Page 1
INSTALLATION AND USE OF THE INTRATONE
Real-time
Coded keypad
Remote control
devices
and Mobile Key
MINI RF GPRS 17-0104 V2 MODULE
Two car park doors can be operated by remote controls from
Manage up to 10,000 remote controls or Mobile Keys per Mini
Manage time slots and open access times.
Connect up to 2 coded keypads (ref. 04-0107).
No configuration for installation tests, “Ex-Factory Test” enables
This Mini RF GPRS model does not manage alerts.
V233 – 5017 – BA Installation and Use of the Intratone Mini RF GPRS Module
the Intratone range.
RF GPRS module.
opening with any Intratone remote control device, on first update,
only remote controls configured on the website will be able to
open.
Page 1 / 8
Page 2
TABLE OF CONTENTS
WARNINGS:
The Mini RF GPRS V2 unit is equipped with special
voltage-free 1A relays for garage or carpark gates. To
control an electric or magnet lock, it will be necessary to
fit an additional 5A relay, not supplied.
Never connect directly to the 220V supply.
TABLE OF CONTENTS --------------------------------------- 2
DIMENSIONS AND FITTING --------------------------------- 3
INSTALLATION-------------------------------------------------- 4
POST-INSTALLATION CHECK ----------------------------- 5
A) FIRST POWER-UP ------------------------------------------------------------------------ 5
B) AFTER UPDATE -------------------------------------------------------------------------- 5
INSTALLING AN ADDITIONAL RF ANTENNA --------- 5
PROGRAMMING AT WWW.INTRATONE.COM -------- 6
TROUBLESHOOTING ----------------------------------------- 7
V233 – 5017 – BA Installation and Use of the Intratone Mini RF GPRS Module
Page 2 / 8
Page 3
DIMENSIONS AND FITTING
1 2 3 4 5
BOTTOM
TOP
The GPRS network
reception LEDs.
Optional functioning
with 3 or more LEDs lit.
A poor reception level
may prevent updates.
An external GPRS
antenna may be fitted if
the installation is in a
metal box, for example.
X 1
X 2
Cable Ø 0.5 mm
Ø 6
To be attached to a flat surface, indoors or outdoors.
V233 – 5017 – BA Installation and Use of the Intratone Mini RF GPRS Module
Page 3 / 8
Page 4
INSTALLATION
Time-delay switch for
relays 1 and 2:
“ON” 0.2 sec pulse not
compatible with open-
access slot
“1” Adjustment on
management site
Watertight cap for
connection of the GPRS
antenna
“ON” integrated antenna
“1” external antenna
Optional antenna
(Ref 12-0114)
Operating LED
Bar code beginning with
2078 confirms
compatibility with 12-key
Automatic
device(s) to be
controlled
Cable ø 0.5 mm minimum – 200 metres
Relays (1a max): specifically for garage or car-park doors.
To power electric or magnet locks, an additional 5a relay must be
fitted
ON
1
V233 – 5017 – BA Installation and Use of the Intratone Mini RF GPRS Module
Page 4 / 8
Page 5
POST-INSTALLATION CHECK
With wire
FACTORY
ASSEMBLY
With 868MHz antenna
NOT SUPPLIED
(Ref. 12-0113)
RF ant.
1
2
RF ant.
1
2
Braid
Core
A) FIRST POWER-UP
The RF GPRS module authorises all Intratone remote controls.
Buttons 1 and 3 on the remote controls will open relay 1.
Buttons 2 and 4 on the remote controls will open relay 2.
The keypad code 2580 will open relay 1.
B) AFTER UPDATE
After the first update of the equipment from the site intratone.com,
the operating LED will remain constantly lit.
It will only go off when reading a signal from an Intratone remote
control.
The module will only accept opening with remote controls and codes
authorised on the management site.
INSTALLING AN ADDITIONAL RF ANTENNA
For better reception of the signal transmitted by the remote control,
you can install an RF antenna, calibrated at 868MHz.
V233 – 5017 – BA Installation and Use of the Intratone Mini RF GPRS Module
Page 5 / 8
Page 6
PROGRAMMING AT WWW.INTRATONE.COM
Enter your contract no.
Residences
Codes
Update
Remote controls, Mobile Keys and keypad codes are only managed
via the site www.intratone.com.
Step 1: Go into the residence, then click:
Then .
Step 2: Enter your contract no. and name your access point:
N.B. If nothing on relay 2, cancel with the X .
To recreate access no. 2:
Go to your access point, then “Set up central unit”
Click on the phrase “Click here to activate relay no. 2”
Now simply name this new access point.
Step 3: Creating your Remote Controls and Mobile Keys.
>
Step 4: Update your residence.
N.B. With a keypad (ref. 04-0107), you will be able to create keypad
V233 – 5017 – BA Installation and Use of the Intratone Mini RF GPRS Module
>
codes in the tab
Page 6 / 8
Page 7
TROUBLESHOOTING
Problem
What to do
No reception LED on
the module
If it is switched on, switch the GPRS module
off and on.
If the reception level remains at 0/5, move
the module or install a GPRS antenna.
Reception LED no. 5
on the module is
flashing
- If LED no. 5 keeps flashing for more than
2 minutes, move the module or install the
remote GPRS antenna (Ref. 12-0114)
The remote controls
do not open the
access point
- Check programming
- Check that the operating LED goes out as
it should when an Intratone remote control
is used
- Check the wiring of the relay(s)
The remote controls
open at random.
- Install an 868MHz RF antenna (Ref 12-
0113).
Operating guarantees:
- The GPRS module is guaranteed within a temperature range of -20°C
and +70°C and at a relative humidity level not exceeding 70%.
- The detachable casing must be fitted to protect the module against
water damage.
- The top and bottom of this module are to be positioned as indicated in
these instructions.
- Never connect directly to the 220V supply (out of guarantee).
End-of-life recycling of the product:
- The GPRS module and its accessories must not be disposed of with
unsorted waste, but must be collected for recycling as Electrical and
Electronic Waste.
V233 – 5017 – BA Installation and Use of the Intratone Mini RF GPRS Module
Page 7 / 8
Page 8
V233 – 5017 – BA Installation and Use of the Intratone Mini RF GPRS Module
Page 8 / 8
Loading...