Intex SEAHAWK 2 BOAT SET User Manual

(98PO) “NMMA” BOAT W / MOTOR MOUNTING (TYPE II) ENGLISH 7.5”X10.3” 08/12/2013

INTEX® OWNER’S MANUAL

INFLATABLE BOAT

98PO

IMPORTANT

THIS BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION.

READ IT THOROUGHLY BEFORE USING THIS PRODUCT AND

KEEP IT FOR FUTURE REFERENCE.

IMPORTANT!

DO NOT RETURN PRODUCT TO STORE

To purchase parts and accessories or to obtain non-technical assistance, Visit

www.intexcorp.com

For technical assistance and missing parts call us toll-free (for U.S. and Canadian Residents)

1-800-234-6839

Monday through Friday, 8:30am to 5:00pm Pacific Time

Due to a policy of continuous product improvement, Intex reserves the right to change specifications and

appearance, which may result in updates to the instruction manual without notice.

©2013 Intex Marketing Ltd. - Intex Development Co. Ltd. - Intex Trading Ltd. - Intex Recreation Corp. All rights reserved/Tous droits réservés/Todos los derechos reservados/Alle Rechte vorbehalten. Printed in China/Imprimé en Chine/Impreso en China/Gedruckt in China.

®™ Trademarks used in some countries of the world under license from/®™ Marques utilisées dans certains pays sous licence de/Marcas registradas utilizadas en algunos países del mundo bajo licencia de/Warenzeichen verwendet in einigen Ländern der Welt in Lizenz von/Intex Marketing Ltd. to/à/a/an Intex Trading Ltd., Intex Development Co. Ltd., G.P.O

Box 28829, Hong Kong & Intex Recreation Corp., P.O. Box 1440, Long Beach, CA 90801 • Distributed in the European Union by/Distribué dans l’Union Européenne par/Distribuido en la unión Europea por/Vertrieb in der Europäischen Union

durch/Intex Trading B.V., Venneveld 9, 4705 RR Roosendaal – The Netherlands www.intexcorp.com

SAVE THESE INSTRUCTIONS

Page 1

098-*PO-R1-1408

(98PO) “NMMA” BOAT W / MOTOR MOUNTING (TYPE II) ENGLISH 7.5”X10.3” 08/12/2013

TABLE OF CONTENTS

INTRODUCTION.............................................................................................................................3

MANUFACTURE’S CERTIFICATION..............................................................................................3

WARNING.......................................................................................................................................3

MANUFACTURER’S RECOMMENDATION....................................................................................4

DESCRIPTION.............................................................................................................................5-7

INFLATING INSTRUCTIONS..........................................................................................................8

HOW TO USE BOSTON VALVE.....................................................................................................8

FISHING ROD HOLDER USE........................................................................................................9

SEAT INSTALLATION.....................................................................................................................9

OAR ASSEMBLY........................................................................................................................9-10

98PO

GRAB LINE INSTALLATION.........................................................................................................11

ACCESSORY LINE INSTALLATION.............................................................................................11

SAFETY AND OPERATION INSTRUCTIONS.........................................................................11-12

CARE AND MAINTENANCE.........................................................................................................12

DISASSEMBLY AND STORAGE...................................................................................................13

TROUBLESHOOTING..................................................................................................................13

REPAIRS.......................................................................................................................................13

SAVE THESE INSTRUCTIONS

Page 2

(98PO) “NMMA” BOAT W / MOTOR MOUNTING (TYPE II) ENGLISH 7.5”X10.3” 08/12/2013

98PO

Introduction

This manual has been compiled to help you to operate your craft with safety and pleasure. It contains details of the craft, the equipment supplied or fitted, its systems, and information on its operation and maintenance. Please read it carefully, and familiarize yourself with the craft before using it.

If this is your first craft, or you are changing to a type of craft you are not familiar with, for your own comfort and safety, please ensure that you obtain handling and operating experience before assuming command of the craft. Your dealer or national sailing federation or yacht club will be pleased to advise you of local sea school, or competent instructors.

PLEASE KEEP THIS MANUAL IN A SECURE PLACE, AND HAND IT OVER TO THE NEW OWNER WHEN YOU SELL THE CRAFT. RECORD THE "HULL IDENTIFICATION NUMBER" (HIN) WHICH IS PRINTED ON THE BOAT'S HULL IN THE FOLLOWING BOX:

HIN:

________________________

Manufacture’s Certification

For boats between and including 2.5 and 24 meters hull length, a CE (FOR EUROPE ONLY) mark means that the boat complies with European Directives for Recreational Craft 94/25/EC and 2003/44/EC as published by the International Organization for Standardization, ISO 6185.

NMMA (FOR USA ONLY) certification means that the boat, sold in the United States, has been judged by the National Marine Manufacture’s Association to be in compliance with the U.S. Coast Guard Regulations and American Boat and Yacht Council (ABYC) standards and recommended practices.

WARNING

• This is not a life saving device. Use only under competent supervision. Never allow diving into this product. Never leave in or near the water when not in use. Never tow from any vehicle.

• Read the complete Owner’s Manual before use and store this Manual in a safe place for future reference.

• Follow all the Safety and Operating Instructions on this Manual.

• Inflatable boats capable of taking an outboard motor. Motors are not to exceed the maximum

recommended power and weight.

