 70%.
- The detachable casing must be fitted to protect the module against water damage.
- The top and bottom of this module are to be positioned as indicated in these
instructions.
End of life product recycling:
The GPRS Module and its accessories must not be disposed of with unsorted waste,
but must be collected for recycling as Electrical and Electronic Waste.
EN-V233 – 5017 – AB Installation and Use of the Intratone Mini HF GPRS Module
Page 2 / 6
CONTENTS
GENERAL POINTS ----------------------------------------- 1
CONTENTS --------------------------------------------------- 2
DIMENSIONS AND ASSEMBLY ------------------------ 3
WIRING -------------------------------------------------------- 3
EQUIPMENT DETAILS ------------------------------------ 4
INSTALLING AN ADDITIONAL HF ANTENNA ----- 5
POST-INSTALLATION CHECK ------------------------- 5
A) F
IRST POWER-UP
----------------------------------------------------------------------- 5
B) A
FTER UPDATE
------------------------------------------------------------------------- 5
PROGRAMMING THE EQUIPMENT AT
INTRATONE.COM ------------------------------------------ 6
TROUBLESHOOTING ----- ERREUR ! SIGNET NON
DEFINI.
COMPLIANCE CERTIFICATIONERREUR ! SIGNET
NON DEFINI.
EN-V233 – 5017 – AB Installation and Use of the Intratone Mini HF GPRS Module
Page 3 / 6
17-0104
-EN
Power supply
12-24v
Ac / dc 1a
To
Automatic device to
be controlled
Not used
5/10 twisted cable, minimum – 200 metres.
Relay: 1 A – Specifically for garage or car-park doors
DIMENSIONS AND ASSEMBLY
This module is to be attached to a flat surface. It may be installed outdoors.
WIRING
TOP
BOTTOM
TOP
BOTTOM
EN-V233 – 5017 – AB Installation and Use of the Intratone Mini HF GPRS Module
Page 4 / 6
EQUIPMENT DETAILS
The GPRS module’s LEDs indicate the GPRS
network reception quality around the installation:
“The more LEDs are lit, the better your
reception.”
Functioning will be optimal if 3 or more LEDs
are lit.
A poor reception level may make it impossible
to receive updates.
The waterproof GPRS module can be
positioned equally well outdoors or indoors.
An external GPRS antenna may be fitted if the
installation is in a metal box, for example.
GPRS
antenna connection (optional extra)
Switch to: “ON”: integrated antenna
“1”: external antenna
Time-delay switch for relays 1 and 2:
“ON”: 0.5 second pulse
“1”: time-delay defined on the management site.
Operating indicator
HF
antenna, 868 MHz
1 2 3 4 5
Two controlled relays
Power connector
EN-V233 – 5017 – AB Installation and Use of the Intratone Mini HF GPRS module
Page 5 / 6
INSTALLING AN ADDITIONAL HF ANTENNA
If the configuration does not allow you to leave the original wire or for better reception of the
signal transmitted by the remote control, you have the option of installing an HF antenna
other than the one supplied, calibrated at 868 MHz.
POST-INSTALLATION CHECK
A)
F
IRST POWER-UP
When first powered up, the Mini HF GPRS module authorises Intratone remote controls.
B)
A
FTER UPDATE
After the first update of the equipment from the site www.intratone.com under the
"management site" tab, the operational LED remains constantly lit. It will only go off when
reading a signal from a remote control.
The module will only accept authorised remote controls.
With wire
FACTORY
ASSEMBLY
With 868Mhz aerial
NOT SUPPLIED
Aer. HF
1 2
Aer. HF
1 2
Braid
Core
EN-V233 – 5017 – AB Installation and Use of the Intratone Mini HF GPRS module
Page 6 / 6
PROGRAMMING THE EQUIPMENT AT
INTRATONE.COM
The Mini HF GPRS module is programmable from the website www.intratone.com in the
“management website” tab.
The remote controls or “Mobile Keys” are also managed, exclusively, via the website.
To register your equipment you will need the contract number corresponding to it.
Then simply select Intrabox Data and complete the set-up stages.
TROUBLESHOOTING
Diagnosis Check What to do
No reception LED on the
module
Is it switched on?
- Switch the GPRS module on
and off.
If yes, indicates 0/5
reception
- Install the GPRS antenna or
move the module
Reception LED no.5 on the
module flashing
Network search in
progress.
- If this stage is not passed,
install the GPRS antenna or
move the module
The remote controls do not
open the entrance
- Check programming
- Check that the operational
LED goes out as it should when
a remote control is used
- Check the wiring of the relay(s)
The remote controls open at
random.
HF range fault
- Install a standard 868 Mhz HF
antenna.
Loading...