Intersil Corporation CA358A, CA358, CA258, CA2904, CA158A Datasheet

...

CA158, CA158A, CA258, CA358, CA358A,

CA2904, LM358, LM2904

Data Sheet October 1999

Dual, 1MHz, Operational Ampliﬁers for Commercial Industrial, and Military Applications

The CA158, CA158A, CA258, CA358, CA358A and CA2904 types consist of two independent, high gain, internally frequency compensated operational ampliﬁers which are designed speciﬁcally to operate from a single power supply over a wide range of voltages. They may also be operated from split power supplies. The supply current is basically independent of the supply voltage over the recommended voltage range.

These devicesareparticularly usefulininterface circuitswith digital systems and can be operated from the single common 5VDC power supply. They are also intended for transducer ampliﬁers, DC gain blocks and many other conventional op amp circuits which can beneﬁt from the single power supply capability.

The CA158, CA158A, CA258, CA358, CA358A, and CA2904 types are an equivalent to or a replacement for the industry types 158, 158A, 258, 258A, 358, 358A, and CA2904.

Technical Data on LM Branded types is identical to the corresponding CA Branded types.

Pinouts

CA158 (METAL CAN)

TOP VIEW

INV.

INPUT (A)

NON-INV. INPUT (A)

V-

NON-INV.

INPUT (B)

+ +

INV.

INPUT (B)

OUTPUT (A)

OUTPUT (B)

V+

File Number 1019.6

Features

• Internal Frequency Compensation for Unity Gain

• High DC Voltage Gain . . . . . . . . . . . . . . . . . . 100dB(Typ)

• Wide Bandwidth at Unity Gain . . . . . . . . . . . . .1MHz(Typ)

• Wide Power Supply Range:

- Single Supply . . . . . . . . . . . . . . . . . . . . . . . . .3V to 30V

• Dual Supplies. . . . . . . . . . . . . . . . . . . . . . . ±1.5Vto±15V

• Low Supply Current . . . . . . . . . . . . . . . . . . . .1.5mA(Typ)

• Low Input Bias Current

• Low Input Offset Voltage and Current

• Input Common-Mode Voltage Range Includes Ground

• Differential Input Voltage Range Equal to V+ Range

• Large Output Voltage Swing. . . . . . . . . . . . 0V to V+ -1.5V

Ordering Information

PART

NUMBER

CA0158E -55 to 125 8 Ld PDIP E8.3 CA0158AE -55 to 125 8 Ld PDIP E8.3 CA0158M -55 to 125 8 Ld SOIC M8.15 CA0158T -55 to 125 8 Pin Can T8.C CA0258E -25 to 85 8 Ld PDIP E8.3 CA0258M -25 to 85 8 Ld SOIC M8.15 CA0358E 0 to 70 8 Ld PDIP E8.3 CA0358AE 0 to 70 8 Ld PDIP E8.3 CA0358M 0 to 70 8 Ld SOIC M8.15 CA2904E -40 to 85 8 Ld PDIP E8.3 LM358N 0 to 70 8 Ld PDIP E8.3 LM2904N -40 to 85 8 Ld PDIP E8.3

TEMP.

RANGE (oC) PACKAGE

PKG.

NO.

CA158, CA258, CA358 (PDIP, SOIC)

CA2904, LM358, LM2904 (PDIP)

OUTPUT (A)

INV. INPUT (A)

NON-INV. INPUT (A)

V-

TOP VIEW

1 2 3 4

V+

OUTPUT (B)

INV. INPUT (B)

NON-INV. INPUT (B)

CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.

