Intex Recreation HT30220 User Manual

114

(114) ELECTRIC POOL HEATER ENGLISH 7.5” X 10.5” PANTONE 295U 12/18/2006

OOWWNNEERR’’SS MMAANNUUAALL

Electric Pool Heater

Model HT30220 230 V~, 50 Hz 3000 W, IP25 Max. Water Temperature 35oC

IMPORTANT

SAFETY RULES

Read, Understand, and Follow all

Instructions Carefully before

Installing and using this Product.

Don’t forget to try these other fine Intex products: Pools, Pool Accessories, Inflatable Pools and In-Home Toys, Airbeds and Boats available at fine retailers or visit our website.

For illustrative purposes only.

114**-A1-0712

Printed in China/Imprimé en Chine/Impreso en China/Gedruckt in China.

®™ Trademarks used in some countries of the world under license from/®™ Marques utilisées dans certains pays sous licence de/Marcas registradas utilizadas en algunos países del mundo bajo licencia de/Warenzeichen verwendet in einigen Ländern der Welt in Lizenz von/Intex Marketing Ltd. to/à/a/an Intex Development Co. Ltd., 8th Floor, Dah Sing

Financial Centre, 108 Gloucester Road, Wanchai, Hong Kong & Intex Recreation Corp., P.O. Box 1440, Long Beach, CA 90801 • Distributed in the European Union by/Distribué dans l’Union Européenne par/Distribuido en la unión Europea por/Vertrieb in der Europäischen Union durch/Intex Trading B.V., P.O. Box nr. 1075 – 4700 BB Roosendaal – The Netherlands

114

SAVE THESE INSTRUCTIONS

Page 2

(114) ELECTRIC POOL HEATER ENGLISH 7.5” X 10.5” PANTONE 295U 12/18/2006

TTAABBLLEE OOFF CCOONNTTEENNTTSS

Warnings................................................................................ 3

Parts List & Reference.......................................................... 4

Set Up Instructions............................................................... 5-8

Operating Time Table............................................................ 8

Electric Pool Heater

Stationary Mounting Option................................................. 9

Pool Care and Chemicals..................................................... 10

Long Term Storage................................................................ 10

Troubleshooting Guide......................................................... 11

Common Pool Problems....................................................... 12

General Aquatic Safety......................................................... 13

Limited Warranty................................................................... 14

Intex Service Center Locations............................................ 15

Filter Pump Flow Rate Requirement:

500 - 2500 gallons/hour (1893 - 9464 liters/hour)

Working Water Temperature:

63 degrees Fahrenheit (17 degrees Celsius) to 95 degrees

Fahrenheit (35 degrees Celsius)

Suitable to be used for pool with water capacity:

below 4500 gallons (17033 liters)

Rectangular Length x Width x Average Depth x 7.5 Length x Width x Average Depth

Circular Length x Width x Average Depth x 5.9 Length x Width x Average Depth x 0.79

Oval Length x Width x Average Depth x 6.0 Length x Width x Average Depth x 0.80

Types of Pool

Gallons

(pool size in feet)

Cubic Meters

(pool size in meters)

114

SAVE THESE INSTRUCTIONS

Page 3

(114) ELECTRIC POOL HEATER ENGLISH 7.5” X 10.5” PANTONE 295U 12/18/2006

SSAAFFEETTYY RRUULLEESS

WARNING

• To reduce the risk of injury, do not permit children to use this product. Always supervise children and those with disabilities.

• Do not bury electrical cord. Locate cord where it will not be damaged by lawn mowers, hedge trimmers, and other equipment.

• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

• To reduce the risk of electric shock, do not use extension cords, timers, plug adaptors or converter plugs to connect unit to electric supply; provide a properly located outlet.

• Assembly and disassembly by adults only.

• Do not attempt to plug in or unplug this product while standing in water or when your hands are wet.

• Position this product away from pool to prevent a child from climbing on product to access the pool.

• Children must stay away from this product and electrical cord(s).

• Do not operate this product when pool is occupied.

