Intex IT-ULCxx User Manual
USB WIRELESS LAN CARD
IT-ULC21
Thank you for purchasing this INTEX wireless network card! You must
have the wireless router or AP with the use of this wireless network card.
Different wireless router or AP may have different connections.
<Wireless USB Card>
<Cradle>
INTEX
INTEX 2
INTEX 3
INTEX 4
INTEX
INTEX
INTEX
INTEX 2
INTEX 3
<CD>
<Qiuck user guide>
INTEX
INTEX 2
INTEX 3
INTEX 4
INTEX
INTEX 2
INTEX 3
INTEX
INTEX 2
INTEX 3
INTEX
INTEX 2
INTEX 3
INTEX
INTEX
INTEX 2
INTEX 3
INTEX 2
INTEX 3
INTEX
INTEX 2
INTEX 3
INTEX
INTEX 2
INTEX 3
INTEX 4
INTEX 5
INTEX
INTEX 2
INTEX 3
INTEX 4
INTEX 5
INTEX 6
INTEX
INTEX 2
INTEX 3
INTEX 4
INTEX 5
INTEX
INTEX 2
INTEX 3
INTEX
INTEX 2
INTEX 3
INTEX
INTEX 3
INTEX
INTEX 3
FCC Statement
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not
expressly approved by the party responsible for compliance could void
the user ’s authority to operate this equipment. (Example- use only
shielded interface cables when connecting to computer or peripheral
devices).
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits
set forth for an uncontrolled environment and it also complies
with Part 15 of FCC RF Rules.
Operation is subject to the following two conditions:
1) This device may not cause interference and
2) This device must accept any interference,including interference that
may cause undesired operation of the device.
Loading...