1-888-INTERSIL or 321-724-7143

CA158, CA158A, CA258, CA258A, CA358, CA358A, CA2904, LM358, LM2904

Absolute Maximum Ratings Thermal Information

Supply Voltage

CA2904, LM2904 . . . . . . . . . . . . . . . . . . . . . . . . . . . 26V or ±13V

Other Types . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32V or ±16V

Differential Input Voltage (All Types) . . . . . . . . . . . . . . . . . . . . . 32V

Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .-0.3V to V+

Input Current (VI < -0.3V, Note 1) . . . . . . . . . . . . . . . . . . . . . . 50mA

Output Short Circuit Duration (V+ ≤ 15V, Note 2) . . . . . .Continuous

Operating Conditions

Temperature Range

CA158, CA158A. . . . . . . . . . . . . . . . . . . . . . . . . . -55oC to 125oC

CA258, . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -25oC to 85oC

CA2904, LM2904 . . . . . . . . . . . . . . . . . . . . . . . . . . -40oC to 85oC

CA358, CA358A, LM358 . . . . . . . . . . . . . . . . . . . . . .0oC to 70oC

CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the device at these or any other conditions above those indicated in the operational sections of this speciﬁcation is not implied.

NOTES:

1. This inputcurrent will onlyexist when thevoltage at anyofthe input leadsis driven negative.This current isdue to thecollectorbase junction ofthe input PNPtransistorsbecoming forward biased andtherebyacting as input diodeclamps.In addition to thisdiode action, there is alsolateral NPN parasitic transistor action on the IC chip. This transistor action can cause the output voltages of the amplifiers to go to the V+ voltage level (or to ground foralarge overdrive) for thetimeduration that an input isdriven negative. This transistor actionis not destructive and normaloutput states will re-establish when the input voltage, which was negative, again returns to a value greater than -0.3V.

2. The maximum output current is approximately 40mAindependentof the magnitude of V+. Continuous short circuits at V+ > 15V can cause excessive power dissipation and eventual destruction. Short circuits from the output to V+ can cause overheating and eventual destruction of the device. Destructive dissipation can result from simultaneous short circuits on both amplifiers.

3. θJA is measured with the component mounted on an evaluation PC board in free air.

Thermal Resistance (Typical, Note 3) θJA(oC/W) θJC(oC/W)

PDIP Package . . . . . . . . . . . . . . . . . . . 130 N/A

SOIC Package . . . . . . . . . . . . . . . . . . . 170 N/A

Can Package . . . . . . . . . . . . . . . . . . . . 155 67

Maximum Junction Temperature (Can Package). . . . . . . . . . .175oC

Maximum Junction Temperature (Plastic Package). . . . . . . . .150oC

Maximum Storage Temperature Range. . . . . . . . . . -65oC to 150oC

Maximum Lead Temperature (Soldering 10s) . . . . . . . . . . . . 300oC

(SOIC - Lead Tips Only)

Electrical Speciﬁcations Values Apply for Each Operational Ampliﬁer. Supply Voltage V+ = 5V, V- = 0V,

Unless Otherwise Speciﬁed

TEMP

PARAMETER TEST CONDITIONS

Input Offset Voltage (Note 6)

Average Input Offset Voltage Drift

Input Common Mode Voltage Range (Note 5)

Common Mode Rejection Ratio

Power Supply Rejection Ratio DC 25 65 100 - 65 100 - dB Input Bias

Current (Note 4)

Input Offset Current

Average Input Offset Current Drift

Large Signal Voltage Gain RL≥ 2kΩ, V+ = 15V (For

Output Voltage Swing RL = 2kΩ 25 0 - V+ -1.5 0 - V+ -1.5 V

RS = 0Ω Full - 7 15 - 7 20 µV/oC

V+ = 30V 25 0 - V+ -1.5 0 - V+ -1.5 V V+ = 30V Full 0 - V+ -2 0 - V+ -2 V DC 25 70 85 - 65 85 - dB

II+ or II- 25 - 20 50 - 45 100 nA II+ or II- Full - 40 100 - 40 200 nA II+ - II-25-210-530nA II+ - II- Full - - 30 - - 75 nA

Large VO Swing)

(oC)

