Intertek Heat Pure 1500, ATI-HPE-XPW Owner's Manual

INFRARED ZONE HEATING SYSTEM

OWNER’S MANUAL

Model No. ATI-HP-XP

www.advancedtechinfrared.com

PLEASE SAVE THESE INSTRUCTIONS

WARNING: READ THIS OWNER’S MANUAL CAREFULLY BEFORE USE.

2

Thank you for choosing the Heat Pure 1500 Infrared Zone Heating System. This owner’s manual
will provide you with valuable information necessary for the proper care and maintenance of
your new product. Please take a few moments to thoroughly read the instructions and familiarize
yourself with all the operational aspects of your new heater.

IMPORTANT INSTRUCTIONS

When using this electric unit, basic safety precautions should always be followed to reduce the
risk of fire, electric shock, and injury to persons, including the following:

1. Read ALL instructions before using this unit.

2. CAUTION: Risk of Electric Shock. DO NOT open or try to repair the heater yourself.

3. This heater may get hot when in use. To avoid burns, DO NOT let bare skin touch hot

surfaces. If provided, use handles when moving this heater.

4. Keep combustible materials, such as furniture, pillows, bedding, paper, clothes, and

curtains at least 3 ft from the front of the heater and keep them away from the sides, top,
and rear. DO NOT place towels or other objects on the heater.

5. Extreme caution is necessary when any heater is used by or near children or the disabled,

or when the heater is left operating and unattended.

6. DO NOT operate any heater with a damaged cord or after the heater malfunctions, has

been dropped or damaged in any manner. Return heater to authorized service facility for
examination, electrical or mechanical adjustment, or repair.

7. This heater is not intended for use in bathrooms, laundry areas and similar indoor

locations. NEVER locate heater where it may fall into a bathtub or other water container.
To protect against electrical hazards, DO NOT immerse in water or other liquids.

8. DO NOT touch the control panel or plug with a wet hand.

9. DO NOT run cord under carpeting. DO NOT cover cord with throw rugs, runners, or

similar coverings. Arrange cord away from traffic area and where it will not be tripped
over.

10. DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening as

this may cause an electric shock or fire, or damage the heater.

11. To prevent a possible fire, DO NOT block the air intakes or exhaust in any manner. DO

NOT use on soft surfaces, like a bed, where openings may become blocked.

12. A heater has hot and arcing or sparking parts inside. DO NOT use in areas where

gasoline, paint, explosive and/or flammable liquids are used or stored. Keep unit away
from heated surfaces and open flames.

13. Avoid the use of an extension cord because the extension cord may overheat and cause a

risk of fire. However, if you have to use an extension cord, the cord shall be No. 16
AWG minimum size and rated not less than 1500W.

14. To avoid fire or shock hazard, plug the unit directly into a 115 V AC electrical outlet.

15. To disconnect heater, turn controls to OFF, then remove plug from outlet. Pull firmly on

the plug, DO NOT unplug by pulling on the cord.

3

16. Always unplug the unit before moving or cleaning, or whenever the heater is not in use.

Voltage Rating

120 V (60Hz)

Power Consumption

1000/1500W

Unit Size

13.1 in. (W) x 16.5 in. (D) x 16.7 in. (H)

Unit Weight

22.7 lbs

17. Use only for intended household use as described in this manual. Any other use not

recommended by the manufacturer may cause fire, electric shock, or injury to persons.
The use of attachments not recommended or sold by unauthorized dealers may cause
hazards.

18. Always use on a dry, level surface. Use on floor only.

19. DO NOT use outdoors.

20. WARNING: To reduce the risk of fire or electric shock, DO NOT use this unit with any

solid-state speed control device.

21. DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit.

Doing so will void your warranty. The inside of the unit contains no user serviceable
parts. Qualified personnel should perform all servicing only.

22. Connect to properly grounded outlets only.

23. Save these instructions.

SPECIFICATIONS

SAFETY FEATURES

Tip-Over Safety Feature

This heater is equipped with a tip-over safety feature. Once the heater is tipped over, an internal
switch will automatically shut the heater off. Once the heater is restored an upright position, the
heater will reset. To continue operation, turn on the heater using the supplied remote control or
the control panel on the heater.

Overheat Safety Feature

This heater is equipped with an overheat safety feature. If the heater’s internal components reach
a certain temperature that could cause overheating and possible fire, the heater will automatically
shut off.