Interphase Tech iSpan 4532 PMC, STM-1, OC-3c User Manual
iSPAN® 4532 PMC
ATM over OC-3c/STM-1
Communications Controller
Industry’s fi rst intelligent OC-3/STM-1 card features the Interphase
“gateway-on-a-card” technology for bridging ATM and Ethernet networks.
FEATURES
Motorola MPC8260A
(PowerQUICC IITM) on-board
processor @ 300 MHz
“Gateway-on-a-card”
technology enables interworking
of ATM and Ethernet protocols
for seamlessly bridging
dissimilar networks
Connects directly to SONET/SDH
facilities with no additional
line termination equipment
necessary
Supports up to 64,000
simultaneous Virtual
Connections (VCs)
Single software selectable OC3/STM-1 interface (front or rear
access)
Single Fast Ethernet interface
(front access)
Telecom clock management,
master or slave synchronization
modes
Slave UTOPIA2 bus on P3
connector allows for extending
ATM services to other modules
ATM protocol support for VBR,
CBR, and UBR Quality of Service
classes
Support for ATM AAL0, AAL2,
and AAL5 Adaptation Layers
Support for ATM layer
functionality: UPC (policing)
traffi c shaping, per VC queuing
Modular PMC form factor
suits CompactPCI, VME,
and proprietary platform
architectures
Pre-integrated protocol stacks
available using Interphase lower
layers and various 3rd party
upper layer stacks
iSPAN 4532 PMC ATM over OC-3c/STM-1 Communications Controller
APPLICATIONS
3G Wireless BSCs/RNCs and BTSs/Node Bs Voice over ATM
Broadband Optical Networks Softswitches
Broadband Access SGSNs (Wireless Gateways)
Routers GGSNs
PDSNs
The iSPAN® 4532 PMC ATM Over OC-3/STM-1
Communications Controller is designed for carrier-
class telecommunication networks supporting
the most demanding ATM applications including
broadband Internet access, second and third
generation wireless, ‘converged’ next generation
networks (i.e. softswitch environments), and
integrated voice and data over carrier and
enterprise ATM backbones. Its support for ATM
to Ethernet interworking capability provides
telco system OEMs with a gateway-on-a-card
solution for bridging dissimilar technologies. This
capability allows carriers to cost-effectively migrate
existing communications infrastructure to newer
technologies and enables future-proofi ng of new
equipment deployments.
This ready-to-use, intelligent OC-3/STM-1 ATM line
interface is fully standards-compliant and features
software development tools to facilitate immediate
integration into CompactPCI
telecommunications platforms. In addition, the 4532
allows direct connection to SONET or SDH facilities,
eliminating the need for additional line termination
equipment. Featuring a powerful MPC8260A
on-board RISC processor, high performance
architecture, and advanced ATM functionality, the
4532 is the industry’s best choice for a 155 Mbps
PMC I/O solution in high-availability servers driving
next-generation wireless, convergence, and
broadband access telecom applications.
®
, VME, or custom
03/02/05
interphase.com
1.800.FASTNET
4532 Software
Reduce time-to-market with robust software development tools
Interphase offers a robust suite of software development tools to help shorten the learning curve and design cycle for integration projects based on the 4532 communications controller. Interphase provides three types of development tools, each tailored to the needs of
different intergrations. The Basic Board Support Package (BBSP) allows software developers to write software applications that run
on a specifi c operating system embedded on the MPC8260A CPU. The Board Development Kit (BDK) facilitates development of device
drivers, embedded protocol fi rmware and applications for the 4532 hardware module. The iWARE
developers a set of Interphase-developed fi rmware protocol stacks, accessible via APIs provided by Interphase.
®
Software Development Suite offers
Summary
• Board Development Kit (BDK)
• VxWorks® Basic Board Support Package (BSP)
• VxWorks Software Development Suite (SDS)
Board Development Kit
The 4532 BDK is specifi c to the 4532 hardware, but it is not tied to
a particular operating system environment. The kit contains the
following main components:
• Setup Utility: Allows the user to modify the content of the
various programmable elements of the board, especially the
Flash EEPROM memory.
• Boot Firmware: Provides power-on self test, power-on boot
sequence, built-in self test (described below), confi guration
capability via a command line interface, and boot fi rmware
source fi les as an example of how to program the card.
• Board Installation and Maintenance Manual: Provides
procedures for installing and maintaining the module.
• Hardware Reference Manual: Provides information for
developing embedded software and/or host drivers for the
module.
• Interactive Built-in Self Test Utility and Monitor Manual: Allows
management of the card such as, reset/run action, memory
and register dump, memory and DMA tests, line parameter
manipulation, and more. Manual provides high-level information
for using the boot fi rmware.
Basic Board Support Package
The 4532 Basic Board Support Package (BBSP) consists of
documentation compiled as a Board Support Guide for VxWorks.
This document provides valuable information on how to confi gure
and install VxWorks on the 4532. Once the BSP is installed, the 4532
can be connected to an Ethernet network and development can be
done directly from the particular RTOS development environment,
such as Tornado. The 4532 BSP also includes the fi les required to
make an RTOS run embedded on the 4532 CPU. The standard BSP
is free of charge, but must be ordered separately.
The package provides source fi les for:
• Interrupt controller
• Flash memory management
• True Flash File System (TFFS) support
• TTY driver
• Ethernet driver (broadcast and multicast support)
• Timestamp driver
iSPAN 4532 PMC ATM over OC-3c/STM-1 Communications Controller
• Auxiliary timer support
Also available via the Interphase Professional Services Group:
• Framer device driver framework
• AAL1, 2 and 5 driver framework
• PCI driver framework
iWARE® Software Development Suite
The 4532 iWARE Software Development Suite (SDS) reduces
software development time and facilitates faster time to market by
supplying embedded protocol support for ATM, base drivers for a
selected operating system, confi guration and diagnostic utilities,
and sample programs. The 4532 is offered with an iWARE Software
Development Suite for the following operating systems:
• Linux
• For other operating systems, please call for availability
The iWARE Software Development Suite enables easy integration
with tools and diagnostics to simplify development. The SDS also
provides Interphase’s own lower layer stacks for various network
protocols (contact your Interphase representative for specifi c
protocols). Complete, pre-integrated stacks using Interphase
lower layers and third party upper layers are also available.
The iWARE Software Development Suite consists of software
programs and utilities running on the host CPU and embedded
software (“fi rmware”) which runs on the on-board 8260A
processor. Software elements are separated into four modules:
• The base drivers for each supported Operating System
(executed by the host processor)
• The confi guration and diagnostic utilities
• Sample programs
• The embedded fi rmware executed by the MPC8260A on the 4532
board
These modules interact with each other through well-defi ned and
documented interfaces. A common iWARE WAN API is defi ned
at the interface between the embedded fi rmware and the various
drivers. A complete documentation set is also provided describing
Interphase’s iWARE WAN API (Wide Area Network Application
Programmer’s Interface), the Base Driver’s API, sample programs,
and tool guides.
Custom Development
Custom software development, integration, and consulting services
are also available via the Interphase Professional Services Group.
With over 150 man years of development experienced amassed,
the professional services team offers everything from completely
custom development to merely customizing standard Interphase
products to meet your specifi c needs.
iSPAN 4532 PMC ATM over OC-3c/STM-1 Communications Controller
interphase.com
1.800.FASTNET
Loading...