• Read the instruction of outboard motor for correct installation and operation.

• Never navigate alone. Beware of offshore winds and currents.

• Do not exceed the maximum recommended capacities. Overloading violates regulations.

• Everyone on board must wear a Personal Floatation Device (PFD).

Use caution when stepping or climbing aboard the boat. Step into the center of the boat for

•

maximum stability.

• Distribute the weight of passengers, gear, tackle box, and accessories so that the boat sits level fore (front) to aft (back) and side-to-side.

• Do not use your boat if you suspect a puncture or leak.

• Adults should inflate the chambers in numbered sequence.

• Not for white water rafting or any other extreme sports activities.

• Follow these rules to avoid drowning, paralysis or other serious injuries.

SAVE THESE INSTRUCTIONS

Page 3

(98PO) “NMMA” BOAT W / MOTOR MOUNTING (TYPE II) ENGLISH 7.5”X10.3” 08/12/2013

Manufacturer’s Recommendation

The total number of persons, motor power and total weight shall not exceed the limits printed on the boat. Please refer to the boat's hull label for the actual values of your boat. See Table A.

TABLE A

MODEL TYPE

CHALLENGER 3a

SEAHAWK 2

SEAHAWK 3

SEAHAWK 4

EXCURSION 2

EXCURSION 3

EXCURSION 4

EXCURSION 5

MARINER 3

MARINER 4

68369

68346

68349

68350

68318

68319

68324

68325

68373

68376

2.95

2.36

2.95

3.51

2.41

2.62

3.15

3.66

2.97

3.28

m HP

1.37

1.14

1.37

1.45

1.57

1.65

1.68

1.27

1.45

1.5

Lbs

660

520

790

1050

440

790

1050

1300

790

1050

+ +

300

240

360

480

200

360

480

600

360

480

bar (psi)

0.035 (0.5)

0.069 (1.00)

0.080 (1.14)

Unladen Craft Weight

BOAT LABEL FORMAT

ISO 6185 PART 1 TYPE

Do not overinflate or use high pressure air compressor to inflate. Adults should inflate the chambers with cold air in numbered sequence. Use the enclosed ruler to check while inflating.

Nicht zu stark aufblasen und keinen Kompressor zum Aufblasen verwenden. Erwachsene sollten die kammern in der angegebenen Reihenfolge mit kalter luft aufblasen. Verwenden Sie das belgefügte Meßgerät um die korrekte Füllung zu überprüfen.

Ne pas surgonfler. Ne pas utiliser de compresseur pour le gonflage. Le gonflage doit être effectué par un adulte avec de l'air froid en suivant les étapes suivantes. Utiliser la règle jointe pour ajuster le gonglage de la chambre à air principale.

CATEGORY D

BY INTEX

MAXIMUM CAPACITIES MAXIMUM-KAPAZITÃT CAPACITÉS MAXIMUM

MAXIMUM POWER MAXIMUM MOTORKRAFT PUISSANCE MAXIMUM

PERSONS PERSONEN PERSONNES

MANUFACTURER HERSTELLER FABRICANT

MODEL MODELL MODÈLE

RECOMMENDED WORKING PRESSURE FOR EACH CHAMBER

EMPFOHLENE ARBEITENDE DRUCK FÜR JEDE LUFTKAMMER

RECOMMANDÉ FONCTIONNEL PRESSION POUR CHAQUE CHAMBRE À AIR

____________________

+ + = ___ Kg ( ___ Lbs)

___kW (___HP) / ___Kg (___Lbs)

= ___

CHINA

= ___ bar ( ___ psi)

MAXIMUM CAPACITIES / CAPACITÉS MAXIMALES

PERSONS OR ____kg (___Lbs) / PERSONNES OU ___KG

____ POUNDS, PERSONS, GEAR / ___KG, PERSONNES ET ÉQUIPEMENT

DESIGN COMPLIANCE WITH NMMA REQUIREMENTS BELOW IS VERIFIED. / LA CONFORMITÉ DU DESIGN AVEC LES EXIGENCES NMMA EST VÉRIFIÉE.

MFGR. RESPONSIBLE FOR PRODUCTION CONTROL / MFGR. RESPONSABLE DU CONTRÔLE PRODUCTION

LOAD CAPACITY (BASIC FLOTATION)

CAPACITÉ DE CHARGE (FLOTTAISON DE BASE)

Certified by the National Marine Manufacturers Association using ABYC standards

Certifié par la National Marine Manufacturers Association en utilisant les normes ABYC

___Kg ( ___ Lbs) MAX.

98PO

CN- XEE

ISO-6185 boat design category (certain models). CE mark (for Europe only) (certain models).

Maximum motor power and motor weight. Manufacturer’s recommended maximum load capacity.

Maximum person’s capacity. Manufacturer’s name and country of origin.

Model name and number. Manufacturer’s recommended working pressure.

NMMA (for USA only) certification means that the boat, sold in the United States, has been judged by the

4 6

National Marine Manufacture’s Association to be in compliance with the U.S. Coast Guard Regulations and American Boat and Yacht Council (ABYC) standards and recommended practices.

Hull identification number (HIN).

SAVE THESE INSTRUCTIONS

Page 4

+ 9 hidden pages