Intratone EEN-CIC12 Installation Manual
FITTING AND CONNECTION OF CENTRAL
UNIT EEN-CIC12
GENERAL
This central unit (ref. EEN-CIC12) enables you to control Intratone products such as
Audio and Visio intercom panels, proximity readers, RF receivers and coded keypads.
It is also used to control the activation of relays, door opening requests by means of a
pushbutton, and the sending of e-mail alerts via the Intratone servers.
A)
C
ONNECTION TO THE INTRATONE SERVER
This central unit must be connected to the Intratone servers by means of one of the
following:
- The GPRS module (EEN-MGPRS).
- The 3G module (EEN-M3G).
- The Visio 2 panel (EEN-PIVI3GV2).
B)
R
ELAY CARD
Up to 4 relay cards (EEN-CR) can be connected to this central unit via the data bus;
these cards allow multiple doors to be controlled using just one of the connection solutions
listed above. However, relay cards will not connect to any other Intratone product – they
are simply used to control another door using a reader, keypad, mobile phone etc.
C)
H
ARDWARE CONFIGURATION
Intratone products are mainly configured from the “management web site” tab on the
www.intratone.com website. However, some settings need to be adjusted on site using the
control panel keypad and screen, or using the programming terminal (EEN-TP):
- Pushbutton settings (NO or NC).
- Setting the door opening time (from 0.2 to 99 seconds).
- Panel volume level (levels 1 to 4).
EN-V233 – 5002 – AA – Fitting of 1-Door Central Unit EEN-CIC12
Page 1 / 10
CONTENTS
GENERAL-----------------------------------------------------1
A) C
B) R
C) H
ONNECTION TO THE INTRATONE SERVER
ELAY CARD
ARDWARE CONFIGURATION
---------------------------------------------------------------------------- 1
--------------------------------------------------------- 1
----------------------------------------- 1
CONTENTS---------------------------------------------------2
SIZES AND FITTING ---------------------------------------3
CABLING------------------------------------------------------4
A) T
B) A
C) R
D) C
E) C
ERMINAL FROM BELOW
LERT INPUT CABLING
ELAY CARD CABLING
ABLING FOR DOOR FITTED WITH MAGNET LOCK
ABLING FOR DOOR FITTED WITH ELECTRIC STRIKER PLATE
--------------------------------------------------------------- 4
----------------------------------------------------------------- 4
----------------------------------------------------------------- 4
---------------------------------- 5
--------------------- 5
HARDWARE CONFIGURATION------------------------6
A) C
B) C
C) C
WEB SITE” TAB
ONFIGURATION ON THE PANEL
ONFIGURATION ON THE CENTRAL UNIT
ONFIGURATION VIA THE INTRATONE.COM WEBSITE FROM THE “MANAGEMENT
----------------------------------------------------- 6
-------------------------------------------- 7
--------------------------------------------------------------------------------- 7
POST-FITTING CHECKS ---------------------------------8
A) C
B) C
C) O
ENTRAL UNIT
OMMUNICATION CHECKS
PENING COMMAND CHECKING
LEDS------------------------------------------------------------------ 8
------------------------------------------------------------ 8
------------------------------------------------------ 8
TROUBLESHOOTING -------------------------------------9
CERTIFICATE OF CONFORMITY--------------------10
EN-V233 – 5002 – AA – Fitting of 1-Door Central Unit EEN-CIC12
Page 2 / 10
SIZES AND FITTING
without cover
with cover
EN-V233 – 5002 – AA – Fitting of 1-Door Central Unit EEN-CIC12
Page 3 / 10
Loading...