Intratone EEN-BOXECO HF User Manual

•

D+

+

S

V. P.

ANT

C1

T1

C2

T2

1

2

     

D+

+

W

IRING DIAGRAM

EEN-MGPRS

12/24V DC - 2AMP

(NOT SUPPLIED)

As close as possible to the

EEN-REC3

EEN-REC3

D-

-

Alert

Cabling

E

D-

-

A

Max 100m from power supply using 0.5 dia. twisted cable
Max 200m from power supply using 0.8 dia. twisted cable

See below

V.P.: Vehicle Present E: Entry - S: Exit
A: Alert ANT: Aerial - 1: Core / 2: Braid

Relay 1: C1 / T1 – Relay 2: C2 / T2

To vehicle

entry sensor

To vehicle
exit sensor

NEVER PUT THE EEN-MGPRS BLOCK OR THE RF RECEIVER IN A METAL BOX

• The LEDs on the EEN-MGPRS block display the reception quality of the nearby GPRS network signal:

"The more LEDs are ON, the better the signal". For optimum performance, ensure that you have 3 LEDs

ON.

• DO NOT FORGET TO NOTE THE EEN-MGPRS CONTRACT No. AND RELATED ACCESS POINT.

You will need this to create your equipment on www.intratone.com in the "management Website" link

EEN-BOXECO – HF

: Installation Guide

Page 1 / 2 EN-V231-0098-BA

T1 C2 T2

2 1

Woven

wire

2 1

CARPARK DOOR

2 Relays (Entry / Exit) 2A

at 24V

C T

C1

Voltage free contact to

Control a mechanism:

entry exit

C T

S1 S2 S3 Description

OFF OFF OFF No anti-passback function.

ON OFF OFF Anti-passback set to 05 minutes.

OFF ON OFF Anti-passback set to 10 minutes.

ON ON OFF Anti-passback set to 15 minutes.

OFF OFF ON Anti-passback set to 30 minutes.

ON OFF ON Anti-passback set to 45 minutes.

OFF ON ON Anti-passback set to 60 minutes.

ON ON ON Anti-passback permanently on.

S4 S5 Description

OFF OFF Loop Normally Closed (LC) or no loop.

S

WITCH DESCRIPTION

ANTENNA

With the

FACTORY FITTED

ANT.

ON ON Loop Normally Open (LO)

Switch no. 6: Always set to OFF.

Any change to this switch resets the rolling codes and anti-passback

IMPORTANT:

Installation of the varistors supplied with the central unit ensures the system's proper functioning and longevity.

1. The varistor must be fitted as close as possible to the electric lock or the magnet lock.

2. Open access times should be avoided in the case of doors fitted with electric locks!

3. The varistor is 12V.

IF YOU INSTALL SEVERAL POWER CABLES, ENSURE THAT GROUNDS (-) ARE ALL CONNECTED.

The complete pack for managing single-door access with

1 868Mhz HF Receiver (EEN-REC3) 1 (EEN-MGPRS-DATA) module.

With 868 MHz aerial

NOT SUPPLIED

ANT

Core

EEN-BOXECO – HF

: Installation Guide

Page 2 / 2 EN-V231-0098-BA