ITEM
NO.: SH-150
Printed in Vietnam
Descriptio
n
:
ENTRY SHELF
ASSEMBLY INSTRUCTIONS
REVISED AUG 28, 2012
- 1 -
Item No.
: SH-150
ITEM
NO.: SH-150
Printed in Vietnam
PART
LIST
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
- Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
- Remove all wrapping material, including staples & packing straps before you start to assemble.
- DO NOT tighten all screws and bolts until completely assembled.
- Keep all hardware parts out of reach of children.
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO Description Qty Sketch NO Description Qty Sketch
A
Top 1
B
Side
panel
2
C
E
Vertical
panel
(L-R)
Bottom
Crossbar
2
1
D
F
Bottom
panel
Back
panel
1
2
REVISED AUG 28, 2012
- 2 -
ITEM
NO.: SH-150
Printed in Vietnam
HARDWARE LIST
STEP 1
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO Description Qty Sketch NO Description Qty Sketch
1
Bolt
(M6x30mm)
16
2
Lock washer
(ɸ6.5x11mm)
16
3
5
Flat washer
(ɸ6.5x13mm)
Cam lock 2
16
4
Cam bolt
2
6
Screw
(M4x15mm)
8
7
Allen key
(4mm)
8
Plastic Dowel
(40mm)
2
1
9
Screw
(M4x40mm)
2
Attach vertical panels (C) to bottom panel (D) with bolts (1), and washers (2) and (3) as shown below
.Tighten with Allen key (7).
10
Steel band 2
REVISED AUG 28, 2012
- 3 -
ITEM
NO.: SH-150
Printed in Vietnam
STEP 2
STEP 3
Attach side panels (B) and bottom crossbar (E) to bottom panel (D) with bolts (1), washers (2) and (3),
cam bolts (4), and cam locks (5) as shown below. Tighten with Allen key (7).
Attach back panel (F) into groove of the unit. Attach top (A) to the unit with bolts (1) and washers (2)
and (3) as shown below. Tighten with Allen key (7)
REVISED AUG 28, 2012
- 4 -
ITEM
NO.: SH-150
Printed in Vietnam
S
TEP 4
STEP 5
Attach back panel (F) to the unit with screws (6) as shown below. Tighten with a screwdriver.
Attach steel bands (10) to the unit with screws (6). Then attach steel bands (10) to a wall with plastic
dowels (8) and screws (9) as shown below.
REVISED AUG 28, 2012
- 5 -
Loading...