Intersil Corporation CD54ACT573F3A, CD54AC573F3A Datasheet

CAUTION: These devices are sensitive to electrostatic discharge. Users should follow proper I.C. Handling Procedures.
Copyright

© Harris Corporation 1994

1

SEMICONDUCTOR

CD54AC573/3A

CD54ACT573/3A

Octal Transparent Latch

Three-State, Non-Inverting

Functional Diagram

Q0

Q1

Q2

Q3

Q4

Q5

Q6

Q7

OE

LE

D0

D1

D2

D3

D4

D5

D6

D7

Description

The CD54AC573/3A and CD54ACT573/3A are octal trans­parent three-state latches that utilize the Harris Advanced
CMOS Logic technology. The outputs are transparent to the
inputs when the Latch Enable (

LE) is HIGH. When the Latch

Enable (

LE) goes LOW, the data is latched. The Output

Enable (

OE) controls the three-state outputs. When the Out-

put Enable (

OE) is HIGH, the outputs are in the high-imped­ance state. The latch operation is independent of the state of
the Output Enable.

The CD54AC573/3A and CD54ACT573/3A are supplied in
20 lead dual-in-line ceramic packages (F suffix).

ACT INPUT LOAD TABLE

INPUT UNIT LOAD (NOTE 1)

OE 0.87
Dn 0.5

LE 0.8

NOTE:

1. Unit load is ∆ICC limit specified in DC Electrical Specifications
Table, e.g., 2.4mA Max at +25oC.

June 1997

File Number

3915

Absolute Maximum Ratings

DC Supply Voltage, VCC. . . . . . . . . . . . . . . . . . . . . . . . -0.5V to +6V

DC Input Diode Current, I

IK

For VI < -0.5V or VI > VCC + 0.5V . . . . . . . . . . . . . . . . . . . . . .±20mA

DC Output Diode Current, I

OK

For VO < -0.5V or VO > VCC + 0.5V. . . . . . . . . . . . . . . . . . . . .±50mA

DC Output Source or Sink Current, Per Output Pin, I

O

For VO > -0.5V or VO < VCC + 0.5V. . . . . . . . . . . . . . . . . . . . .±50mA

DC VCC or GND Current, ICC or I

GND

For Up to 4 Outputs Per Device, Add ±25mA For Each

Additional Output . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .±100mA

Power Dissipation Per Package, P

D

TA = -55oC to +100oC (Package F) . . . . . . . . . . . . . . . . . . 500mW

TA = +100oC to +125oC (Package F) . . . . . . . . Derate Linearly at

8mW/oC to 300mW

Operating Temperature Range, T

A

Package Type F. . . . . . . . . . . . . . . . . . . . . . . . . . -55oC to +125oC

Storage Temperature, T

STG

. . . . . . . . . . . . . . . . . .-65oC to +150oC

Lead Temperature (During Soldering)

At Distance 1/16in. ± 1/32in. (1.59mm ± 0.79mm)

From Case For 10s Max . . . . . . . . . . . . . . . . . . . . . . . . . . +265oC

Unit Inserted Into a PC Board (Min Thickness 1/16in., 1.59mm)

With Solder Contacting Lead Tips Only. . . . . . . . . . . . . . . +300oC

CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation
of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied.

Recommended Operating Conditions

Supply Voltage Range, V

CC

Unless Otherwise Specified, All Voltages Referenced to GND
TA = Full Package Temperature Range

CD54AC Types . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.5V to 5.5V

CD54ACT Types . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4.5V to 5.5V

DC Input or Output Voltage, VI, VO. . . . . . . . . . . . . . . . . . 0V to V

CC

Operating Temperature, TA . . . . . . . . . . . . . . . . . . .-55oC to +125oC

Input Rise and Fall Slew Rate, dt/dv

at 1.5V to 3V (AC Types) . . . . . . . . . . . . . . . . . . . 0ns/V to 50ns/V

at 3.6V to 5.5V (AC Types) . . . . . . . . . . . . . . . . . 0ns/V to 20ns/V

at 4.5V to 5.5V (AC Types) . . . . . . . . . . . . . . . . . 0ns/V to 10ns/V

COMING SOON!

COMPLETE DATA SHEET