Page 1
Connection and fitting guide for the GPRS module
several tests in order
TOP
BOTTOM
Residential
CE standards:
- The GPRS unit complies with EC directive R&TTE 1999/5/CE: electrical safety standard
used: EN 60950(2001), EMC standard applied: EN 301 489-3(2002), radio standard applied:
EN 300 330-2(2001).
- The GPRS module complies with GSM (Radio spectrum) standards EN 301 511 and 3GPP
51.010-1.
- The GPRS module complies with EMC standards EN 301 489-1 and EN 301.489-7
Cabling:
- The cables connected to the central unit must not be placed in the vicinity of other sources of
electrical power (e.g. mains power supply).
- 3-pair twisted cables 0.5mm minimum.
Operating warranty:
- The GPRS unit is guaranteed for a temperature range between -20°C and +70°C and for relative
humidity not exceeding 70%.
- The flap on the unit must be turned down in order to protect the block from rainwater ingress.
End-of-life product recycling:
The receiver and its accessories must not be disposed of with unsorted municipal waste, but
must follow the WEEE (Waste Electrical and Electronic Equipment) collection and recycling
channel.
The LEDs on the GPRS
module display the
reception quality of the
surrounding GPRS network
signal:
"The more LEDs lit up, the
better the signal".
Optimum performance is
achieved with at least
3 LEDs lit up.
Poor reception can lead to an inability to make calls or perform
updates. We therefore advise that you conduct
to find the location with the best reception (the GPRS module can
be installed 100m away).
The GPRS module can be installed outside as well as inside.
N
EVER PUT THE UNIT INSIDE A METAL BOX
!
Connection guide for the Intratone Residential EEN-MGPRS unit
Page 1 / 2 EN-V231 – 0038 – BA
Page 2
of the EEN
-
CEN12 central unit
2 2
+ - D+ D-
Alert
Power supply
+
-
1 2 3 4 5 6 7 8 9 10 11 12
C R T
1 2 3 4 5 6 7 8 9 10 11 12
C R T
2 2
1 2 3 4 5 6 7 8 9
+ - D-
C R T D+
EEN
-
CIC12
+ - D+ D-
Alert
The GPRS module is exclusively for Data (no
voice). It does not therefore work with a call panel!
Connecting the GPRS module to an Intratone Residential central
unit:
Always connect the GPRS module to terminals 11 to 14
Connector 1 on the central unit
11 to 19 and CRT
11 13 14 15 16 17 18 19
12
+ - D+ D-
Maximum cable distance/diameter:
- 200m using 0.8mm
- 100m using 0.5mm
Connector 2 on the central unit
21 to 29 and CRT
21 23 24 25 26 27 28 29
22
GPRS unit connector
EEN-CEN-12
EEN-MGPRS
Connecting the GPRS module to an IntraCode central unit:
Connector on the IntraCode
central unit
+ - D+ D-
Maximum cable distance/diameter:
- 200m using 0.8mm
- 100m using 0.5mm.
GPRS Module connector
EEN-MGPRS
Warning: The "Alert" terminals on the GPRS module are operational only if
you connect the GPRS module to a central unit.
Only the alert terminals on the central units may be configured in this case.
Plug-in terminals on the GPRS module
1. Connect the 6 wires such that
TERMINALS POINT DOWNWARDS
2. Plug the terminals into the 6 pico-terminals on the module.
3. Turn the installation on and check the status of the LEDs
on the module.
THE SCREWS ON THE PLUG-IN
.
+ -
D+ D-
Connection guide for the Intratone Residential EEN-MGPRS unit
Page 2 / 2 EN-V231 – 0038 – BA
Loading...