Intermec Technologies RM182-24 User Manual

P/N XXXXXX-001

Important RM182 Information!

Contents

For Users in the United States and Canada....................................................................................2

For Users Outside of the United States or Canada........................................................................4

Français.............................................................................................................................................5

Deutsch...............................................................................................................................................6

Italiano...............................................................................................................................................7

Español .............................................................................................................................................8

RM182 Manual Supplement
For Users in the United States and Canada

Place this supplement in your manual.
This device complies with Part 15 of the FCC Rules and with RSS-210 of

Industry Canada. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that can cause undesired
operation.

Federal Communications Commission Compliance

This equipment is intended for operation in a commercial environment, in
compliance with the requirements for a Class A digital device, pursuant to Part
15 of the FCC Rules, and it must not be used in a residential environment;
however, it has also been tested and found to comply with the more stringent
requirements for a Class B device, pursuant to Part 15 of the FCC Rules. It
generates, uses, and can radiate radio frequency energy. If not installed and
used in accordance with the instruction manual, it may cause interference to
radio communications. If this equipment causes interference, the user will be
required to correct the interference at the user’s own expense.

Note: In order to maintain compliance with FCC Rules, the input/output (I/O) cables
that interconnect between the device and any peripheral must be as specified by
Intermec.

Operators Warning:

To comply with the FCC’s RF exposure requirements and minimize health
hazards:

The user shall not touch the antenna of this device, when the device is in use
in handheld and vehicle mount terminals, where low gain antennas are used.
In some products (Models 2415 and 6400), the antena is inside the product. In
other products the antenna is a small dipole usually attached to the side or to
the top of the product.

With handheld devices, the user shall ensure that the device is at least 20 cm (8
inches) away from their body, when the transceiver is in use.

The user shall stay at least 20 cm (8 inches) away from the antenna of this
device, when the device is in use in access points and other hosts , where
higher gain antennas may be used.

2

RM182 Manual Supplement
For Users in the United States and Canada

Installers Warning:

To comply with the FCC’s RF exposure requirements and minimize health
hazards:

Host devices with higher gain antennas such as access points must be installed
in such a way that the user will be at least 20 cm (8 inches) away from the
antenna, when the device is in use.

The installers should not forget that the burden of maintaining this distance is
on the installer and not the user. The antennas should be installed in a manner
that will comply with this requirement.

Caution

Changes or modifications not expressly approved by Intermec could void the
user’s authority to operate this equipment.

Industry Canada Compliance

This Class B digital apparatus meets all requirements of the Canadian Interference­Causing Equipment Regulations.

This device requires a radio license, unless it is used totally inside a building.
(The user must obtain this license.)

Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le
matériel brouilleur du Canada.

Cet appareil exige une license radio à moins d’être entièrement installé dans un
bâtiment. (L’utilisateur doit obtenir cette license.)

Additional EMI/RFI Compliance

This device meets the Class B limit requirements of CISPR 22.

Agency Approvals

This device is UL Listed and CSA Certified.

3