Intermec PB42, PB50, 74789 Supplementary Manual

PB42 and PB50

Handstrap Instructions

The handstrap (P/N 074789) provides a convenient way to carry your PB42
or PB50 printer. With the handstrap attached, you can also attach the
shoulder strap (P/N 074788). The handstrap kit contains these items:

• Handstrap accessory

• This instruction sheet

To attach the handstrap

1 Remove both ends of the handstrap from the strap adjusters that secure

them to the strap.

2 Insert one end of the handstrap through the handstrap clip on the printer.

Make sure the D-rings on the handstrap are facing away from the printer.

Handstrap
clip

Strap adjuster

D-ring

3 Pull the end of the handstrap through the handstrap clip and then insert

the end of the handstrap back through the strap adjuster and pull tight.

4 Repeat step 3 with the other end of the handstrap. You are now ready to

use the printer with the handstrap, or you can attach a shoulder strap to
the D-rings on the handstrap.

Worldwide Headquarters

6001 36th Avenue West
Everett, Washington 98203
U.S.A.

tel [phone]
fax [phone]

www.intermec.com

2007 Intermec Technologies

©

Corporation. All rights reserved.

PB42 and PB50 Handstrap Instructions

*074579-002*

P/N 074579-002