Page 1
Connection of the
ON
1
1
2
4
3
Connection of the EEN
Connection of the Connection of the
to the GSM EEN
to the GSM EEN----MEDGE unit or Visio EEN
to the GSM EENto the GSM EEN
MEDGE unit or Visio EEN----PIVI3G panel
MEDGE unit or Visio EENMEDGE unit or Visio EEN
EEN----ANTD
EENEEN
ANTD----EDGE remote aerial
ANTDANTD
EDGE remote aerial
EDGE remote aerialEDGE remote aerial
PIVI3G panel
PIVI3G panelPIVI3G panel
Overview:
The remote aerial is not required
. Install it in the case:
• Of a perturbed environment.
• Aspecific layout of surrounding buildings.
• To cancel the Faraday cage effect.
EC standards:
The remote aerial complies with GSM (Radio spectrum) standards EN 301 511 ;
3GPP 51.010-1 and with EMC standards EN 301 489-3 and EN 301 489-7.
Operating warranty
The remote aerial is guaranteed to operate within a temperature range of between -35°C and +85°C in which
relative humidity does not exceed 70%.
End of life product recycling:
The remote aerial and its accessories must not be disposed of with unsorted municipal waste,
but must follow the WEEE (Waste Electrical and Electronic Equipment) collection and
recycling channel.
Connection of the EEN-PIVI3G-V2:
Switch
Aerial terminal block
1. Trip the switch downwards.
"D
O NOT USE A SCREWDRIVER
2. Screw the aerial cable to the card's aerial terminal block.
3. Fit the cable pass through supplied in the remote aerial kit as indicated on the
diagram.
4. Thread the cable through the cable pass through.
!"
Cable pass through
for swan neck
fitting
Connection of the EEN-ANTD remote aerial
Page 1 / 2 V231 – 0086 – AB
Page 2
ON
1
1
2
3
4
5
6
•
Aerial
EEN-MEDGE connection:
Switch
" The remote aerial can only be
installed with the EEN-MEDGE
model with a round cap"
1. Prise out the protective cap.
2. Trip the switch downwards.
"D
O NOT USE A SCREWDRIVER
3. Make a hole in the cap with a screwdriver and pass the aerial cable through.
4. Screw the aerial cable to the card's aerial terminal block.
5. Refit the cap.
6. Use the cable pass through supplied in the remote aerial kit.
Aerial terminal block
!
Cable pass through for swan neck
fitting
General instructions
Fit the aerial to a metal support for optimum reception.
TOP
Install the aerial high up and outside.
• The aerial must not be installed on a ceiling but
in a vertical position.
BOTTOM
Or
• Prefer swan neck cabling.
Connection of the EEN-ANTD remote aerial
Page 2 / 2 V231 – 0086 – AB
Loading...