Intermec Technologies WN 5MP01 User Manual

Exhibit J: User Manual

FCC ID: HN2WN-5MP01

Important WN-5MP01 Information!

Place this supplement in your manual.

For Users in the United States and Canada

This device complies with Part 15 of the FCC Rules and with RSS-210 of
Industry Canada. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) This device must
accept any interference received, including interference that can cause
undesired operation.

Federal Communications Commission Compliance

This equipment is intended for operation in a commercial environment,
in compliance with the requirements for a Class A digital device, pursuant
to Part 15 of the FCC Rules, and it must not be used in a residential
environment. It generates, uses, and can radiate radio frequency energy. If
not installed and used in accordance with the instruction manual, it may
cause interference to radio communications. If this equipment causes
interference, the user will be required to correct the interference at the
user’s own expense.

Operation Warning
To comply with the FCC’s RF exposure requirements and minimize
health hazards: The user shall stay at least 20 cm (8 in) away from the
antenna of this device, when the device is in use.
The operation of this device is restricted to indoors only for the 5.150-

5.350 GHz configuration with integral antenna. No such restriction is
placed on the 5.250-5.350 GHz configuration with removable
antennas.
This device will automatically discontinue transmission in case
of either absence of information to transmit or operational failure.

Installation Warning
To comply with the FCC’s RF exposure requirements and minimize
health hazards:
Access points must be installed in such a way that the user will be at
least 20 cm (8 in) away from the antenna, when the device is in use.
The installers should not forget that the burden of maintaining this
distance is on the installer and not the user. The antennas should be
installed in a manner that will comply with this requirement.

Changes or modifications not expressly approved by Intermec could
void the user’s authority to operate this equipment.

Part No. 072869-001