• Always unplug this product from the electrical outlet before removing, cleaning, servicing or making any adjustment to the product.

• Always located the pool heater below the hose connection level during use.

• Place the product in an upright position.

• Do not switch on if there is no water in the product.

• Do not switch on if there is a possibility that the water in the product is frozen.

• For above ground pool use only. Do not use for spa.

• Do not lift up the product by holding the power cord.

• Have a qualified electrician install a property grounded receptacle outlet, acceptable for outdoor use and protected from snow and rain, immediately adjacent to the location where the heater will be used.

• Route the supply cord and locate the heater so as to be protected from damage by livestock.

• Do not use extension cords.

• Inspect cord before using.

• Unplug heater at receptacle outlet when not in use or before removing from pool.

• Store heater indoors after winter season.

• Spray head shall not be used.

• The outlet must not be connected to any tap or fitting other than those specified.

• Keep this product more than 2m away from the pool (For France only).

• Keep the plug of this product more than 3.5m away from the pool.

• The plug shall be accessible after product installed.

• This product is intended to be used only for the purposes described in the manual!

FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN PROPERTY DAMAGE, ELECTRIC SHOCK, ENTANGLEMENT OR OTHER SERIOUS INJURY OR DEATH.

These product warnings, instructions and safety rules provided with the product represent some common risks of water recreation devices and do not cover all instances of risk and danger. Please use common sense and good judgement when enjoying any water activity.

IMPORTANT SAFETY RULES

Read, Understand and Follow All Instructions Carefully Before Installing and Using this Product.

READ AND FOLLOW ALL INSTRUCTIONS

114

SAVE THESE INSTRUCTIONS

Page 4

(114) ELECTRIC POOL HEATER ENGLISH 7.5” X 10.5” PANTONE 295U 12/18/2006

PPAARRTTSS LLIISSTT && RREEFFEERREENNCCEE

PARTS LIST

PARTS REFERENCE

Before installing your product, please take a few minutes to check the contents

and become familiar with all the parts.

REF. NO.

DESCRIPTION

QTY.

SPARE PART NO.

HOSE

HOSE CLAMP

HOSE SEAL

10116

10122

10134

When ordering parts, be sure to quote the model number and part numbers.

NOTE: Drawings for illustration purpose only. May not reflect actual product size. Not to

scale.

114

SAVE THESE INSTRUCTIONS

Page 5

(114) ELECTRIC POOL HEATER ENGLISH 7.5” X 10.5” PANTONE 295U 12/18/2006

SSEETT--UUPP IINNSSTTRRUUCCTTIIOONNSS

SET UP INSTRUCTIONS

IMPORTANT: The electrical pool heater must be installed as the last piece of pool equipment before the saltwater pool or chlorine generator system in the water return line to the pool

1. Assemble the above-ground-pool (AGP) and its filter pump per

installation instructions.

2. Remove the electrical pool heater and it’s accessories from the

packaging.

3. Place the electrical pool heater in line after the filter pump.

4. Connect the hose (1) to the electrical pool heater inlet. (See following

page)

5. If your above-ground-pool is filled up with water, unscrew the strainer

grids from the strainer connectors and insert the black hat-like plugs into the strainer connectors before electrical pool heater installation. Go to step 6 directly if your pool is empty.

6. Disconnect the water return (to the pool) hose from the filter pump

connection, and connect it to the upper electric pool heater connection with a hose clamp.

7. Connect the second hose to the lower electric pool heater connection and to the lower pump connection. Make sure all the hose clamps (2) are tight.

8. If applicable, return strainer grids to strainer connectors inside pool after removing black hat-like plugs that prevented water from flowing out of the pool.

9. Connect the electric pool heater to the power outlet. Test RCD as shown on following page.

10. Turn pump on. Check water is flowing through the heater. Then turn heater on.

IMPORTANT

If the heater is not in an upright position a safety switch will automatically turn the heater off. Be sure the heater is always in an upright position while the cord is connected to the power outlet.

+ 10 hidden pages