Intersil Corporation HA4-5102-883, HA2-5102-883, HA-5102-883 Datasheet
July 1994
HA-5102/883
Dual, Low Noise, High Performance
Operational Amplifier
Features
• This Circuit is Processed in Accordance to MIL-STD883 and is Fully Conformant Under the Provisions of
Paragraph 1.2.1.
• Low Input Noise Voltage Density at 1kHz. . 6nV/√
4.3nV/√
Hz (Max)
Hz (Typ)
• High Slew Rate. . . . . . . . . . . . . . . . . . . . . . . 1V/µs (Min)
3V/µs (Typ)
• Unity Gain Bandwidth . . . . . . . . . . . . . . . . . 8MHz (Typ)
• High Open Loop Gain (Full Temp) . . . . . 100kV/V (Min)
250kV/V (Typ)
• High CMRR, PSRR (Full Temp). . . . . . . . . . . 86dB (Min)
100dB (Typ)
o
• Low Offset Voltage Drift . . . . . . . . . . . . . . 3µV/
C (Typ)
• No Crossover Distortion
• Standard Dual Pinout
Applications
• High Quality Audio Preamplifiers
• High Q Active Filters
• Low Noise Function Generators
• Low Distortion Oscillators
• Low Noise Comparators
Description
Low noise and high performance are key words describing
the unity gain stable HA-5102/883. This general purpose
dual amplifier offers an array of dynamic specifications
including 1V/µs slew rate (min), A
≥ 1, and 8MHz band-
VCL
width (typ). Complementing these outstanding parameters is
a very low noise specification of 4.3nV/√
6nV/√
Hz (max).
Hz at 1kHz (typ),
Fabricated using the Intersil standard high frequency D.I.
process, these operational amplifiers also offer excellent
input specifications such as 2.5mV (max) offset voltage and
75nA (max) offset current. Complementing these specifications are 100dB (min) open loop gain and 60dB channel
separation (min). Economically, the HA-5102/883 also consumes a very moderate amount of supply power 180mW/
package.
This impressive combination of features make this amplifier
ideally suited for designs ranging from audio amplifiers and
active filters to the most demanding signal conditioning and
instrumentation circuits.
Ordering Information
PART
NUMBER
HA2-5102/883 -55oC to +125oC 8 Pin Can
HA4-5102/883 -55oC to +125oC 20 Lead Ceramic LCC
HA7-5102/883 -55oC to +125oC 8 Lead CerDIP
TEMPERATURE
RANGE PACKAGE
Pinouts
HA-5102/883
(CERDIP)
TOP VIEW
OUT1
1
-IN1
2
1
-
+IN1
V-
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
http://www.intersil.com or 407-727-9207
+
3
4
2
V+
8
OUT2
7
-IN2
6
+
+IN2
5
| Copyright © Intersil Corporation 1999
NC
-IN1
NC
+IN1
NC
HA-5102/883
(CLCC)
TOP VIEW
NC
OUT 1
1
3
2
4
1
5
6
7
8
+-
910111213
V-
NC
3-109
NC
2
NC
+
V+
1920
-
+IN2
NC
NC
18
NC
17
OUT2
16
NC
15
-IN2
14
NC
-IN1
(METAL CAN)
1
OUT1
2
3
+IN1
Spec Number
HA-5102/883
TOP VIEW
V+
8
12
+
--
7
+
5
4
V-
File Number 3709
OUT2
-IN2
6
+IN2
511019-883
Specifications HA-5102/883
Absolute Maximum Ratings Thermal Information
Voltage Between V+ and V- Terminals. . . . . . . . . . . . . . . . . . . . 40V
Differential Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7V
Voltage at Either Input Terminal . . . . . . . . . . . . . . . . . . . . . . V+ to V-
Peak Output Current . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Indefinite
(One Amplifier Shorted to Ground)
Junction Temperature (TJ) . . . . . . . . . . . . . . . . . . . . . . . . . . +175oC
Storage Temperature Range . . . . . . . . . . . . . . . . . -65oC to +150oC
ESD Rating. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . <2000V
Lead Temperature (Soldering 10s). . . . . . . . . . . . . . . . . . . . +300oC
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation
of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
Operating Conditions
Operating Temperature Range. . . . . . . . . . . . . . . . -55oC to +125oC
Operating Supply Voltage. . . . . . . . . . . . . . . . . . . . . . . . . . ±5V to ±15V
TABLE 1. DC ELECTRICAL PERFORMANCE CHARACTERISTICS
Device Tested at: V
PARAMETERS SYMBOL CONDITIONS
Input Offset Voltage V
Input Bias Current +I
Input Offset Current I
Common Mode Range +CMR V+ = +3V, V- = -27V 1 +25oC +12 - V
Large Signal Voltage
Gain
Common Mode
Rejection Ratio
SUPPLY
= ±15V, R
IO
B
SOURCE
= 100Ω, R
LOAD
= 500kΩ, V
VCM = 0V 1 +25oC -2.0 2.0 mV
VCM = 0V,
+RS = 10kΩ,
-RS = 100Ω
-I
B
VCM = 0V,
+RS = 100Ω,
-RS = 10kΩ
IO
VCM = 0V,
+RS = 10kΩ,
-RS = 10kΩ
-CMR V+ = +27V, V- = -3V 1 +25oC - -12 V
+A
VOL
V
= 0V and +10V,
OUT
RL = 2kΩ
-A
VOL
V
= 0V and -10V,
OUT
RL = 2kΩ
+CMRR ∆VCM = +5V,
V+ = +10V, V- = -20V,
V
= -5V
OUT
-CMRR ∆VCM = -5V,
V+ = +20V, V- = -10V,
V
= +5V
OUT
Thermal Resistance θ
JA
CerDIP Package . . . . . . . . . . . . . . . . . . . 115oC/W 28oC/W
Ceramic LCC Package . . . . . . . . . . . . . . 65oC/W 15oC/W
Metal Can Package. . . . . . . . . . . . . . . . . 155oC/W 67oC/W
Package Power Dissipation Limit at +75oC for TJ≤ +175oC
CerDIP Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .870mW
Ceramic LCC Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.54W
Metal Can Package. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 645mW
Package Power Dissipation Derating Factor Above +75oC
CerDIP Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8.7mW/oC
Ceramic LCC Package . . . . . . . . . . . . . . . . . . . . . . . .15.4mW/oC
Metal Can Package. . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.5mW/oC
V
≤ 1/2 (V+ - V-)
INCM
RL≥ 2kΩ
= 0V, Unless Otherwise Specified.
OUT
GROUP A
SUBGROUPS TEMPERATURE
LIMITS
UNITSMIN MAX
2, 3 +125oC, -55oC -2.5 2.5 mV
1 +25oC -200 200 nA
2, 3 +125oC, -55oC -325 325 nA
1 +25oC -200 200 nA
2, 3 +125oC, -55oC -325 325 nA
1 +25oC -75 75 nA
2, 3 +125oC, -55oC -125 125 nA
2, 3 +125oC, -55oC +12 - V
2, 3 +125oC, -55oC - -12 V
4 +25oC 100 - kV/V
5, 6 +125oC, -55oC 100 - kV/V
4 +25oC 100 - kV/V
5, 6 +125oC, -55oC 100 - kV/V
1 +25oC86-dB
2, 3 +125oC, -55oC86 - dB
1 +25oC86-dB
2, 3 +125oC, -55oC86 - dB
θ
JC
3-110
Spec Number 511019-883
Loading...