Intermatic PA122 User Manual
PA122 - WATER TEMPERATURE SENSOR KIT
The I-Wave Control System comes equipped
with a Water Temperature Sensor. This
sensor is needed to monitor and maintain
both the pool and spa water temperature
depending on the position of the diverter
valves. It needs to be installed in order for
the thermostat control to work. Power needs
to be disconnected when connecting the
temp sensor. Only an Intermatic Sensor
will work with this controller. Follow the
directions below to install and mount your
water temperature sensor.
Drill a 3/8” hole in the pipe between the
lter pump and lter and install the Water
Temperature Sensor with hose clamp (not
provided). Ensure the O-ring is in place.
Run the wire to the Control Center,
through the low voltage raceway. Connect both wires to the Panel-Mounted Receiver. (See
Figure 1-1.)
1.
2.
Fireman’s Switch Wires
(Brown/Brown)
Water Temp Wires
(Black/White)
Make connection
with connectors
provided
Cable to
P1353ME
Cable to
P4232ME
Wires from
Water Temp Sensor
(Black/White)
(178PE4)
Fireman’s Switch Wires
(Brown/Brown)
Water Temp Wires
(Black/White)
Make connection
with connectors
provided
Cable to
P1353ME
Cable to
P4232ME
Wires from
Water Temp Sensor
(Black/White)
(178PE4)
Figure 1-1Figure 1-1
Setting Pool and Spa Temperatures
If connected and linked, the Hand-Held Remote controls the independent water temperatures of
both the pool and spa.
View the current temperature on the right side of the Hand-Held
Remote Screen under the word SET.
P = current pool water set temperature
S = current spa water set temperature
Press and release the <P/S> button if necessary to change the system
between Pool and Spa mode. Depending on which mode is selected, the word POOL (lower
left) or SPA (lower right) appears on the screen
Press the <UP> or <DOWN> arrow buttons to raise or lower the setting to the desired
temperature. You can hold the button down and the value will automatically change.
Release the arrow button when the setting reaches the temperature you want. After a few
seconds, the display returns to the current temperature of the pool or spa, depending on
which mode you select.
1.
•
•
2.
3.
4.
STAT
OK
POOL
72
ºF SET
P 72
S 85
STAT
OK
POOL
72
ºF SET
P 72
S 85
Copyright © 2006 Intermatic, Inc.
ATTENTION:
If the Intermatic panel in which you are installing this Water Temperature Sensor Kit is not
equipped with a low voltage compartment raceway, then you will need to order and install the
Intermatic Class 2 Wiring Isolation Kit. The part number to order this is 156PA12976A. NEC,
UL & CSA require a double barrier of insulation between high and low voltage wiring when
both are present in the same compartment. The Class 2 Wiring Isolation Kit satises that
requirement. If you have the newest Intermatic Control panel with the low voltage raceway,
then it is not necessary for you to install the Class 2 Wiring Isolation Kit. Please follow the
below instructions carefully and, as with all accessory kits, remember to remove power before
you begin installation.
158PE13068.indd 1 11/2/06 12:23:29 PM
LIMITED 1 YEAR WARRANTY
If within one (1) year from the date of purchase, this product fails due to a defect in material or workmanship, Intermatic
Incorporated will repair or replace it, at its sole option, free of charge. This warranty is extended to the original household
purchaser only and is not transferable. This warranty does not apply to: (a) damage to units caused by accident, dropping
or abuse in handling, acts of God or any negligent use; (b) units which have been subject to unauthorized repair, opened,
taken apart or otherwise modified; (c) units not used in accordance with instructions; (d) damages exceeding the cost of
the product; (e) sealed lamps and/or lamp bulbs, LED’s and batteries; (f) the finish on any portion of the product, such as
surface and/or weathering, as this is considered normal wear and tear; (g) transit damage, initial installation costs, removal
costs, or reinstallation costs.
INTERMATIC INCORPORATED WILL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. SOME
STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES,
SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. THIS WARRANTY IS IN LIEU OF ALL
OTHER EXPRESS OR IMPLIED WARRANTIES. ALL IMPLIED WARRANTIES, INCLUDING THE WARRANTY OF
MERCHANTABILITY AND THE WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, ARE HEREBY MODIFIED
TO EXIST ONLY AS CONTAINED IN THIS LIMITED WARRANTY, AND SHALL BE OF THE SAME DURATION AS THE
WARRANTY PERIOD STATED ABOVE. SOME STATES DO NOT ALLOW LIMITATIONS ON THE DURATION OF AN
IMPLIED WARRANTY, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU.
This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased, or
(b) mailing the product, along with proof of purchase, postage prepaid to the authorized service center listed below. This
warranty is made by: Intermatic Incorporated/After Sales Service/7777 Winn Rd., Spring Grove, Illinois 60081-9698/815675-7000 http://www.intermatic.com Please be sure to wrap the product securely to avoid shipping damage.
INTERMATIC INCORPORATED
SPRING GROVE, ILLINOIS 60081-9698
http:\\www.intermatic.com
158PE13068
158PE13068.indd 2 11/2/06 12:23:29 PM
Loading...