Intermec PW50, 825-196 Series Instructions Manual

Page 1
PW
The handstrap (P/N 825-196-xxx) provides you with a convenient way to carry your PW50 printer. The handstrap kit contains these items:
Handstrap accessory
These instructions
To attach the handstrap 1 Release the strap from the adjuster, and remove the strap from the VELCRO
pad.
50
Note: VELCRO is a trademark of Velcro Industries B.V.
Handstrap Instructions
2 Insert the strap through the PW50 and VELCRO pad. Make sure the D-ring and
D-ring
Adjuster
Strap
VELCRO pad
Page 2
3 Place the strap on the VELCRO pad, and route the strap through the adjuster
and D-ring as shown.
D-ring
Adjuster
Strap
VELCRO pad
4 Close the VELCRO pad over the strap. You are now ready to use the printer with
the handstrap.
5 (Optional) Install another handstrap on the other side of the PW50.
PW50 Handstrap Instructions
*943-159-001*
P/N 943-159-001
Worldwide Headquarters
6001 36th Avenue West Everett, Washington 98203 U.S.A.
tel 425.348.2600 fax 425.355.9551
www.intermec.com
2008 Intermec Technologies
©
Corporation. All rights reserved.
Loading...