(254PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 10/18/2013
IMPORTANT
SAFETY RULES
Read, understand, and follow
all instructions carefully before
installing and using this product.
PureSpa™
SSP-10-1 & SSP-H-10
110-120V~, 60Hz, 12A
English
254
PO
For illustrative purposes only.
Do not forget to try these other fi ne Intex products: pools, pool
accessories, in-home toys, airbeds and boats available at fi ne
retailers or visit our website.
Due to a policy of continuous product improvement, Intex reserves
the right to change specifi cations and appearance, which may
result in updates to the instruction manual, without notice.
OWNER’S MANUAL
To purchase parts and accessories or to obtain non-technical assistance, visit
DO NOT RETURN PRODUCT TO STORE
For technical assistance and missing parts call us toll-free (for U.S. and Canadian Residents):
IMPORTANT!
www.intexcorp.com
1-800-234-6839
Monday through Friday, 8:30am to 5:00pm Pacifi c Time
254-*PO-R0-1410
(254PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 10/18/2013
(254PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 10/18/2013
English
254
PO
IMPORTANT SAFETY INSTRUCTIONS
When installing and using this electrical equipment, basic safety precautions should always be followed, including the following.
READ AND FOLLOW ALL INSTRUCTIONS
DANGER
• Risk of Accidental Drowning. Extreme caution must be exercised to prevent unauthorized access by
children. To avoid accidents, ensure that children cannot use this spa unless they are supervised at all
times.
• Risk of drowning. Inspect the spa cover regularly for leaks, premature wear and tear, damage, or signs of
deterioration. Never use a worn or damaged cover: it will not provide the level of protection required to
prevent unsupervised access to the spa by a child.
• Risk of injury. Replace damaged cord immediately. Do not bury cord. Connect to a grounded, grounding
type receptacle only.
• Risk of Injury. The suction fi ttings in this spa are sized to match the specifi c water fl ow created by the
pump. Should the need arise to replace the suction fi ttings or the pump, be sure that the fl ow rates are
compatible.
• To reduce the risk of injury, do not remove the suction fi ttings. Never operate a spa or hot tub if the suction fi ttings are loose, broken, damaged, cracked or missing. Replace immediately. Never replace a suction fi tting with one rated less than the fl ow rate marked on the original suction fi tting.
• To reduce the risk of drowning from hair and body entrapment, install a suction fi tting(s) with a marked fl ow
rate that equals or exceeds the fl ow rate marked on the equipment assembly.
• Make sure the power outlet current and voltage is suitable for the electrical equipment.
• Risk of Electric Shock. Install at least 5 feet (1.5 m) from all metal surfaces. As an alternative, a spa may
be installed within 5 feet (1.5 m) of metal surfaces if each metal surface is permanently connected by a
minimum 8 AWG (8.4 mm
provided for this purpose.
• Risk of Electric Shock. Do not permit any electric appliance, such as a light, telephone, radio, or television,
within 5 feet (1.5 m) of a spa or hot tub.
• Risk of Electric Shock. Do not use the spa when it is raining, thundering or lightning.
2
) solid copper conductor to the wire connector on the terminal box that is
WARNING
• A wire connector is provided on this unit to connect a minimum 8 AWG (8.4 mm
between this unit and any metal equipment, metal enclosures of electrical equipment, metal water pipe, or
conduit within 5 feet (1.5 m) of the unit.
• To reduce the risk of drowning and injury, do not permit children to use this product unless they are closely
supervised at all times.
• To reduce the risk of child drowning, attach and lock spa cover after each use.
• To reduce the risk of drowning and injury:
a) Never use the spa alone or allow others to use the spa alone.
b) Before entering a spa or hot tub, the user should measure the water temperature with an accurate
thermometer since the tolerance of water temperature-regulating devices varies.
c) The water in a spa should never exceed 104°F (40°C). Water temperatures between 100°F (38°C) and
104°F (40°C) are considered safe for a healthy adult. Lower water temperatures are recommended for
young children and when spa use exceeds 10 minutes.
d) Pregnant and possible pregnant women should consult a physician before using a spa or hot tub.
e) Since excessive water temperatures have a high potential for causing fetal damage during the early months
of pregnancy, pregnant or possibly pregnant women should limit spa water temperatures to 100°F (38°C) .
Do not stay in spa for longer than 10 minutes.
f) The use of alcohol, drugs, or medication before or during spa use may lead to unconsciousness with the
possibility of drowning.
g) Obese persons and persons with a history of heart disease, low or high blood pressure, circulatory system
problems, or diabetes should consult a physician before using a spa.
h) Persons using medication should consult a physician before using a spa since some medication may
induce drowsiness while other medication may affect heart rate, blood pressure, and circulation.
i) Check with a doctor before use if pregnant, diabetic, in poor health, or under medical care.
2
) solid copper conductor
S AVE THESE INSTRUCTIONS
Page 3
(254PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 10/18/2013
English
254
PO
WARNING
j) Exit immediately if uncomfortable, dizzy, or sleepy. Spa heat can cause hyperthermia and unconsciousness.
