Intersil Corporation HA-5142-883 Datasheet
HA-5142/883
July 1994
Features
• This Circuit is Processed in Accordance to MIL-STD883 and is Fully Conformant Under the Provisions of
Paragraph 1.2.1.
• Low Supply Current at V
= +5V. . . .(+25oC) 160µA (Max)
S
(Full) 200µA (Max)
• Wide Supply Voltage Range . . . . . .Single 3V to 30V or
Dual ±1.5 to ±15V
• High Slew Rate. . . . . . . . . . . . . . . . . . . . . . 0.8V/µs (Min)
1.5V/µs (Typ)
• High Gain . . . . . . . . . . . . . . . . . . . . . . . . . . 20kV/V (Min)
75kV/V (Typ)
• Low Noise (1kHz). . . . . . . . . . . . . . . . . . 20nV/√
Hz (Typ)
• 100% Tested at ±15V and +5V, 0V Power Supplies
• Unity Gain Stable
• Dielectric Isolation
Applications
• Portable Instruments
• Meter Amplifiers
• Telephone Headsets
• Microphone Amplifiers
• Instrumentation
• For Further Design Ideas See Application Note AN544
Dual, Ultra Low Power Operational Amplifier
Description
The HA-5142/883 dual, ultra-low power operational amplifier
provides AC and DC performance characteristics similar to,
or better than most general purpose amplifiers while only
drawing 1/30 of the supply current of most general purpose
amplifiers. This amplifier is well suited to applications which
require low power dissipation and good electrical characteristics.
The HA-5142/883 provides accurate signal processing by
virtue of their low input offset voltage (6mV), low input bias
current (100nA), high open loop gain (20kV/V) and low noise
(20nV/√
slew rate and a 24kHz bandwidth make the HA-5142/883
ideal for use in low power instrumentation, audio amplifier
and active filter designs.
Ordering Information
Hz). These characteristics coupled with a 1.5V/µs
PART
NUMBER
HA7-5142/883 -55oC to +125oC 8 Lead CerDIP
HA2-5142/883 -55oC to +125oC 8 Pin Can
HA4-5142/883 -55oC to +125oC 20 Lead Ceramic LCC
TEMPERATURE
RANGE PACKAGE
Pinouts
HA-5142/883
(CERDIP)
TOP VIEW
1
OUT1
2
-IN1
+IN1
V-
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
http://www.intersil.com or 407-727-9207
1
-
+
3
4
8
V+
7
OUT2
6
2
-IN2
-
+
5
+IN2
| Copyright © Intersil Corporation 1999
NC
-IN1
NC
+IN1
NC
HA-5142/883
(CLCC)
TOP VIEW
OUT 1
NC
NC
3212019
4
5
6
7
8
1
+
-
9101112
V-
NC
NC
3-149
V+
NC
18
NC
17
2
+
-
+IN2
OUT2
16
NC
-IN2
15
NC
14
13
NC
OUT1
-IN1
+IN1
HA-5142/883
(METAL CAN)
TOP VIEW
V+
1
12
+-+
2
3
V-
Spec Number
8
7
OUT2
6
-IN2
+IN2
5
4
511035-883
File Number 3732.1
Specifications HA-5142/883
Absolute Maximum Ratings Thermal Information
Voltage Between V+ and V- Terminals . . . . . . . . . . . . . . . . . . . . 35V
Differential Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7V
Voltage at Either Input Terminal . . . . . . . . . . . . . . . . . . . . . . V+ to V-
Output Current . . . . . . . . . . . . . . . . . . . .Full Short Circuit Protection
Output Current Duration. . . . . . . . . . . . . . . . . . . . . . . . . . . Indefinite
One Amplifier Shorted to Ground
Junction Temperature (TJ) . . . . . . . . . . . . . . . . . . . . . . . . . . +175oC
Storage Temperature Range . . . . . . . . . . . . . . . . . -65oC to +150oC
ESD Rating. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . <2000V
Lead Temperature (Soldering 10s). . . . . . . . . . . . . . . . . . . . +300oC
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation
of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
Operating Conditions
Operating Temperature Range. . . . . . . . . . . . . . . . -55oC to +125oC
Operating Supply Voltage. . . . . . . . . . . . . . . . . . . . . . . . ±1.5V to ±15V
or 3V to 30V
TABLE 1. DC ELECTRICAL PERFORMANCE CHARACTERISTICS
Device Tested at: R
Subscript 1 Refers to Supply Voltages (V±) = ±15V, Subscript 2 Refers to V+ = 5.0, V- = 0V
SOURCE
= 100Ω, R
LOAD
= 500kΩ, V
= 0V, Unless Otherwise Specified.
