Intratone EEN-BP2R User Manual
Installation guide
blocks
Installation guide for the
Installation guideInstallation guide
for the EEN
for the for the
EEN----BP2R
EENEEN
BP2R Car park control unit
BP2RBP2R
Car park control unit
Car park control unit Car park control unit
RW
Presentation
The EEN-BP2R car park control unit enables RF
control of two car park accesses called "ENTRY"
and "EXIT".
It works with an active antenna supplied with the
EEN-KBP2R kit that receives an RF signal.
It accepts the 2 and 4-channel Intratone RF
868MHz remote controls.
When controlling the 2 accesses, the anti-passback
function is available and can be set by switches.
It can be installed on a DIN rail or wall-mounted.
Car park control unit features:
- 12 24 V AC/DC – 200 mA.
-
2 2A 24V relays.
Remote control management:
- On the internet: www.intratone.com.
- Read/write mode from the web
-
Max 2,500 remote controls
-
Opening of max 5 units per remote control.
Be sure to note the unit's
serial number. It will be
needed for managing your
remote controls from the
Internet.
Description of the unit's components
TOP
Removable memory
8 switches
Reset button
Red LED
Terminal
EC standards
The EEN-BP2R meets the R&TTE 1999/5/EC directive: electrical safety standard EN 60950 (2000)
applied, EMC standard EN 301 489-3 (2000) applied, radio standard EN 300 220-3 radio (2000) applied.
End of life product recycling:
The case and its accessories must not be disposed of with unsorted municipal waste, but must
follow the WEEE (Waste Electrical and Electronic Equipment) collection and recycling channel.
Installation and user guide for the EEN-BP2R car park control unit
Page 1 / 6 V233 – 0008 – AA
on
on
Exit
vehicle
V.P.
POWER
ANT
TOP
Cabling diagram:
Power supply
12 24 V AC/DC –
C
T
C
R
T
Active aerial
R
S
Entry
R T C R T C - + E
2 1
To detection
of entry
To detection
of exit vehicle
Voltage-free
contact
to
the
device
to control
Voltage-free
contact
to
the
device
to control
200 m max
(0.50 mm twisted pair).
BOTTOM
Instructions to follow:
Since the car park control unit is not waterproof, it must be installed either in a technical area
or inside a box.
Connecting the active antenna (supplied in the EEN-KBP2R kit) is required. Without an
active antenna, the car park control unit will not work.
The active antenna must not be enclosed in a metal case or placed behind a protective area
that uses wire netting. It must be installed as shown in the diagram ensuring that the TOPBOTTOM position is respected so that the cable is connected through the bottom of the
antenna.
To achieve satisfactory operation, there must be no metal obstacles between the active antenna
and the normal position used for operating the remote controls. It is therefore preferable to
fit the active antenna in a high location to avoid obstacles (e.g. wire netting).
If you are unable to position the active antenna where it will ensure normal operation on entry
and exit of the car park, a second antenna may be added (ref: EEN-ACOD) thus providing
one antenna for entry to and another for exit from the car park. This will be the case for solid
metal doors on the car park or where the "ENTRY" access is at some distance from the
"EXIT" access
Installation and user guide for the EEN-BP2R car park control unit
Page 2 / 6 V233 – 0008 – AA
Loading...