The use of alcohol, drugs, or medication can greatly increase the risk of fatal hyperthermia. The causes,
symptoms, and effects of hyperthermia may be described as follows:
Hyperthermia occurs when the internal temperature of the body reaches a level several degrees above the
normal body temperature of 98.6°F (37°C). The symptoms of hyperthermia include an increase in the
internal temperature of the body, dizziness, lethargy, drowsiness, and fainting. The effects of hyperthermia
include failure to perceive heat; failure to recognize the need to exit spa or hot tub; unawareness of
impending hazard; fetal damage in pregnant women; physical inability to exit the spa or hot tub; and
unconsciousness resulting in the danger of drowning.
• People with infectious diseases should not use a spa or hot tub.
• To avoid injury exercise care when entering or existing the spa or hot tub.
• Always add chemicals to water, never add water to chemicals. Adding water to chemicals may cause
strong fumes or violent reactions and hazardous chemical spray.
• Never jump or dive into a spa or any shallow body of water.
• Assembly and disassembly by adults only.
• Always unplug this product from the electrical outlet before removing, cleaning, servicing or making any
adjustment to the product.
• The plug must be accessible after product is installed.
• Do not bury the electrical cord. Locate the cord where it will not be damaged by lawn mowers, hedge
trimmers and other equipment.
• If the supply cord is damaged, it must be replaced by a qualifi ed electrician in order to avoid a hazard. Use
only identical replacement parts when servicing.
• To reduce the risk of electric shock, do not use extension cords, timers, plug adaptors or converter plugs to
connect unit to electrical supply; provide a properly located outlet.
• Do not attempt to plug in or unplug this product while standing in water or when your hands are wet.
• Do not leave the spa empty for extended period of time. Do not expose the spa under direct sunshine.
• Adequate drainage system must be provided around the spa to deal with overfl ow water.
• Do not allow the water in the spa to freeze. Do not turn on the spa when the water is frozen.
• Do not use the spa if damaged in delivery and/or malfunctioning in any fashion. Contact the Intex service
center for further direction.
• Never pour water with a temperature higher than 104°F (40°C) into the spa directly.
• Keep all pets away from spa to avoid any damage.
• Do not add bath oil or bath salt to the spa water.
WARNING
• This product is provided with a GFCI/RCD located at the end of the power cord. The GFCI/RCD must be
tested before each use. Do not use the spa if the GFCI/RCD does not function properly. Disconnect the
power cord until the fault has been identifi ed and corrected. Contact a qualifi ed electrician to correct the
fault. Do not bypass the GFCI/RCD. There are no serviceable parts inside the GFCI/RCD. Opening the
GFCI/RCD will void the warranty.
1. Plug the power cord into a grounded electrical socket.
2. Press the RESET button on the GFCI/RCD.
3. Turn on the spa electrical equipment.
RESET
RESET
RESET
TEST
TEST
4. Press the TEST button on the GFCI/RCD. The GFCI/RCD indicator
should turn off and the electrical equipment should shut off. If the
GFCI/RCD indicator does not turn off, and the electrical equipment
does not shut off, the GFCI/RCD is faulty. Do not use the spa.
Contact a qualifi ed electrician to correct the fault.
5. Press the RESET button on the GFCI/RCD. The indicator on
the GFCI/RCD should turn on. If the GFCI/RCD indicator does
not turn on, the GFCI/RCD is faulty. Do not use the spa.
TEST
RESET
TEST
TEST
Contact a qualifi ed electrician immediately to correct the fault.
CAUTION
• Maintain water chemistry in accordance with manufacturer’s instructions.
S AVE THESE INSTRUCTIONS
Page 4
(254PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 10/18/2013
English
PARTS
Before assembling your product, please take a few minutes to check the contents
and become familiar with all the parts.
23
17
20
19
21
14
13
22
12
24
15
254
PO
26
27
16
18
6
4
3
B
C
A
2
11
8
10
9
5
25
7
1
NOTE: Drawings for illustration purpose only. Actual product may vary. Not to scale.
S AVE THESE INSTRUCTIONS
Page 5
(254PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 10/18/2013
PARTS (continued)
Before assembling your product, please take a few minutes to check the contents
and become familiar with all the parts.
REF. NO.DESCRIPTIONQTY.
CONTROL BASE (MODEL SSP-10-1)
1
CONTROL BASE (MODEL SSP-H-10)11835
2 CONTROL BASE BACK COVER111719
3 CONTROL PANEL (INCLUDED #4 )111837
4 CONTROL PANEL BOLT 311024
5 CONTROL BASE INFLATION CAP111831
6 CONTROL PANEL BOLT WRENCH 111053
7 SPA/COVER INFLATION HOSE 111830
8 SPA CONTROL INLET/OUTLET O-RING211699
9 SPA CONTROL AIR INLET O-RING111687