25 - 1 2 - 2 3 mV

Full - - 4 - - 5 mV

Full - 10 200 - 10 300 pA/oC

25 50 100 - 25 100 - kV/V

CA158A CA358A

UNITSMIN TYP MAX MIN TYP MAX

CA158, CA158A, CA258, CA258A, CA358, CA358A, CA2904, LM358, LM2904

Electrical Speciﬁcations Values Apply for Each Operational Ampliﬁer. Supply Voltage V+ = 5V, V- = 0V,

Unless Otherwise Speciﬁed (Continued)

TEMP

PARAMETER TEST CONDITIONS

Output Current

Short Circuit Output Current (Note 2)

Crosstalk f = 1 to 20kHz

Total Supply Current RL = ∞ Full - 0.7 1.2 - 0.7 1.2 mA

NOTES:

4. Due to the PNPinput stage the direction of the input current is out of theIC.No loading change exists on the input lines because the currentis essentially constant, independent of the state of the output.

5. The input signal voltageandthe input common mode voltage should not be allowed to go negative by morethan0.3V. The positive limit of the common mode voltage range is V+ - 1.5V, but either or both inputs can go to +32V without damage.

6. VO = 1.4V, RS = 0Ω with V+ from 5V to 30V, and over the full input common mode voltage range (0V to V+ - 1.5V).

Source VI+ = +1V, VI- = 0V, V+ =

15V

Sink VI+ = 0V, VI- = 1V,

V+ = 15V VI+ = 0V, VI- = 1V,

VO = 200mV RL = 0Ω 25 - 40 60 - 40 60 mA

(Input Referred)

RL = ∞, V+ = 30V Full - 1.5 3 - 1.5 3 mA

(oC)

25 20 40 - 20 40 - mA

25 10 20 - 10 20 - mA

25 12 50 - 12 50 - µA

25 - -120 - - -120 - dB

CA158A CA358A

UNITSMIN TYP MAX MIN TYP MAX

Electrical Speciﬁcations Values Apply for Each Operational Ampliﬁer. Supply Voltage V+ = 5V, V- = 0V,

Unless Otherwise Speciﬁed

TEST

PARAMETER

Input Offset Voltage (Note 9)

Average Input Offset Voltage Drift

Input Common Mode Voltage Range (Note 8)

Common Mode Rejection Ratio

Power Supply Rejection Ratio

Input Bias Current (Note 7)

Input Offset Current

AverageInputOffset Current Drift

Large Signal Voltage Gain

Output Voltage Swing RL = 2kΩ 25 0 - V+ -

CONDITIONS

RS = 0Ω Full - 7 - - 7 - - 7 - µV/oC

V+ = 30V 25 0 - V+ -

V+ = 30V Full 0 - V+ -2 0 - V+ -2 0 - V+ -2 V DC 25 70 85 - 65 70 - 50 70 - dB

DC 25 65 100 - 65 100 - 50 100 - dB

II+ or II- 25 - 45 150 - 45 250 - 45 250 nA II+ or II- Full - 40 300 - 40 500 - 40 500 nA II+ - II- 25- 330- 550-550nA II+ - II- Full - - 100 - - 150 - 45 200 nA

RL≥ 2kΩ, V+ = 15V (For Large VO Swing)

TEMP

(oC)

25 - 2 5 - 2 7 - 2 7 mV

Full - - 7 - - 9 - - 10 mV

Full - 10 - - 10 - - 10 - pA/oC

25 50 100 - 25 100 - - 100 - kV/V

CA158, CA258 CA358, LM358 CA2904, LM2904

0 - V+ -

1.5

0 - V+ -

1.5

0 - V+ -

1.5

0 - V+ -

1.5

UNITSMIN TYP MAX MIN TYP MAX MIN TYP MAX

+ 4 hidden pages

Intersil Corporation CA358A, CA358, CA258, CA2904, CA158A Datasheet

Specifications and Main Features

Frequently Asked Questions

User Manual