OUT
Thermal Resistance θ
JA
CerDIP Package . . . . . . . . . . . . . . . . . . . 115oC/W 28oC/W
Ceramic LCC Package . . . . . . . . . . . . . . 65oC/W 15oC/W
Metal Can Package. . . . . . . . . . . . . . . . . 155oC/W 67oC/W
Package Power Dissipation Limit at +75oC for TJ≤ +175oC
CerDIP Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .870mW
Ceramic LCC Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.54W
Metal Can Package. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 645mW
Package Power Dissipation Derating Factor Above +75oC
CerDIP Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8.7mW/oC
Ceramic LCC Package . . . . . . . . . . . . . . . . . . . . . . . .15.4mW/oC
Metal Can Package. . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.5mW/oC
V
≤ 1/2 (V+ - V-)
INCM
RL≥ 50kΩ
θ
JC
PARAMETERS SYMBOL CONDITIONS
Input Offset Voltage V
Input Bias Current +I
IO1
V
IO2
VCM = 0V 1 +25oC-66µV
VCM = 0V,
V
= 1.4V
OUT
VCM = 0V,
B1
+RS = 10kΩ,
-RS = 100Ω
-I
VCM = 0V,
B1
+RS = 100Ω,
-RS = 10kΩ
+I
B2
VCM = 0V , V
+RS = 10kΩ,
-RS = 100Ω
-I
B2
VCM = 0V , V
+RS = 100Ω,
-RS = 10kΩ
Input Offset Current I
IO1
VCM = 0V,
+RS = 10kΩ,
-RS = 10kΩ
I
IO2
VCM = 0V, V
+RS = 10kΩ,
-RS = 10kΩ
Common Mode
Range
+CMR1V+ = +5V,
V- = -25V
-CMR1V+ = +25V,
V- = -5V
+CMR2V+ = +5V to +2V,
V- = 0V to -3V,
V
= 1.4V to -1.6V
OUT
OUT
OUT
OUT
= 1.4V ,
= 1.4V ,
= 1.4V
GROUP A
SUBGROUPS TEMPERATURE
LIMITS
UNITSMIN MAX
2, 3 +125oC, -55oC-8 8µV
1 +25oC-66µV
2, 3 +125oC, -55oC-8 8µV
1 +25oC -100 100 nA
2, 3 +125oC, -55oC -125 125 nA
1 +25oC -100 100 nA
2, 3 +125oC, -55oC -125 125 nA
1 +25oC -100 100 nA
2, 3 +125oC, -55oC -125 125 nA
1 +25oC -100 100 nA
2, 3 +125oC, -55oC -125 125 nA
1 +25oC -10 10 nA
2, 3 +125oC, -55oC -20 20 nA
1 +25oC -10 10 nA
2, 3 +125oC, -55oC -20 20 nA
1 +25oC10-V
2, 3 +125oC, -55oC10 - V
1 +25oC - -10 V
2, 3 +125oC, -55oC - -10 V
1 +25oC3-V
2, 3 +125oC, -55oC3 - V
3-150
Spec Number 511035-883
Loading...